Question about Peugeot Cars & Trucks

Open Question

308 hdi stalling

My 308 idles ok then all of a sudden stalls.Some days it's ok then others will not idle at all

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 178 Answers

SOURCE: rough idle stalls at low rpm's

hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck

Posted on Sep 18, 2008

Ad
  • 1 Answer

SOURCE: 1997 Grand Cherokee stalls at speed and at stop signs

Mine does the same thing when the oxygen senor goes out... About every 70k miles. doesn't always turn on check engine light

Posted on Feb 16, 2009

  • 1 Answer

SOURCE: 98 Isuzu Trooper stalls on cold start, idle issues..

I had the same issue on my 99 Trooper.

It would usually start when completely cold, but idle around 2k RPM.
It would drive fine. But if I shut it down, ran into a store, and came back out, it would start but immediately idle.
Had to ride the gas a little to get it into gear.
The Check Engine light has been going on and off for 6 months or so.

I took this to my local trusted repair shop (no Isuzu dealers within 200 miles).
The diagnosed the light, and found that the Intake Gaskets were bad or leaking.
The idling problem was related to the car not being able to control the amount of air coming in.

They replaced the Intake gaskets by the next day, and I haven't had a problem since. And no more check engine light, which has been on half a year.

Here's some details from my bill:
(1) Intake Gasket set $107.95
Misc materials $21.00
2.1 hours of Labor

The total cost to me was $345.00, and I definately don't feel gipped.

Posted on Mar 06, 2009

teezay731
  • 1 Answer

SOURCE: rough idle stalls at low rpm's

check your transmission fluid,the motor will stall when fluid is low

Posted on Mar 24, 2009

  • 4 Answers

SOURCE: have a 1985 mazda rx7 will not idle .. cold start

There is a throtle adjuster right behind the carb. You can adjust it with a screw driver. If you are not sure where it is, just have someone press to gas pedal and you will see it move. RPM's at idle should be around 1,000 when it is idle once it has warmed up. Once that car warms up the choke moves back in and the car is probably stalling because it is not running enough RPM's.

Posted on Jul 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but when put in gear it dies/stalls


my ford winstar vav stalls when you put it in drive will idol all day just find

Apr 08, 2013 | 1993 Buick Century

1 Answer

2003 nissan frontier stalls when i slam on the brakes


Check oil level, but might be idle motor going bad. The idle motor kicks down the idle as needed as the rpm dictates. If sudden reduction in rpm occurs the idle motor normally keeps up and motor continues running at reduced idle. Unless its going out on you, then you may experience stalling when speed is suddenly reduced such as hard braking.

Mar 16, 2013 | 2003 Nissan Frontier Crew Cab

1 Answer

4 cylinder 4 speed 1987 s10 stall's. Will idle all


What are the conditions when it stalls ?
And does it start back up ?

Jan 12, 2013 | Cars & Trucks

1 Answer

Idling issues


does it idle ok in park? how does it idle in drive but not moving?

Jan 06, 2013 | 2002 Jeep Liberty

1 Answer

I have mercury villager 1999 ,when started in morning idler ok , after run for 20 mnts engine stall in idler turn off ,end stared back up ok give gas go normal , and star again idler low like lose power...


Read the following and follow the instructions for this problem.

Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Sep 28, 2017 | 1999 Mercury Villager

1 Answer

1990 Ford Probe 2.2 automatic stalls in forward, reverse OK


Sounds like a bad IAC (idle air control valve/sensor) that controls your idle when going from throttle to idle. If bad your idle will act crazy and can cause stalls easily. Pretty sure that's it.

Dec 20, 2008 | 1993 Ford Probe

1 Answer

2002 sequioa sudden stall


Often when the battery is disconnected or replaced the computer will lose it's learned idle settings. You could try letting the engine idle in park until the engine temperature comes up to normal and leave it like that for a few minutes, then put the Air con on and let it idle again for a few minutes, then switch the air con off and put it into drive. If it does not stall, let it idle in drive for 2 minutes or so, and then do the same with the Air con on. This should relearn the base idle settings and stop it from stalling on you. Before you carry out this procedure you should make sure that when you replaced the battery you didn't remove any other plugs or knocked anything that may be causing the fault. If you try this procedure and it still stall when you select drive, you will need to get a Mechanic to check the vehicle over.

Hope this helps,
Mark.

Nov 02, 2008 | 2002 Toyota Sequoia

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...