Question about Cars & Trucks

1 Answer

Hi revs, 51 plate ford focus estate - Cars & Trucks

Posted by on

  • yadayada
    yadayada Nov 06, 2012

    Isn't that a good thing?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 43 Answers

Check your idle control setting

Posted on Nov 07, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 150 Answers

SOURCE: rear humming noise on my ford focus suspect rear wheel bearings

If the humming is more pronounced when you turn corners it is one of the wheel bearings.Listen to determine which side. They can be done easily DIY but only with some mechanical knowledge.The old bearing casings need to be removed from the hub using a small chisel or drift. The new ones need to be pressed back into the hub ideally but can be done using a hammer and a suitale sized socket.

Posted on Mar 21, 2009

juggernautxt
  • 145 Answers

SOURCE: what Bosch super 4 spark plug fits a Ford Focus 1.6 zetec.

my advise don't get those, they don't work as well as you think they do.
if you think about it if they are so much better why don't drag racers use them?
because they actually block the ignition point.

just get the factory style plugs and you will be better off.

Posted on May 17, 2009

  • 909 Answers

SOURCE: focus estate creaking and grinding when turning right

Could be the CV joint needs greasing up, or replacing, check for splits in the rubber gater around the drive shaft(looks like a bellow). Replace if necessary.

Posted on Jul 15, 2009

  • 184 Answers

SOURCE: flashing orange light in ford focus 51 plate car,

is it the eng light thats flashing on dash?

Posted on Sep 13, 2009

  • 369 Answers

SOURCE: The heater blower on my Ford Focus Turbo Diesel 51

the resistor on your blower is malfunctioning replace it.it is usually mounted on your blower

Posted on Jan 24, 2010

Testimonial: "Thanks very helpful was completely clueless "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

51 plate ford focus needs a radio code can anyone help. serial no 1g04120


Hi does any ine no the code for my focus serial number M020244

Mar 04, 2012 | 2000 Ford Focus

1 Answer

I have a 51 plate ford focus estate,the rear brake lights dont work although the high level one does,i`ve checked fuse and bulbs etc. any clues


If bulbs are definetly ok you can look behind trim on the left side in the boot, which covers the space between the boot floor and the window, you are looking for a green/red wire in a connector. this is the power cable which supplies both rear side mounted brake lights. You should check for voltage at this wire when pedal depressed. If no voltage you would need to trace this back to where the wire is joined in the loom as it feeds off the wire which supplies the high mounted brake light and you have stated that this works. Would still double check bulbs first though if you did'nt replace them. Hope this helps.

Jan 27, 2011 | 2000 Ford Focus

1 Answer

Please can tell the location of the fuse box on my ford focus 55 plates desil estate car


Passenger compartment fuse panel: The fuse panel is located below and to the left of the steering wheel by the brake pedal. Remove the CD stowage box to access the fuses. THis and other details can find in the 2005-Ford-Focus-Owners-Manual (page 148 and next).

Good lukc (remember rated this).

Aug 12, 2010 | 2005 Ford Focus

1 Answer

Wheres the filler hole on a 51 plate ford focus


Its usually on top of the gear box and there is usually a black or grey plastic top you can take off.

Jan 19, 2010 | 2001 Ford Focus

2 Answers

Sometimes car drives eally well plenty boost other


Hi,you need to get the codes read first this will probably show an intermittent problem with the accelerator pedal position switch,if not check for air and vacumn leaks to all the actuators ,the fuel pumps are know for internal failure if you use bad fuel,

Aug 11, 2009 | 2001 Ford Focus

1 Answer

Focus estate creaking and grinding when turning right


Could be the CV joint needs greasing up, or replacing, check for splits in the rubber gater around the drive shaft(looks like a bellow). Replace if necessary.

Jul 15, 2009 | 2004 Ford Focus

1 Answer

Rear humming noise on my ford focus suspect rear wheel bearings


If the humming is more pronounced when you turn corners it is one of the wheel bearings.Listen to determine which side. They can be done easily DIY but only with some mechanical knowledge.The old bearing casings need to be removed from the hub using a small chisel or drift. The new ones need to be pressed back into the hub ideally but can be done using a hammer and a suitale sized socket.

Mar 21, 2009 | 2001 Ford Focus

1 Answer

Does a focus zetec have a belt or chain


google ur car info hun... there u will find...

Jan 02, 2009 | 2002 Ford SVT Focus

1 Answer

52 focus estate loss radio code


hi there sharondav are u able to remove unit & look for serial no. on side unit serial no. starts with m & is six figure no.u need radio pins to take unit out which u can purchase at local car accessories or if you ask nicely u can ask u r local ford garage to take unit out it you can i will be able to get radio code for u.

Nov 22, 2008 | 2001 Ford Focus

1 Answer

Ford Focus Estate Diesel, 51 plate.


It turned out that the bulbs in the headlights had gone simultaneously. Luckily my son is knowledgeable about cars. He came over and figured out the problem. I had to purchase new bulbs, then my son had to practically dismantle the front of the car to change the bulbs. It was a complicated operation just to replace bulbs, and something I would not have been able to tackle myself. If it had not been for my son. I would have had to spend a fortune at a garage for a mechanic to replace the bulbs for me. What should have been a relatively simple task has become a mammoth operation. In years gone by it would have been a simple task that I could have performed myself. Why do manufacturers design cars so that it is so complicated just to replace the bulbs. There are so many things that have developed faults on this Ford Focus, I will never have another one.

Oct 03, 2008 | 2001 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...