Question about 2010 Ford Focus 1.6

Open Question

2010 ford focus horn dose not work

Horn worked until it was towed and impounded now just a click. the lights go on and off when you set the alarm but the horn is silent.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 5158 Answers

SOURCE: horn replacment

look under the dash at the fuse panel and locate the relay for the horn... replace it. quick way to tell which one it is is put your finger on each relay as you press the horn... the one that you can feel clicking is the one to replace.


Please take a moment to rate this solution thanks

Posted on Feb 08, 2009

  • 30 Answers

SOURCE: 2002 Ford Focus Doors lock with key fob, but horn does not honk

there are two seperate horns

Posted on Mar 11, 2009

  • 597 Answers

SOURCE: power locks, windows, and horn

Owner's manual should have a diagram of the fuse panel. Need to find which fuses control these items and check the fuses.

Posted on Dec 05, 2009

  • 486 Answers

SOURCE: reversing light on my ford focus (51 plate) dose

the switch is in fact the earth when you select reverse it gronds the wire, so to test take lead off and earth it, there will be a contant live to the bulb with the ignition on, if when earthed the light works the fault is with the switch, which could be an adjustment problem, or a defective switch. if does not work when earthed check the live to the bulb then check fuse

Posted on Dec 06, 2009

  • 677 Answers

SOURCE: 2003 Ford Escape Horn stopped working

The horn itself , or the wire to it needs to be replaced.
I have the part :
Please click on the contact, and I will help you out, and give you step by step instructions on how to replace.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where do i locate horn on a 2001 ford focus

Hi there,

If your horn is not working, check the horn relay before anything else. Press the horn actuator on the steering wheel, and have someone listing within the engine compartment for a distinct 'clicking.' If you hear it, then it's working and the horn component itself may be malfunctioning. The horn looks like a square-mouthed snail shell and should be just behind the front bumper skirt on the driver's side. More or less beside the fog light assembly.

Good luck.

Feb 24, 2015 | 2001 Ford Focus

1 Answer

2001 GMC SIERRA 2500 HD alarm horn stopped working, reg horn dose'nt work either. Alarm lights still go off when activated through key fob. Checked all fuses and wiring, driving lights not working...

You need an ohm meter and check to see if ther is power at the horns and lights. There is no programming that turns off the horn on the steering column. But I have one of these trucks and had the same problem with the lights and horns but it didn't happen at the same time. My lightbulbs burnt out and the actual horns under the bumper did to. Hope this helps.

Jun 29, 2011 | GMC Sierra 2500HD Cars & Trucks

2 Answers

My horn is not working but the alarm go' s off and it works....

you need a test light .connect the clamp end to the battery positive post . then remove the horn relay .prob pin 86. have some hold the horn button down .it should light if the circuit is ok. if not then remove the 4 or 2 bolts that hold the air bag to the steering wheel .do not unplug or appliy power to the yellow connector it will deploy the air bag. you should see the two black wires to the horn buttons. with a ohm.meter mesure the one that gose to the clock spring should be open untill you press the horn button then it should short to ground. if it dose the clock spring is bad. but you will want to test it first.sgm1115_48.png

May 03, 2011 | 1998 Ford Expedition

1 Answer

I have just installed a new battery in a 2004 focus and now the alarm system keeps going off what do you do? Tried diconneting and then reconnting still the system continues to go off

If you have a remote, lock then unlock the doors using the remote. That should stop the horn. If that doesn't work, use the ignition key in the driver's door lock and turn the key all the way to the left, then all the way to the right. Of course, this all has to be done with the battery connected, and the horn honking the whole time. If none of this works, look for a reset button under the driver side dash, or it may be a toggle switch. With the key in the on position. push and hold the button until you hear a beep from the alarm. On some cars, the reset button is behind the driver side kick panel.

Feb 09, 2011 | 2004 Ford Focus

1 Answer

My 2004 ford focus flight horn is not working its making a clicking sound when i press it i tried the fuse

needs a new horn,try putting some engine oil on the front of it where the it vibrates ,then assistant holds horn on and you tap it with a small hammer ,if it starts working then make sure assistant hold it on for at least a minute then it should work ,

Aug 17, 2010 | 2004 Ford Focus

1 Answer

My horn does not work. I press the horn, but all i hear is a click in the fuse box. Checked the fuse and it is good. I bought it from a auction and had problems with the alarm and locking because i didnt...

If the horn fuse ( Fuse #26 ) is installed and has power on both sides of the fuse, you might want to check that the horn connector is still on the horns.

The horn relay is not serviceable in the fuse panel.

You can test the horn connector for power, the Yellow w/ Light Green wire, when the horn button is pressed.

Feb 02, 2010 | 2005 Ford F-150

1 Answer

1991 Cadillac Deville won't engage in gear

the idiots must have towed the the car by the wrong end , this will burn out the transmission in short order. Any car needs to be towed with the drive wheels off the ground, if that is not poss then the drive-shaft has to be removed.

Dec 16, 2008 | 1998 Cadillac DeVille

Not finding what you are looking for?
2010 Ford Focus 1.6 Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides