Question about 2005 Volkswagen New Beetle

2 Answers

Head lamp fuse

What is the fuse number for the right head lamp, low beam? Where is the fuse box located?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Volkswagen Master
  • 76,164 Answers

Follow the link above it is correct.

Posted on Nov 05, 2012

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 14,363 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 261 Answers

SOURCE: low beam on right side not functional

just the head light bulb, it has too filament one for high and one for low the low beam filament is burnd out so replace the bulb

Posted on Nov 24, 2008

youredone82
  • 426 Answers

SOURCE: left head light on low beam does not come on

check the headlight fuse.has one for low and one for high beams

Posted on Sep 29, 2009

johnjohn2
  • 5763 Answers

SOURCE: All head lights failed. Display reads: left front

they could fail in pairs, check bulbs ,remove and install new ones also check fuses after installing new bulbs if they dont work because they sometimes pop the fuse when they blow out , also theres a left and right lamp fuse so check both fuses , but only if lamps dont work after you install them. hope this helps, good luck.

Posted on Oct 25, 2009

  • 1 Answer

SOURCE: How many bulbs in the 02 passat front?

This is a driving light bulb

Posted on Nov 20, 2009

airjer995
  • 5332 Answers

SOURCE: is the head light in a 2004 passat a bulb with two filaments (low and high beams in the same bulb)?

If it has a normal headlight system than yes the high and low beam are the same bulb the part number will be 1255/H7 If you have HID headlights than you will have a seperate high and low beam bulb. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Posted on Feb 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the headlamp relay on a 2007 saturn ion


Are both low beams an high beams not working ? What engine does your car have ? Low beam relay only on 2.2 L .
On vehicles with manual headlamps, the LH HDLP and RH HDLP fuse in the fuse block - under hood, supply battery positive voltage to both low beam lamps and high beam lamps at all times. The low beam and high beam circuits continue through the fuse block - under hood, through the body control module (BCM), and to the headlamp switch. The low beam or high beam circuit then, depending on the position of the dimmer switch, continues through the headlamp switch. When the headlamp switch is placed in the ON position, it provides a ground path for the low beam or high beam lamps through G203. The low beam and high beam circuits are monitored by the BCM.
Is there B+ voltage at the headlamp fuse's ? Power runs from fuse through the head lamps to the dimmer switch through the head lamp switch to ground when turned on . If there is B+ voltage at the fuse ,check for voltage at the headlamp switch .
The

Oct 16, 2016 | 2007 Saturn Ion

1 Answer

Where exactly is the fuse box located on a 1988 suzuki samurai


easy , stuff and answered 100 of times.
here goes again

there are 2 boxs, the main in engine bay
and one in cab.
the FSM covers this.

does car have DRL? lamps, like mandated in canada????
are both head lamps dead? there are 2 fuses.
so how would both blow left and right.
F1 is right
F2 is left head. fuse.
http://www.fixkick.com/sammi-stuff/schematics/pre1990-schematics-x3.pdf

here is more.
when you push head light FLASH lever do the high beams work>
must do so , with DLR or none
the above schmatic works for DLR and non DRL.
as you can see if the resistor burns up, (DRL) lows go dead in DRL mode only but work if you turn on HL to on.

tell more get more...
the drawing is free.

the fsm covers box location, look under dash yet.
seems not.
http://www.fixkick.com/sammi-stuff/index.html

Oct 26, 2015 | 1988 Suzuki Samurai

1 Answer

Were is headlight low beam relay


It is located in the under hood fuse/relay box . It's non -replaceable ,if bad whole fuse box has to be replaced ! The low beam headlamps may be turned ON in 3 different ways:
?€¢
When the headlamp switch in the HEAD position for normal operations


?€¢
When the headlamp switch is in the AUTO position, for automatic lamp control (ALC)


?€¢
When the headlamp switch is placed in the AUTO position, with the windshield wipers ON in daylight conditions, after a 6 second delay

Battery voltage is applied at all times to the coil and switch sides of the LOW BEAM PCB Relay located in the underhood fuse block. When the headlamp switch is placed in the HEAD position, ground from G202 is applied through headlamps ON switch signal circuit to the body control module (BCM), signaling the headlamps ON request. In response to this signal, the BCM applies ground through the headlamp low beam relay control circuit energizing the low beam relay. With the relay energized, battery voltage is applied through the switch side of the relay, the left and right low beam fuses, and the low beam supply voltage circuits illuminating the low beam headlamps. Ground for the left headlamp is provided at G101 and the right headlamp at G100.
Low Beam Relay Test

  1. Ignition OFF, disconnect the C2 harness connector at the underhood fuse block.
  2. Connect a test lamp between the control circuit terminal A5 and B+.
  3. Ignition ON, command the Low Beams ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
  4. ?‡'
    If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.


    ?‡'
    If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

  5. If all circuits test normal, replace the underhood fuse block.
  6. Ignition OFF, disconnect the harness connector at the inoperative low beam headlamp. Test for less than 5.0 ohms between the ground circuit terminal B and ground.
    ?‡'
    If greater than the specified range, test the ground circuit for an open/high resistance.

    Connect a test lamp between the supply voltage circuit terminal A and ground. Ignition ON, command the Low Beams ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    ?‡'
    If the test lamp is always ON, test the supply voltage circuit for a short to voltage. If the circuit tests normal, replace the underhood fuse block.


