Question about 1999 GMC Jimmy
Check for a possible short; [open wires touching each other] when driving things move around, when standing still everythings stays still, could also be a porrly connected wiring harness
Posted on Nov 07, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I dont know how much help this will be, but I'll offer it and let you be the judge.
Ive had this issue before in a different GM vehicle, a Pontiac Grand Prix. The issue turned out to be that the voltage from the battery was low due to corroded terminals. Once that was cleaned up and the voltage restored to normal, the key came out. Come to find out that this was a common issue in that vehicle, voltage goes low, you cant remove the key.
Now, on my vehicle and since yours is a GM product as well I will assume it will hold true for your vehicle too, there is a small hole on the bottom side of the column right in the area of where the ignition key cylinder is. If you have this, you can take a small tool like an allen wrench and push it up in there and that will press on a release mechanism that should allow you to turn the key back to its release position and pull the key out.
Hope this helps.
Posted on Dec 31, 2008
Hi... to adjust rear brakes providing the shoes are good... just drive vehicle in reverse and pump brakes... rear shoes are self adjusting so they should "adjust" themselves... after doing this test by putting on park brake, put vehicle in drive and see if vehicle moves forward, repeat procedure if necessary. Hope this helps... please rate suggestion.... ty
Posted on May 21, 2009
Yeah if you have to tap on it, then that means the brushes in the motor are worn out and you need to replace it. The blower motor is behind the PCM and Coolant Overflow bottle. If you remove these then it will give you better access to motor. You'll have to cut around housing. There should be a groove already there for you, just make sure you don't cut all the way around it. Once you open it and get the new one installed, you'll have to use caulk to seal where you cut it at.
Posted on Dec 20, 2009
Tips for a great answer:
Mar 21, 2013 | 1999 GMC Jimmy
Sep 11, 2011 | 1987 GMC Jimmy
Feb 08, 2011 | 1999 GMC Jimmy
Jul 12, 2010 | 2000 GMC Jimmy
May 19, 2010 | 1999 GMC Jimmy
Mar 23, 2009 | 1999 GMC Jimmy
Sep 05, 2008 | GMC Jimmy Cars & Trucks
66 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: