Question about 1988 Toyota Tercel 2 Door

1 Answer

88 tercel no spark, cranks fine

Sudden failure to start. Ran fine on Mon. wouldn't start the next day. No pervious indication of any problem. It cranks over strong but will not fire. Changed spark plugs, coil, pickup coil. Still won't fire. No spark to plug.

Posted by on

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,692 Answers

Unless you have the equiptment to check the microprocessor, I believe that is next.Sorry 

Posted on Jan 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No spark to spark plugs on 2000 4.0 liter sohc motor. coil pack, crank sensor?


Parts stores can test ignition module. You can check ignition fuse and tap on relay. Crank sensor is common failed part, but harder to test. If you know how to access it, you can test for continuity by back probing connector.

Apr 18, 2014 | 2001 Ford Explorer Sport

1 Answer

Replaced distributor in 2000 nissan quest ,now van wont start


check if there is spark in your plugs, if none, just replace ignition coil.

Jun 10, 2013 | 2000 Nissan Quest

1 Answer

Have a 1996 ford explorer. It started the other morning just fine and ran good, that afternoon I couldn't get it to start. Changed the fuel filter and it started and ran fine again. Cut it off when I...


first need to make sure you have enough fuel pressure. Hook up a tester and check against the specs. if its too low, then your probably looking at a fuel pump. By replacing the filter, you allowed more fuel to flow. Also, make sure you are getting spark and injector pulse.

Apr 14, 2013 | Cars & Trucks

1 Answer

The car dies out, it will turn over but wont start, it ran one day then wouldn't


It is probably one of three things. It isn't getting a proper spark, proper fuel, or proper compression. Good luck!--------------------------------------------------------------------------
VAS 5054A

Dec 17, 2012 | 2006 Kia Optima

2 Answers

Dying 1996 Jeep Grand Cherokee Limited


I wouldn't think catalytic converter, without it giving some indication that it was going bad, but without testing it is hard to say.
When it cranks and won't start, check for battery voltage to the coil on the dark green wire, with key ON. If you have power at the coil, it might be a bad coil. If no power to the coil, it could be a Crank Position Sensor or the Cam Position Sensor inside the distributor. If one of those is bad, it can stop the computer from sending power to the coil.
Good luck.

Jul 06, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

98 Ford F150 w/4.6l Wont start. Hear fuel pump click. Have pressure on fuel rail. Pulled #1 plug from head and plugged back into wire. Grounded plug and cranked. No spark. Changed wires 4 and 7 four days...


have diagnostic codes checked to see if you have a cam or crank sensor fault. make sure fuel pressure is at the required pressure, just testing to see if you have fuel at the valve is not enough. replace all spark plug wires. if you replaced two then all are just as old and even when they "look good" does not qualify as "they are good". Replace coil pack. start up drive away happy

Sep 05, 2011 | 1998 Ford F150 Regular Cab

1 Answer

My truck was running fine and got in it the next day and it wouldn't start.. I'm not getting any spark.


What year model is the truck? if it has a Tach then crank engine over if tach doesn't move then suspect a faulty crank sensor if it does move check power to coil. several other things this could be but this is a start.

Jul 14, 2011 | Dodge Dakota Cars & Trucks

1 Answer

88 cavalier has no spark


check the throttle position sensor,it may be stuck and it wont start unless its all the way back.Almost like trying to start it with the gas pedal down-which it will crank and crank but it wont start.

May 31, 2009 | 1988 Chevrolet Cavalier Z24

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...