Question about Cars & Trucks

1 Answer

I need instructions on how to complete a tuneup for the 2006 Buick Rendezvous

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 77,169 Answers

What parts do you wish to rellace, in most cases the plugs are all that is done at 100,000 miles.

Posted on Nov 05, 2012


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2035 Answers

SOURCE: What would cause the AWD light to come on in a

There could be alot of problems if the AWD lights comes it could either
transmission oil is old or the oil filter is dirty ,these interact with onboard
computer and produces false signal which causes the car to be AWD mode
or this could be the problem with selector switch ,first try to replace the oil and check if its AWD light goes......

Good luck...

Posted on Feb 18, 2009

  • 2984 Answers

SOURCE: How to change the fuel filter in fuel tank 2006

3.4L & 3.5L Engines

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
    • Fuel filter mounting bracket nut
    • Fuel filter and drain any remaining fuel

The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:
  1. Install or connect the following:
    • Fuel filter to the bracket
    • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
    • Inlet/outlet quick connectors to the fuel filter
    • Negative battery cable
  2. Start the vehicle and checks for leaks, repair if necessary.

Posted on Oct 11, 2009

Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."

  • 743 Answers

SOURCE: Can I charge the battery for 2006 Buick

By disconnection one of the battery wires...if it is a side post, you will need to go to your auto parts store and get a post that screws in so you can attach the charger cable...the reason that you don't charge with everything hooked up is because you can get a surge and damage the components in the computers.

Posted on Oct 29, 2009

Testimonial: "Wire "+" connect to "positive (+) jump starting terminal" or to terminal " + " battery?"

  • 491 Answers

SOURCE: I want to change the battery in 2006 Buick

On most cars after 2000 it is recommended to keep a minimum of 9 volts in the system when disconnecting the battery.
You can buy a 9 volt battery unit to plug into your lighter socket.
Otherwise....if you have a battery charger....attach it to the alternator output and put it on its lowest setting....that should keep voltage in the numerous memory circuits while you change the battery.

When changing the battery.....(removing voltage from the system) it's a 50% chance of putting the radio into theft mode.
The codes to take it out of theft mode are available online.....just google.

Posted on Oct 29, 2009

SOURCE: cigarette lighter fuse

check under the steering wheel in the glove box or open either front door and check the ends of the dash

Posted on Dec 29, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Window slipped 2006 buick rendezvous driver side

Window slipped ???? Your going to need to explain that a little better !

Dec 16, 2016 | 2006 Buick Rendezvous

1 Answer

How do I attach factory crossbars to the luggage rails of my 2006 Rendezvous?

If you purchased factory crossbars they come with INSTRUCTIONS!!!!!!!!!!!

Mar 22, 2015 | 2006 Buick Rendezvous

2 Answers

Where ia the crank sensor at on a buick rendezvous 2006 3.5 v6

Based upon the design the of replacement part, it appears that it would be bolted to the transmission bell housing at one side of the engine adjacent to the flywheel where it can sense the flywheel teeth passing the sensor head.

Aug 02, 2014 | 2006 Buick Rendezvous

1 Answer

Vacuum hose diagram 2006 buick rendezvous

I believe that the 2006 Buick (if it is a U.S. version) is required to have a vacuum routing diagram posted at the engine (usually on top of the fan shroud). Check there.

Jul 19, 2014 | 2006 Buick Rendezvous

1 Answer

Buick wont start

Please see my tip at . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Sep 26, 2010 | 2006 Buick Rendezvous

1 Answer

2006 Buick Rendezvous cxl broken rear hatch strap!

I believe there is a recall for that feature. but i am not 100% sure. it was recalled on 2004 rendezvous

Jan 12, 2009 | 2004 Buick Rendezvous

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides