Question about Cars & Trucks

1 Answer

WHAT DOES E13 MEAN - Cars & Trucks

Posted by on

  • Brad Brown Nov 06, 2012

    On what?

  • GERRI CHITTICK Nov 08, 2012

    NO because its a home heating propane monitor, & E13 means a couple of things, fuel lines need cleaning or the pump is gone, & that was the problem the "PUMP" needed to be replaced, the pump that fills the kerosene to the monitor

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,431 Answers

E13 is for a washing machine door

Posted on Nov 06, 2012


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I remove alternator?


-Disconnect negative battery terminal.
-Take the airbox out of the way, easier to work on.
-Remove the two long screws holding the alternator in place, I think it was with an e13 or 14 socket.
-Jack up the car, and you can pivot the alternator out of the bracket, might need a screw driver, and disconnect the harness
-After you got the alternator moved out of the way, there should be a 14mm, or 13mm nut holding the battery cable to the alternator. You can get it off with a long extension and ratchet.

Then the hardest part, getting the alternator out the engine block, take the wheel off and try to get it to slide out the engine bay from the bottom. Its a hard task. I had to remove my motor mount and jack it up from the side to the exact position to get it enough wiggle room to clear everything. You could also try disconnecting the CV shaft if its really stubborn.

Jan 08, 2016 | 2008 Saturn Astra

1 Answer

1998 buick regal stereo what are the wire color codes


showgif.do?image=73222

tif.gif
Connector Part Information
?€¢
12110115


?€¢
32-Way F Micro-Pack 100 Series (Blue)

Pin
Wire Color
Circuit No.
Function
E1
DK GRN
835
Entertainment and Comfort (E&C) Serial Data Communication
E2-E5
--
--
Not Used
E6
DK BLU
1796
Steering Wheel Controls Input
E7-E8
--
--
Not Used
E9
LT BLU
1405
Remote CD Changer Common Input
E10
ORN/ BLK
1406
Remote CD Changer Left Channel Input
E11
LT GRN
1407
Remote CD Changer Right Channel Input
E12
BRN
199
Speaker Feed-Left Rear
E13
YEL
116
Speaker Return-Left Rear
E14
DK GRN
117
Speaker Return-Right Front
E15
LT GRN
200
Speaker Feed-Right Front
E16
BLK/ WHT
351
Ground
F1
ORN
640
Fused Battery Feed
F2
YEL
43
Fused (Retained w/KP2) Accessory Power Feed
F3
DK GRN
145
Radio Switched Power
F4
GRY
8
Interior Lamp Dim Switch
F5
YEL
32
Fused Interior Lamp Dim Signal
F6-F10
--
--
Not Used
F11
BARE
2011
Remote CD Changer Drain
F12
TAN
201
Speaker Feed-Left Front
F13
GRY
118
Speaker Return-Left Front
F14
LT BLU
115
Speaker Return-Right Rear
F15
DK BLU
46
Speaker Feed-Right Rear
F16
--
--
Not Used

Dec 20, 2014 | 1998 Buick Regal

1 Answer

CODE E13 1986 CADILLAC DEVILLE?


E13 is a problem with the O2 sensor in the exhaust pipe.
The sensor would need to be checked.

Jun 25, 2013 | 1986 Cadillac DeVille

1 Answer

2000 Buick Century. Put in a replacement radio/cd/casset player. Radio works, clock works, but CD and casset do not. The message comes up E 13. What does this e code mean?


if its a radio shack radio, it means E13 means "Tape Communication Error". It is caused by the
microprocessor reading speed pulses from the tape deck either too fast, most other makes mean about the same thing, normally a stuck tape will cause this code to show up, either that or the drive gear that loads and unloads the tape is broken, cracked, or jammed

Sep 26, 2011 | 2000 Buick Century

1 Answer

Please help: 1992 Cadillac Deville: idles slightly rough, gas mileage has decreased. The check engine light goes on and off every once and a while. I got codes E13 and F48. Any advice is greatly...


E13: right bank O2 sensor, no data
F48: low refrigerant level in A/C system

Neither of these is likely to cause rough idle, but I would change the sensor.
If that cure it, great.

If not, make sure the vacuum hose on the fuel pressure regulator (at end of fuel rail) is tight at both ends and not cracked or leaking. Then pull the vacuum hose off the regulator and see if there is any fuel in the vacuum hose. If yes, replace regulator.
I also recommend cleaning up the intake side of engine with carb cleaner or equivalent: throttle body, Mass airflow sensor, EGR system, and PCV valve. Make sure EGR valve is operating.

If you have questions, please let me know.

335435f.gif
fuel press reg:

807b70b.gif

Oct 24, 2010 | Cadillac DeVille Cars & Trucks

1 Answer

MAJOR CADILLAC TROUBLE!!! I got my valve cover gaskets replaced and now my car accelerates funny. It feels like I my car is shifting gears bad and my car always reads 0mph no matter how fast I go. I...


Take the vehicle back to the place that created that all those issues.
You should not have to worry and look for answers. We can not help you over the internet
If it always read zero,not to be hurtful,that is neglect on your part. Have these problems checked out within days, of them first showing up.
You have had issues from the moment your speed indicator failed to work correctly. Most likely you fix that, and all you crazy codes go away.

Sep 19, 2010 | 1992 Cadillac DeVille

1 Answer

92 cadillac engine codes e13, e38, e44


HESE ARE OXYGEN SESOR CODES REPLACE THE OXYGEN SENSORS AND CHECK THE CONNECTORS

Nov 07, 2009 | 1992 Cadillac DeVille

1 Answer

1992 cadillac Deville OBD code read out and what it means.


E13-Oxygen sensor voltage stays between 0.307 and 0.609 volts for 64 seconds. Engine was at normal operating temperature at a speed over 800 RPM.
E44-Right oxygen sensor was lean for more than 50 seconds when engine was warm and at 800 RPM or greater.
E52-PCM has lost primary battery power.
E58-Pass Key fuel enable was not correct.
F47-PCM has received bad data from IPC for 3 seconds while engine speed was 500 RPM or more for 3 seconds.
F48-EGR open command was given during off idle operation. EGR opening should cause the mixture to be slightly richer because of the low oxygen content of exhaust gas. Vehicle speed was over 35 MPH and engine was warm.
Good luck and hope this helps, keep me posted be glad to answer any questions you may have. 

Jul 05, 2009 | 1992 Cadillac Seville

1 Answer

Wheel help!


225 = Tyre width
50 = Tyre Height
17 = Size of the wheel without tyres on.

You can go up a size to 18's and I'd suggest 225/40R18 TO GIVE YA A LITTLE EXTRA GRIP BUT THE COMFORT WILL SUFFER A BIT.

Hope this helps.

Apr 27, 2009 | 2004 BMW 5 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...