Question about 2006 Chevrolet Corvette

1 Answer

89 cadillac cornering light does not come on with turnsignal bulb is good

Left sideworks not passenger side

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 75,005 Answers

More than likely the turn signal switch is defective as the circuit runs through it. have a shop confirm this as the part is expensive.

Posted on Nov 06, 2012

Testimonial: "thank you"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: instruction to replace left rear turnsignal bulb 2004 cavalier

Open trunk,
remove the felt cover in your trunk near the
light socket, twist and turn the socket,
pull it out, remove bulb assembly , replace with a new one bulb reinstall ... close trunk.

Posted on Mar 15, 2009

emissionwiz
  • 75005 Answers

SOURCE: turnsignal

the system uses an electronic flasher, they often cause this intermittent loss of turn signals, replace it.

Posted on Apr 06, 2009

carfreak1217
  • 109 Answers

SOURCE: 2003 Trailblazer has no lower brake lights or

If you have no third brake light it most likely the brake light switch.

Posted on Jun 23, 2009

c17hydro
  • 2984 Answers

SOURCE: How do I get to the drivers side marker light bulb

  1. Remove the inner wheel well splash shield.
  2. Grasp the bulb socket and rotate it counter-clockwise to remove it from the lamp.
  3. Remove the bulb from the socket.
  4. Installation is the reverse of removal.
b2159df.gif
Remove the retaining bolts for the splash shield and ...

aa616ff.gif
... remove the splash shield from the vehicle

470117c.gif
Twist the bulb socket to remove it from the lamp and ...

61c885a.gif
... lower the socket down to access the bulb

fd06434.gif
Pull the bulb straight out to remove it from the socket

Posted on Oct 10, 2009

Testimonial: "Wow, great pictures! Just what I needed. What book did they come from?"

  • 18 Answers

SOURCE: Need to replace tail light bulb passenger side on

Here is some great CAR solution by Some FIXYA EXPERT.
Get any kinds of CAR solution from bellow.

18

Posted on Dec 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the turnsignal flasher located and how do you get to it


Turn Signal/Hazard Flasher Module
Left front of the passenger compartment, behind the left hand knee bolster

Jan 31, 2016 | 2004 Cadillac Deville

1 Answer

1987 ford ranger turn signals keep blowing fuses. have changed flasher fuse and switch on column. just keeps blowing?


first thing i guess to understand what is going on here ,is a little back to basics on how turnsignals work , first item you have is power fuse then it's off to flasher module than it goes to the turnsignal switch on colum ,of course anywhere on it way to there the power could got to ground and cause the fuse to trip, now the power depending on Left or right selection , is directed to lights on both front and back of truck,thankfully rangers don't have em on the side) now any place in this pathway the wire could go to ground and blow the fuse, now to troubleshoot and narrow down the area that fault is located , (1) replace fuse with correct size and ck for proper fit in fusebox and start and operate truck for a few minutes DO not use turnsignals, ck fuse is it still good if so go to step 2 if not stop and ck wire conditions in steering colum and switch(2) start truck and try right hand turn signal only verify lights working ,Ok yes/no if not replace fuse and try left side same way, Ok yes /no if right or left side only blows fuses take ALL bulbS OUT of lights and try again , if fuse still blows then look for wire fault on that side of truck if fuse is still good then look carefull at light bulb sockets for rust and powered corrosion (ill bet an 87 has some ) you may need to replace bulb sockets , they do sell em in autoparts stores .

Jun 30, 2014 | 1987 Ford Ranger

1 Answer

My dash lights want come on and my left brack light want come on and my right blinker want come on.


1st off the right blinker,does it blink fast or not at all if it blinks fast, check the bulbs if it is not blinking and the dash light also don't work the multifunction switch could be bad(turnsignal,light switch) if your other break light is working start by checking the bulbs take the verified good one and try it in the other side if the bulbs are good check the fuses under dash and under hood carefully

Nov 30, 2010 | 1991 Honda Civic

1 Answer

O replace passenger side rear turn signal bulb on 2004 Cadillac


open trunk, remove the plastic panel around the latch plate, remove the plastic mounting bolts that hold the grey trunk liners in place, there are two 10mm nuts that hold in the light remove nuts pull out light twist the bulb retainer out and replace bulb.

Jul 12, 2010 | 2004 Cadillac CTS

1 Answer

Left side turn signal's do not function on my 2005 chevy malibu bulbs are new can not find a fuse for the turnsignals


If only left sides are not working there may be another bulb bad some vehicles incorporate sidemarkers as turn signal as well.Would check right side first and see what lights are flashing for sure and compare to left side.If not a bulb would double check the sockets and wiring itself.It is not uncommon for a socket to go bad.

Jul 06, 2010 | 2005 Chevrolet Malibu

1 Answer

Bought new headlights for my 2001 lexus gs300 but the right light won't turn on. what do i need to do to get it working again?


Take the right one and put it in the left side and see if that light works over there. If it does then you probably need to clean some contact terminals on the right side. If the headlight does not work on theleft side you go a defective bulb. It;s rarebut it does happen. You can also put the left sidebulb in the right side and seeif the right sideworks then. If so you just didn't have a good enough contact while installing the first time.

Apr 15, 2010 | 2001 Lexus Gs 300

1 Answer

1999 cadillac turn signals stopped working


Check the hazard switch brother. Thats a know source for this problem. Mess around a bit with it for a temporary fix but replace it at any rate!

Aug 16, 2009 | 1996 Cadillac DeVille

1 Answer

Turn signal and brake light


check the plug in the trunk lid mine did that and the plug was completely disconnected, yours may just be loose, or have a broken wire

Oct 03, 2008 | 2000 Ford Crown Victoria

1 Answer

1998 cadillac deville passenger side tail lights


generally the problem is either a bad bulb socket blown fuse or a bad ground. check to see if you have no loose or stray wires.

Aug 28, 2008 | 1998 Cadillac DeVille

Not finding what you are looking for?
2006 Chevrolet Corvette Logo

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...