    ?‡'
    If the test lamp is always OFF, test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the underhood fuse block.

    If all circuits test normal, test or replace the low beam headlamp.

Jun 10, 2015 | 2006 Chevrolet Chevrolet Impala LS

1 Answer

Right side low beam headlight is out. I replaced it. It still does not work. I am sure it is a fuse.. I do not have my owners manual to see which fuse corresponds to that head light.The high beam does...


The fuse for the right (passenger) side low beam headlamp is located in the fuse box under the hood in the engine compartment. Below I gave you a picture of the fuse layout and the fuse you are looking for is the fuse in the number 6 location and should be a 10 amp fuse. I hope you don't take this the wrong way but some people get right and left mixed up and don't understand when you are talking right and left, it's as if you are sitting in the car. I just to make sure you have the correct fuse. If you happen to be talking about the "drivers" side low beam, that fuses is in the number 1 position in that same panel. I hope this helps you and good luck.

Jun 19, 2011 | 2007 Honda Accord Sedan

1 Answer

I have a 2006 altima and the low beam on the drivers side won't work i changed the bulb but noticed i had no power


these are fused individually right and left side and high and low beam for a total of four fuses controlling head lamps.fuses are located in black box near coolant reservoir and wiper washer fill.remove cover to access.location of fuses is marked on side of cover .i think you will find a blown ten amp fuse .i hope this helps.please let me know how you make out.

Feb 14, 2011 | Nissan Altima Cars & Trucks

1 Answer

I have no low beams. My high beams work but that is all.


Hi,

Thanks for using fixya.

If your low beams suddenly stopped working. All you need to do is to check the fuse box. You can find the fuse box by checking the owners manual. Look for the Head light low L-R fuse. check if they are blown out. If the fuse is good. check the head lamp bulbs, see if they are still okay. I hope this helps.

Thanks and have a nice day.

-Hotratchet

Nov 03, 2009 | Chevrolet Avalanche Cars & Trucks

2 Answers

Fuse box diagram for 2002 ford taurus


The 1999 Fuse Box Diagram is as follows:

Column 1 (Top to Bottom)
Driver Window Relay
Interior Lamp Relay
Driver Unlock Relay
Battery Saver Relay
Hazard Lamps (15A)
Diagnos (10A)
Cigar (20A)
Front Wipers (30A)
Air Bag (5A)
ABS (10A)
Shift Interlock (5A)
Blank

Column 2 (Top to Bottom)
High Beams (15A)
Deck Lid Release (15A)
Mirrors/Antenna (5A)
Head Lamp Illumenation (5A)
Light Out Module (5A)
EEC Ignition Coil (20A)
Brake Lamps/ A/C (15A)
Instrument Illumenation (5A)

Column 3 (Top to Bottom)
Accessorty Delay Relay
Rear Defrost Relay
Tail Lamps (5A)
Battery Saver (10A)
Wiper and Vaps (5A)
Rear Wiper (15A)
Turn Signal (10A)
Air bag/ Alt LPS (A)
Starter Relay (10A)
Left Low Beams (10A)

Column 4 (Top to Bottom)
Switch Illumenation (5A)
Def Sw Illumenation (10A)
Stop Lamps (15A)
Radio (5A)
Radio Memory (5A)
Right Hand Power Locks (20A)
Gauges/ Warning Lamps (5A)
Radio Mute (5A)
Right Low Beam (10A)

Hope this helps.

Apr 19, 2009 | 2002 Ford Taurus

1 Answer

My headlights dont work,.all other lights are fine though,.is it the fuses or the bulbs? im not sure what fuses they would be,.there seem to be different ones for the same thing


do your flash to pass lamps light when you pull the stalk towards you? If yes, the bulbs are ok.
Do the hig beams work?
Your headlamps have sepaerate fuses for each headlamp and you have a low beam relay and a high beam relay under the hood in the black box.
If everything is out, I suspect a bad headlamp switch.
Check car-part.com and look on page with * for cheapest price.

Your owner manual will identify fuses & relays.

PS, You did not recently instal high current bulbs did you? If yes, put originals back in.

HEADLAMPS

The voltage is supplied to the lamp switch through a fuse. This fuse is located in the central junction box in the left-hand footwell.
When the headlamps are switched on, a voltage is supplied to the high beam/low beam switch and to the low beam relay. The relay for the low beam is located in the battery junction box (BJB) in the engine compartment.
If the high beam/low beam switch is set to "low beam", then a voltage is supplied through the low beam relay to the low beam part of the headlamp assembly. The left and right-hand low beams are fused separately. The fuses are located in the battery junction box (BJB) in the engine compartment.
If the high beam/low beam switch is set to "high beam", then a voltage is supplied through the high beam relay to the high beam part of the headlamp assembly. The left and right-hand high beams are fused separately. The fuses are located in the battery junction box (BJB) in the engine compartment.

----------------------------------------------------------------------------------------------------------
Lamp Switch
Removal
  1. s2y~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
    Remove the lower driver's side footwell trim.
  1. Detach the lamp switch bezel.
    • Remove two screws.
  1. Remove the light switch.
    • Remove three screws.
    • Disconnect the electrical connector

Feb 23, 2009 | 2005 Ford Focus

2 Answers

My low beam lights come on.


dimmer switch is bad

Jan 26, 2009 | 2004 Ford F350

Not finding what you are looking for?
Cars & Trucks Logo

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...