Question about Cars & Trucks

1 Answer

Have 2003 Saturn ion put new motor from a2006 Saturn ion in and when it gets warm wont accelerate and goes into. Limp mode runs rough

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

It is over heating .did you change the timing belt and water before you put in the motor? did you loook it all very well.before I put a motor in a customers car I replace the timing belt and water pump ,and look it over very close

Posted on Nov 06, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: 98 Catera goes into "Limp Mode" after warm up.

have you check you ignition coil packs.

Posted on Jul 21, 2009

  • 5 Answers

SOURCE: saturn ion blower motor

lower settings as far as speeds for your blower motor go through a resister block to reduce the voltage your blower motor receives to make it turn slower. If it turns slow on high you would have to check the voltage at the blower motor, should be the same voltage that would be at the battery. There could also be material in the blower motor fan like things a mouse could have put there. Causes the fan to spin slower and also blocks the fins from pushing air. Any strange noises would be heard unless you have had the prob since you owned it and could not detect any changes. It could be even full of stuff and still
be in balance. but it could be a few other things.

Posted on Dec 23, 2008

  • 1596 Answers

SOURCE: where is 2003 saturn ion thermostat?

FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You

  1. Drain the cooling system.
  2. Remove the bolts that secure the thermostat housing to the water pump feed pipe.
Remove the feed pipe
  1. Remove the thermostat and retaining sleeve, noting the orientation for installation.
Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.

  1. Install the feed pipe that connects the thermostat housing to the water pump.Notice: Refer to Fastener Notice in Service Precautions.

    1. Install the bolt that secures the water pump feed pipe.
      • Tighten the bolt to 10 Nm (18 inch lbs.) .
    1. Fill the cooling system.

Posted on Feb 09, 2009

  • 636 Answers

SOURCE: Rough Idle/Runs Rough and low power

I would take it in and have them do a diagnostic on it, sounds like the cam shaft sensor to me.

Posted on Sep 19, 2009

  • 139 Answers

SOURCE: 2001 Saturn Sl2 wont run after warmed up

SOUNDS LIKE YOUR CATALYTIC CONVERTER IS DYING

Posted on Dec 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Saturn Ion running loud and rough


Check for other loose heat shields.
The shield you removed would allow more noise to enter the cabin too.

Mar 15, 2014 | 2003 Saturn ION

2 Answers

When I accelerate hard to pass my check engine light comes on and the vehicle goes into limp home mode.


Get the vehicle looked at by a garage. The reason it goes into limp home mode is to protect the engine from further damage. The reason the check engine light comes on is because the engine needs checking with some urgency.

Nov 18, 2012 | 2007 SsangYong Actyon 4x4

1 Answer

Xr6 going into limp home mode when car is turned


theres a solenoid that selects gears it can trick the gearbox into limp mode, id have that checked before spending big money i spent 6000 on a new gearbox (not standard price i had a heavily modified gearbox) because the standard gearbox did the same turns out it was an $80 solenoid, i found out after forking out the money. any ford dealer should be able to plug it in and run diagnostic checks for you

Jan 20, 2010 | 2005 Ford Futura

1 Answer

How do you replace lights behind the speedometer? 2003 Saturn Ion


Take it to a dealer, pay them $141, wait 1.5 hours and take it home with the dash lights fixed. Or put up with it until your wiper motor fails, and get them both done at the same time.

Sep 30, 2009 | 2003 Saturn ION

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...