Question about 1994 Chevrolet Astro
See if you have spark if yes see if your getting fuel then post another question
Posted on Nov 05, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: have a 1994 chevy s10
You need to check and make sure you have fuel pressure, then check for spark at ignition, if those check out then check for pulse width at the injectors. That basically is the electrical signal which tells injectors to spray fuel. Use what is called a Noid light on injector pulse width check. that will eliminate all possibilities other than internal issues with engine. I.E. broken cam, broken timing components, obviously if all I mentioned checks out then run compression test. Good Luck
Posted on Jul 15, 2008
Does it crank? Do you have any codes? Check engine light? Do you have spark? No spark check coil, and connections, also it would be nice to know what year it is. Get codes read. No crank check battery and starter. No codes or lights check crank position sensor, make sure your pcm is good after replacing your ignition mod you could have blown it if you did do it right. (engine computer) Check cam sensor if applies. Crank and cam could prevent it from starting and I know one I think cam controls pcm's fuel delivery on gm's
Posted on Dec 30, 2008
Your problem is a leak in the cpi pletium most likely the pressure line has a leak
had same problem with mine $45.00 PRESSURE LINE KIT AND $15.00 GASKET FOR PLETIUM and 2 hours labor problem sovled.
You can remove vortec cover and remove air regulator to look inside pletium. I had gas vapor on driver side . that is where fuel lines are. fuel regulator is on passenger side. turn key on and look in hole and see where fuel is spraying. taking pletium off you can again turn key on and make sure where fuel is coming from.
Posted on Feb 06, 2009
Check to see if the fuel pump is kicking in,
when you turn the key on without starting the van you should hear it kick on for about 2 seconds,
It could be...
A clogged fuel filter...
Blown fuse for the pump..or bad pump relay..
Bad fuel pump
Posted on Mar 07, 2009
try bypassing the oil pressure switch on the back of the block behind the distributor, if there oil pressure switch goes bad it will do this. had one that drove me nuts trying to fix it then figured out I had to buy a book and low and behold thee it was 3 wire oil pressure switch you can't see between the engine and fire wall just behind the distributor and costs 8 bucks to buy new.
Posted on Jan 16, 2010
Tips for a great answer:
May 19, 2011 | 2001 Chevrolet Camaro
Oct 01, 2010 | 1994 Chevrolet Astro
Sep 29, 2009 | 1992 Chevrolet C1500
Jun 27, 2009 | 1998 Chevrolet Astro
Jun 18, 2009 | 1986 Chevrolet Astro Cargo
Mar 07, 2009 | 2000 Chevrolet Astro
Oct 22, 2008 | 1994 Chevrolet Astro
192 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: