Question about Buick Cars & Trucks
How do you know it is the cluster, I think not. I think it is the gas tank fuel level sending unit that is the problem here.
Posted on Nov 06, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Our 2002 did the same thing. Easy cheap fix! Pull the wheel off and check the wiring that goes to the wheel sensor. You will find after removing a few inches of wrap, a broken wire or two. This could be on either wheel, so check both. Fix the wires back up and you are good to go. Hope this helps!
Posted on Aug 01, 2008
I cannot find the 2004, but you can buy it from the dealer. You can download the 2003 and 2005 from this link. http://www.extendedgmwarranty.com/owners-manual/buick_owner_manuals.html
Posted on May 22, 2009
the BCM needs to be programmed to operate the computer. a GM techII is now required to calibrate BCM to airbag, stereo, keyless entry, and control pcm data. This is required to make it all work. a gm service should have it done within an hour or less just call and ask them how much it would be to program new BCM. it might cost @$75 to $125 but it is needed, to allow the BCM to work properly.
Posted on Sep 11, 2009
Testimonial: "ok...i bought the bcm on line (used)...but the gays in the dealer says i have to buy a new one..because the used cannot be to reflashed...or recoded."
Your Fuel sender unit is defective , Bad news is it's in the Fuel tank and it's also part of the fuel pump module assembly which may cost a lot of $$ to fix.
Posted on Mar 17, 2010
Hi there, below are the removal/installation instructions for your thermostat.
Removing the housing bolt..
The removal and installation of the thermostat...
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Hope it helps
Posted on Jan 12, 2011
Testimonial: "What a fast and splendid response/solution.........."
Tips for a great answer:
Apr 04, 2017 | 2004 Buick Rendezvous
May 24, 2015 | 2004 Buick Rendezvous
Dec 01, 2014 | Buick Cars & Trucks
Mar 14, 2013 | 2004 Buick Rendezvous
Jun 28, 2012 | 2004 Buick Rendezvous
Aug 11, 2010 | 2002 Buick Rendezvous
Sep 30, 2009 | 2004 Buick Rendezvous
Sep 07, 2009 | 2004 Buick Rendezvous
May 08, 2009 | 2004 Buick Rendezvous
Feb 14, 2009 | 2004 Buick Rendezvous
98 people viewed this question
Usually answered in minutes!