Question about Cars & Trucks
Just put new clutch in disco 300 tdi plus thrust bearing and arm plus slave and master cylinders can get third fourth and fifth gears wont select 1st 2nd or reverse
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I'm a Land Rover owner myself - old school Series models.
This sounds like major gearbox trouble.
As the selector shafts are different for gears #2 and #4, I may be inclined to think there is an external problem around the base of the gearlever.
Probably cheaper to have a look here first.
If you've been offroading, it's possible you've managed to get a stone in there.
With the covers off the transmission, if there is no fault externally that you can see, then the gearbox may have to be stripped to find the obstruction.
You can always join one of the Landrover forums to assist on this and other matters.
Hope this helps you. If it does, please rate as Fixya! Thanks.
Posted on Jun 16, 2008
Pilot bearing (pressed into flywheel) or release bearing (presses against clutch pressure plate)?
Regardless, the repair is the same. Replace clutch disc, pressure plate, release bearing & pilot bearing. Most flywheels are available or as part of a complete kit, minimum is to inspect & resurface flywheel when replacing clutch assymbly.
Posted on Feb 17, 2009
Car is in limp in mode unless you have the tools to work on automatic transmission you will need to take it to a transmission shop. Of course you can check oil level but I suspect you have other issues.
Posted on Mar 26, 2010
SOURCE: I own a peugeot 307
I own a Peugeot 307 SW 1,6 hdi 2004 which I bought a month and a half ago. It all started with an increasing rattle and sometimes "singing" noise from what i presumed was the gearbox (it`s a manual) and perhaps a bearing problem. At the same time (a week after i bought it) I noticed a small oil leak from beneath the car. After a short examination at the dealer`s we found that there actually was a leak from the gearbox. I got it sorted out and refilled as much as 1,8 l of gear oil (which had leaked out). After that the car works fine, except from a tiny rattle/ singing from the gearbox, especially in combination with gear shifting. I am now concerned that the whole gearbox is going to break down. In case it does, I hope it will happen before 22nd of February (my warranty runs out by then). Glad to hear if you find a solution to your problem, it may have some similarities to mine. PS I`m from Norway, but this or similar problems are not being discussed on Norwegian websites or forums. DS
Posted on Jan 05, 2011
Tips for a great answer:
Nov 11, 2016 | Cars & Trucks
Mar 06, 2011 | Land Rover Range Rover Cars & Trucks
Jan 18, 2011 | 1997 Land Rover Discovery
Apr 16, 2010 | 2004 Land Rover Discovery
Feb 13, 2010 | 2002 Land Rover Freelander
Sep 01, 2009 | 1999 Land Rover Discovery
Sep 01, 2009 | 2002 Land Rover Freelander
Jun 07, 2009 | 1998 Land Rover Discovery
Jan 02, 2009 | Land Rover Discovery Cars & Trucks
Oct 20, 2008 | 1996 Land Rover Discovery
127 people viewed this question
Usually answered in minutes!