Question about 2008 Nissan Sentra 2.0

Open Question

How to install brake shoes on 2008 nissan sentra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

Posted on Feb 28, 2009

mcgyver468
  • 710 Answers

SOURCE: I WOULD LIKE A NISSAN SENTRA 2008 BELT ROUTING DIAGRAM

THERE SOULD BE A DIAGRAM UNDER THE HOOD ON A WHITE STICKER SOMEWHERE IN THE FRONT OF THE MOTOR.HOPE THIS HELPS. LET ME KNOW. GOOD LUCK

Posted on May 03, 2009

  • 770 Answers

SOURCE: brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Posted on Jun 21, 2009

A3sthetix
  • 41 Answers

SOURCE: How do I change brake light bulb of Nissan Sentra 2008

Was able to complete this job successfully:
It's a little tricky to do without pictures, but I don't have any available right now.

  1. Access the trunk
  2. Remove the material covering the light. You'll need to remove the black pegs by lifting the centre part. A flathead screw-driver will help. There are 2 to remove -- one directly behind the brake light and another at the top of the trunk.
  3. Pull back the material to expose the brake light wiring and the metal frame of the car.
  4. There are 2 nuts / screws to remove near the entrance of the trunk. Both are about 4 inches apart and hold the tail light's cover in place. Remove both.
  5. Using a bit of force, you will be able to pull off the entire tail light from the frame of the car. This is done on the exterior of the car.
  6. Rotate the problematic light from it's housing (it should come off with ease) and pull it out of the socket. Brake light and indicator are a 3057K bulb.

Posted on Jun 22, 2009

MNfisherman
  • 11896 Answers

SOURCE: 1995 Nissan Sentra, The engine light and brake

You could have faulty altenator or short causing the battery to drain. The engine light usually comes on when anything electrical or sensor wise is faulty. Brake light will come on if, low brake fluid, e-brake handle is up.

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced front pads on my 1999 Nissan Sentra. Brake pedal felt low.Had system flushed, bled and rear shoes adjusted. Still have low pedal and spongy feel. Suggestions?


have had this on different models and makes and what i do is to push brake pedal down and jam it down a length of wood or anything that holds the pedal down a bit not hard down -and leave overnight .if this fails then renew the master cylinder

Dec 03, 2016 | 1999 Nissan Sentra

1 Answer

Free Repair Manual


Drum brakes use an automatic adjuster to gradually move the shoes closer to the drum as they wear. When installing new shoes, you will need to adjust this back.

May 13, 2013 | 2000 Nissan Sentra

1 Answer

Recalls on the 2008 nissan sentra


Recall ID# 72326 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COM
Recall Date: July 11, 2008
Units Affected: 169202


Read more: http://www.automobilemag.com/auto_recalls/11/nissan/sentra/#ixzz2Hy8jQii1

Jan 14, 2013 | 2008 Nissan Sentra

1 Answer

I am trying to change my brake light on the drivers side of my 2008 nissan sentra hot do i get to the bulb


through the inside behind the interior are plastic nuts remove and you should be able to remove tail light

Aug 12, 2010 | 2007 Nissan Sentra 2.0 SL Sedan

1 Answer

I have a burnt out bulb on my 2008 nissan sentra which is located on the rear dash behind the passaenger seat how do i replace it


Open your trunk and look on the underside of the "rear dash" towards the center. You either can replaces bulb by twisting the pigtail going to the light or you may have to unscrew a couple of bolts to remove the brake light housing. Hope this helps.

Mar 23, 2010 | 2008 Nissan Sentra

1 Answer

Brake light, 2008 Nissan Sentra


Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Jun 21, 2009 | 2008 Nissan Sentra

Not finding what you are looking for?
2008 Nissan Sentra 2.0 Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...