Question about 2002 GMC Envoy XL

1 Answer

CENTER BRAKE LIGHT DOESNT WORT - 2002 GMC Envoy XL

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

In the 2002 you cannot replace just the light. The housing needs to be replaced as well. For some reason GMC built the housing around the light so you can't just replace the bulb. Best bet for a new housing with light would be eBay.

Posted on Mar 19, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes the dash brake indicator to stay on?


First of all, the abs problem... NO do not start there, start with checking your brake fluid.. thats the number one cause for that light and no other lights on your dash to be on... if that is your problem fill it up and address the brake leak... brake fluid doesnt evaporate and your car doesnt use it up. if its low its going some where best way to do this is park on a clean surface or slide cardboard under your car pump your brakes 10 times and then examine the cardboard or move the car and look for wet spots that wernt there before or you could also have a friend lay on the ground a few feet back and look for drips while your pressing the brake pedal careful not to get any brake fluid in the eye it burns like no other... if you find a leak have it fixed if you dont it might still be a internal leak into the power brake booster and you should have someone look at it NORMALLY when you have a ABS problem with you car BOTH THE ABS LIGHT AND BRAKE LIGHT will be on not just one but the other awnsers could be correct too the brake indicator light does come on when the emergancy or parking brake is enabled try pulling the release and pull up on the parking brake pedal at the same time.. or if its a center parking brake push it all the way down with the button pushed

Apr 29, 2014 | 1998 Chevrolet K2500

1 Answer

I have a problem with the rear brake lights, hazard lights and the blenker lights not working. I do have parking lights and the single brake light above the back window is still working. I have check all...


The problem is most likely with the turn signal switch, since the brake lights use the same bulb elements as the turn signals, the wiring runs through the turn switch which is why the center light still works fine.

Oct 16, 2010 | Chevrolet 1500 Cars & Trucks

1 Answer

Center brake light flashes along with right blinker only


85 fury with a center brake light? Did someone add this light and wire it to the right tail light. You need to wire it to the brake switch.

Jul 24, 2010 | 1985 Plymouth Gran Fury

2 Answers

Brake light doesnt work


sounds like the brake light switch at the brake pedal my need to be replaced

May 03, 2010 | 2003 Land Rover Freelander

1 Answer

Brake light is on, emergency brake doesnt work too well, not sure how to tighten the slack in the cable, and if its not so simple id like to know how to turn the light off to get a sticker


The brake light switch is stuck on.The switch is located under the dash,and if you follow the arm up from the brake pedal you should be able to see the plunger where it contacts the arm.As far as your emergency brake if you have a center console lever there may be a adjustment there or if you look under the car there should be a adjustment at the equelizer.This is where a single cable goes in to two cables.Well good luck and hope this helps.

Mar 25, 2010 | 1996 Chevrolet Camaro

1 Answer

Center brake light illuminates, but LH/RH brake lights do not


LH/RH lights cable could be disconnected anywhere, will take a long time to trace.
Center Brake Light and LH & RH should be connected at one point.
Jump a cable from Center Brake Light to one of Rear Break Light.
Hope this will works.

Sep 12, 2009 | 1995 Toyota Tercel

1 Answer

Wires burned no brake lights and one taillight doesnt work


Yes , The wiring in question does effect the brake lights because they all run on the same circuit.
I would repiar or repalce all the wiring and then replace the brake light switch. The switch could have shorted out from the fire.

Apr 11, 2009 | 1998 Dodge Caravan

3 Answers

Left and right brake light doesn't work but center lights does


check behind the brake peadle for a little button that pushes in and out when the peadle is pressed(this is your brake light switch) some cars have more than one of theese. manualy let the button out if the light works the switch is good if it does not disconect the harness from the switch and take a small piece of wire and jump the two prongs on the harness if the brake lights come on then you need a brake light switch. if this doesnt work check for power at the switch. if no power you have a bad fuse if there is power and you already jumped the wires to the switch then you have a broken wire between the switch and the tail lights.

Dec 25, 2008 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2002 GMC Envoy XL Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...