Question about 2004 Jeep Grand Cherokee

1 Answer

Ihave a fault code P0620

Not fuses what next

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 79,851 Answers

Duplicate question.

Posted on Nov 05, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

'05 Buick Rendezvous alternator charges, but turns on the battery light on the dash. Trouble code P0620 is set.


First check voltage on your battery with a multimeter a fully charged batt should be 12.6 bolts . Disconnect the battery from the car check voltage, second tyical voltage regulator maintain voltage between 13.5 and 15.5 . 15 when cold and 13 when hot. The regulator allows higher voltage to force electrons into you batt. If batt voltage is under12volts change batt. Is your regulator does not maintain 13 or above change alternator or alt regulator. Good luck

Dec 28, 2017 | Buick Cars & Trucks

1 Answer

Ihave changed the crank sensor and the coles on the plugs but still the it wont give a spark.


DID YOU CHECK THE COIL PACK.........THIS SENDS A SPARK TO YOUR SPARK PLUG

Apr 15, 2014 | 2005 Toyota RunX 160i

1 Answer

Fault code p0703


P0700 Transmission Control System Malfunction
P0730 Incorrect Gear Ratio
P0620 Generator Control Circuit Malfunction
P1130 Not found
P0340 Camshaft Position Sensor Circuit Malfunction

Mar 06, 2013 | 2002 Jeep Grand Cherokee

1 Answer

Ihave a fault code P0620


P0620 - Generator Control Circuit Malfunctionxicon.jpghttp://engine-codes.com/p0620.htmlForum CodePossible causes- Failed Generator/Belt
- Battery charge
- PCM controlled generator
- PCM failure
- Open or short generator circuit When is the code detected?The PCM has fault detection circuitry which monitors the state of the generator turn on signal circuit. If the fault detection circuit senses a voltage other than what is expected, this DTC will set. The voltage regulator also contains fault detection circuitry. If the regulator detects a problem, the regulator will ground the generator turn on signal circuit, pulling the voltage low. This also causes the PCM to set the DTC.

Nov 05, 2012 | Cars & Trucks

1 Answer

Ihave a 08 honda odssey, a new battery was install and their is no power to the radio, i have the code but it don't turn on so you can put the code in


Have you checked the fuse for the radio, there may be more than one, there should be one in the fuse panel on the inside of the vehicle and there may or may not be another fuse and relay housing in the engine compartment.

Apr 02, 2012 | Cars & Trucks

1 Answer

Codes p0620 and p0742 came up how to fix?


hi, this is an article that will tell you the meaning of code. and I think this tool can clear the code out. hope help.

Jun 28, 2011 | 1999 Chevrolet Venture

1 Answer

Brake warning light and abs light on. Code P1130 and P0620


0620:

http://www.helpforcars.net/obd_codes/p0620.html

P1130: Most likely you have a bad oxygen sensor. This would be the first oxygen sensor if you have more than one meaning the one closest to the engine and BEFORE the catalytic converter. They're pretty common and inexpensive enough where I'd recommend changing that first and see if the light goes out on it's own.Hope this helps Tim

Apr 23, 2011 | 2003 Jeep Liberty

1 Answer

P0000, c2202, 02062, p0620, u0101


i am receiving a code u0101 on my 2005 dodge durango. can you help me. i think it has something to do with the tcm but i am not sure. "LEN"

Oct 06, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer

Ihave a1997 dodge full size 4x4 with airbag lamp on and also the abs&brake lamp on fusees ok fault code #2 flashes everything checks out oK.


First try disconnecting the battery, so the PCM and the error code cache is erased and your computer is reset. If there is a problem they will come back on, if not they will have been cleared and its nothing to worry about.
If that doesn't work let me know and I will walk you through some troubleshooting.

Mar 29, 2010 | 1997 Dodge Ram

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...