FORD FALCON UTE SPEEDO NOT WORKING AND WONT CHANGE GEARS

SOURCE: xf falcon ute dies driving up hill

have had a few of these in with carb faults but were 2 barrel type.basic checks first,is pcv valve hose under carb not split(runs to valve cover or oil cap on this model?).try driving without airfilter element for test,have had one in that looked clean but had a fine mist of oil on it that blocked and caused air starve and stall on power.Did both problems start at same time? or maybe you are chasing 2 probs.being a ute.I have had probs with rusting petrol tanks and blocked fuel filters

wayne

• 364 Answers
• Posted on Dec 16, 2009

SOURCE: ford falcon gear not changing

Common answer for this problem is low trans fluid, if thats ok, then check your vaccuum line to the kickdown solonoid to see if it is not split or a hole, if you have cable, try adjusting it near the carby, lastly, it could be the clutches in the trans are shot, remember we are here to help as best we can, so I hope this gets you going, good luck.

SOURCE: my 2003 ba ute transmittion has problems, when in

check the codes but is likely the shift position sensor on trans

SOURCE: need a diagram to change rear wheel bearings

if you are looking for a manual for this car, try this link... http://cgi.ebay.ph/Ford-Falcon-Ute-BA-series-Repair-Manual-2002-2005-on-CD_W0QQitemZ170423275380QQcmdZViewItemQQptZAU_Clothing_Merchandise_Media?hash=item27ae04cf74 For twenty bucks you can do it all yourself

SOURCE: 2001 Ford Falcon AU111 speedo not working again.

Hi,
Just check the connection on the speedo sensor and the wiring that leads up till it gets to the main loom. There could be a loose connection there.

If thats ok then you will need to get the loom checked and the dash. It could be the dash is faulty..

Thanks

Jason

Testimonial: "Hi Jason, Thank you for your help. I shall check that out today. Regards, Janel"