Question about 2008 Chevrolet Malibu Hybrid

1 Answer

Where is the water pump on 2008 Chevrolet Malibu Hybrid

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Chevrolet Master
  • 75,822 Answers

It is on the front of the engine, that is on the passengers side.

Posted on Nov 06, 2012

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 6826 Answers

SOURCE: 2008 chevrolet malibu brake problem

Check for clearance between the rotor and the caliper,and caliper to the rim.Make sure one ,or more of the brake pads where not accidently put on backwards,with the metal on the rotor,it happens sometimes.

Posted on Mar 07, 2010

Testimonial: "turned pout to be warped rotors purchased from re so firestone says. replaced rotors. thank you"

  • 4472 Answers

SOURCE: Changing Thermostat 2008 Chevrolet Malibu

NOTE: When adding coolant, it is important that you use GM Goodwrench DEX-COOL® (orange colored, silicate free) coolant meeting GM specifications. On these vehicles, if silicated coolant is added to the system, premature engine, heater core or radiator corrosion may result. In addition, the engine coolant will require change sooner; at 30,000 miles (48,000km) or 24 months.

Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.

2.4L Engine
Disconnect the negative battery cable.
Properly drain and recover the coolant to a level below the thermostat.
Unfasten the cover-to-outlet pipe bolt, which is accessible through the exhaust manifold runners.
Raise and safely support the vehicle.
Disconnect the radiator and heater hoses from the outlet pipe.
Unfasten the outlet pipe-to-oil pan bolt and the cover-to-outlet pipe bolts.
Remove the thermostat, then clean the old gasket material from the mating surfaces.

Posted on Nov 01, 2010

  • 1975 Answers

SOURCE: How do I change right

Here's the information I found. This should be in your owners manual if you have one. If you don't and would like a copy, you can email me at with your make, model and year and I will be happy to email you a copy. Don't worry no cost to you. I hope this helps and good luck.

clifford224_679.gif clifford224_680.gif

Posted on Jun 02, 2011

SOURCE: 2008 chevrolet malibu check engine light on and car is running fine. What should I do?

Auto Zone will run a free diagnostic check. Just go in and ask.

Posted on Dec 03, 2011

  • 75822 Answers

SOURCE: where is the water pump located on 2008 chevy malibu

It is on the front of the engine, that is the passengers side.

Posted on Nov 01, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Installation of a harmonic balancer in 2009 malibu hybrid

it just bolts on the crankshaft , go on youtube this should be there

Mar 19, 2015 | 2009 Chevrolet Malibu Hybrid

1 Answer

Where is the water pump located on 2008 chevy malibu

It is on the front of the engine, that is the passengers side.

Nov 01, 2012 | Chevrolet Cars & Trucks

2 Answers

2008 chevrolet malibu water leaking in passenger back floorboard

2008 chevy malibu due to the way the a/c drains and the construction of the floor pan water funnels into the car. this would have been a cheap fix if the factory would have seam sealed the floor pans properly. good luck tick @ premium auto care pell city al.

Jun 23, 2012 | 2008 Chevrolet Malibu

1 Answer

2003 chevy malibu gas gauge always on empty, replaced the fuel pump

Need to replace the sensor inside the gas tank. I have a 2008 Malibu with the same problem. It was a faulty fuel gauge sensor.

Jan 31, 2012 | 2003 Chevrolet Malibu

1 Answer

Where is the a/c drain tube in a 2008 Chevy Malibu? Getting puddles of water only in the back passenger floorboard.

This is a common problem with the 2008 malibu,the problem you are facing is as a result of the fact that the water actually goes out of the vehicle through the drain pipe, and then comes back in from the outside of the pipe,which is due to the turbulence of the air under the hood which actually pushes the water back along the outside of the tube, through the seal and back into the passenger side.

The solution is to apply a seam sealer to surround the outer part of the drain pipe.

Thank you for using fixya..

Jul 10, 2011 | 2008 Chevrolet Malibu

1 Answer

How hard is it to replace water pump on the 2000 malibu

not that hard!
loose the water pump pulley bolts with the belt still on
remove the belt
remove the pulley
remove the bolts on water pump
remove the water pump

Mar 05, 2010 | 2000 Chevrolet Malibu

1 Answer

How do I replace the water pump on a 2002 Malibu?

how to replace a water pump on a 2000 chevrolet malibu-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Jul 12, 2009 | 2002 Chevrolet Malibu

1 Answer

Need to install lighting harness to tow my 2008 Malibu with RV

The tail lamps will have to be removed first of all. You will need a test light to check all wires to see which one is for what usage. Have a friend to operate the switches inside while you test each wire and mark the wires with tape for what they are used for. Signal lamps must be marked for which side. Brake lights make no difference as so for back up lamps. The directions are incorporated with the 4 way flashers

May 23, 2009 | 2008 Chevrolet Malibu Hybrid

Not finding what you are looking for?
2008 Chevrolet Malibu Hybrid Logo

Related Topics:

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides