Question about 1997 Buick LeSabre

1 Answer

Fuel not getting to engine - 1997 Buick LeSabre

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 14,337 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine flooding


Check the fuel pressure. The pressure regulator may have gone bad and is delivering too much pressure to the fuel rail, thereby flooding the engine.

Dec 07, 2013 | Cars & Trucks

1 Answer

Not getting fuel to the engine on my 2001 chevy blazer


you must be getting fuel, remove fuel line @ engine, have someone crank the engine, then you'll know, NO SMOKING ! if no fuel, check fuel pump relay ! check all fuses . pump should hum for only 2 seconds, when key is turned to ON position. to prime the system. always check all ground wires to fuel system. important ! good luck

Mar 06, 2013 | 2001 Chevrolet Blazer

1 Answer

1982 gmc pickup I replaced the mechanical fuel pump and still am not getting fuel up to the carb and it will not start


You most likely have an air lock in the fuel line or fuel pump.
To start the engine and hopefully get the fuel to the carby, pour a little fuel down the carby and then start the engine. You may need to do this several times until you get the engine running.

Apr 08, 2012 | 1983 GMC C1500

1 Answer

My 1997 GMC Sierra 5.0 Litter wont start and i changed the fuel pump regulator, what might be the problem?


engines need 3 things to start (petrol engine)
fuel, air and a spark,
as you have been working on your fuel system it is best to suspect this system first,
on engine turn over see if you can smell fuel at the exhaust.
if you smell fuel the fuel regulation mybe too high and the engine is flooding.
if you do not smell fuel, remove fuel line from engine and ensure fuel is getting to the engine,
(be careful not to let fuel spill this generates a fire risk)..
once fuel is getting to the engine, check your ignition system to ensure you have a good spark to ignite the fuel.
finally check your air filter is not blocked and that you have air getting to the engine.

I hope this was helpful.

Jan 11, 2011 | 1997 GMC Sierra

1 Answer

Replaced the fuel pump in 1988 ford f250 and the engine still seems to not be getting fuel


follow fuel lines from gas tank to engine are any lines crushed. next replace fuel filter. check to be sure fuel filter is installed in right direction. arrow on fuel filter should point toward engine. double check that fuel lines are connected properly, some fuel pumps have three fuel lines one for pressure , one for return and one vent line.last possible bad fuel pump from factory

Jun 13, 2010 | 1988 Ford F 250

1 Answer

Engine not getting fuel


First, confirm that the fuel filter is clean. Next determine that the electric fuel pump (usually located in the fuel tank) is operating. You can do this when you check your fuel filter. With the filter out, turn on the ignition (DO NOT CRANK THE ENGINE). The fuel pump should run and fuel should flow out of the fuel filter holder .... or the fuel line if it is an inline filter. Be extremely careful and have somebody help with this test because you could be pumping raw gasoline into the engine compartment and on the ground. If the filter is clean and you are getting fuel out of the fuel line then the problem could be an engine computer or the fuel injection system.

Nov 27, 2009 | 2001 Kia Sportage

1 Answer

2005 chrysler 300 where is the fuel filter? will start and stall out about 3 times then nothig, no starter, nothing?


If the engine isn't turning over then it is not the fuel filter. If the engine is turning over when you turn the key it is possible it's the fuel filter but most likely the Fuel pump unless you got some poor fuel or water in your fuel. This is a fuel injected engine. Look at the engine and find one of the fuel injector rails. On one end there should be a black dust cover cap. Remove that cap and you will see what looks like a Tire air valve. Put a rag under and around this to keep fuel from spraying out all over and press on the center release valve after you have turned the ignition key to on but not started the engine. If fuel comes out try the other rail. If you have fuel at both then the engine is getting fuel and the problem is most likely NOT the fuel filter but may still be related to your fuel pump. Chrysler uses submerged fuel pumps in these vehicles. That is the fuel pump is located in the gas tank. If you suspect the Fuel pump is faulty, and this does happen, you should really have a trained mechanic do the work. They have the tools to do the job quickly and without getting fuel all over. If the fuel pump, which is electronic, does not maintain proper fuel pressure it will cause the symptoms you have described.

Sep 07, 2009 | 2005 Chrysler 300

3 Answers

Deisal out of gas wont start


The fuel system has a bleeder located on the engine, located near the passenger side front of the engine. Open the bleeder, turn the engine over until you can see fuel come out on the ground near the front of the engine. Close the bleeder, attempt to restart the engine. It may take a couple of tries, but it should start after five or six attempts. Do not run the starter for more than twenty seconds per attempt, with at least one minute between attempts.

Nov 12, 2008 | 1987 Ford F 250

Not finding what you are looking for?
1997 Buick LeSabre Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...