Question about 2002 Chevrolet S-10

Open Question

Interior door chime on chevy s10 not going off

Interior chime not going off when key is in ignition, tried to remove fuse but operates brake lights also. Please help Robert Cincinnati Ohio

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: I have a 97 Chevy S10 pickup...cannot move shifter out of park

When my battery was dead i was forcing the key in the ignition which messed everything up with my chevy s10 and have to get everything replaced....: (

Posted on Jan 20, 2009

Ad
  • 150 Answers

SOURCE: Radio, Key auto door lock/opener, interior lights not working.

Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.

Posted on Feb 18, 2009

csmock132
  • 4669 Answers

SOURCE: i have a 1990 chevy s10,all my lights work except my brake lights

Do you have power with a test light in and out of the switch? Do the turn signals work? Will the brake lights work if you play with the turn signal handle?

Posted on May 06, 2009

  • 3 Answers

SOURCE: My third brake light dosen't work on my chevy s10 94'

I had a similar problem with my 1994 S-10 LS extended cab. Both tail brake lights worked fine. I removed the 3rd brake light cover and tested for voltage at the steel center of the two rivets and found the positive (driver side) negative (passenger side) were good. I checked the two metal strips that send power to bulbs and found the positive side was open. Seems the flared side of the rivet was not making contact with the metal strip. I bucked the rivet with a punch and hammer and it took care of the problem.

Posted on Jun 23, 2009

  • 156 Answers

SOURCE: 98 chevy S10.Tried bleeding brakes,Front ok,Rear not reacting

Check the master cylinder and make sure it is working correctly and both resevoirs are full.

Posted on Jun 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Pontiac grand am se1 acts like door is open and interior light stays on also does t lock on its own when in gear and lights don't blink and horn not honk when locking with key bob


Door ajar switch problem more then likely or wiring issue . The BCM - body control module won't turn off interior light , let door lock because it think's the door is open . The door ajar switch is a input to the BCM .

The first thing would be to have it checked for DTC'S - diagnostic trouble codes . Also check with an enhanced scan tool to see if the BCM shows ajar switch data (open or closed ? Do you know about body electronics ?
Body Control Module
The various BCM input and output circuits are described in the corresponding functional areas indicated on the BCM electrical schematics. The Body Control Module functions include the following:
?€¢
A/C compressor request. Refer to Air Temperature Description and Operation


?€¢
Remote Function Control. Refer to Keyless Entry System Description and Operation


?€¢
A/C cooling Fan. Refer to Air Delivery Description and Operation


?€¢
Audio Delay Power. Refer to Radio/Audio System Description and Operation


?€¢
Exterior and interior lighting control. Refer to Exterior Lighting Systems Description and Operation


-
Daytime running lights (DRL)


-
Automatic lighting control


-
Fog lamps


?€¢
Interior lighting. Refer to Interior Lighting Systems Description and Operation


?€¢
Battery rundown protection (Inadvertent Power). Refer to Interior Lighting Systems Description and Operation


?€¢
Chimes. Refer to Audible Warnings Description and Operation


-
Key-In-Ignition


-
Head Lamps On


-
Seat Belt Not Fastened


-
Turn Signal On


-
Park Brake Warning


-
Door Ajar Warning


-
Check gages


?€¢
Gage control. Refer to Instrument Cluster Description and Operation in Instrument Panel, Gages, and Console.


?€¢
Instrument cluster indicator control. Refer to Instrument Cluster Description and Operation in Instrument Panel, Gages, and Console.


?€¢
Theft deterrent. Refer to Theft Systems Description and Operation .


?€¢
Engine coolant level sensing. Refer to Cooling System Description and Operation .


?€¢
Washer solvent level sensing. Refer to Wiper/Washer System Description and Operation in Wipers/Washer Systems.


?€¢
Key-in-ignition sensing. Refer to Audible Warnings Description and Operation in Instrument Panel, Gages, and Console.


?€¢
Seat belt use sensing. Refer to Seat Belt System Description and Operation .


?€¢
Brake fluid level sensing.


?€¢
Parking brake state sensing.


?€¢
Rear compartment interface. Refer to Power Door Locks Description and Operation


?€¢
Horn interface.


?€¢
Door lock interface. Refer to Power Door Locks Description and Operation


?€¢
Bulb Check. Refer to Instrument Cluster Description and Operation in Instrument Panel, Gages, and Console.

Oct 24, 2016 | 2004 Pontiac Grand Am

1 Answer

What should I check with no interior lights or door chime operating with the opening of any doors?


Try these simple checks 1st;

Check the door plunger buttons on all the doors make sure there not stuck.

check to fuse box for a blown fuse, replace.
If this do'es not work then its more complicated get back to me.
Hope this helps Mike

Jan 17, 2016 | Cars & Trucks

1 Answer

Why won't my My 98 or 99 (sic)Ford Escort chime to indicate I left my lights on?


The warning chime sounds if the parking lamps (13200) or the headlamps (13008) are left on after the key has been removed from the ignition switch lock cylinder and either front door (20124) is opened. There is a chime module that controls this .
The safety belt warning chime (10D840) (also called the central processing unit or CPU) is an audible warning system and timing circuit. The system components include:
  • Timing circuit safety belt switch.
  • Dome lamp switches.
  • Safety belt warning indicator switch which is an integral part of the front safety belt buckle end (61203).
  • Ignition switch (11572).
  • Headlamp switch.
The warning chime sounds and the safety belt warning indicator illuminates when the ignition switch is placed in the ON position and the LH front safety belt is not buckled.
Key In Ignition Warning
The warning sounds if the key is left in the ignition switch lock cylinder when either door is opened and the ignition switch is in the LOCK or OFF position.
Don't any of chimes work ?
  • The Headlamp on Reminder Chime Is Inoperative/Does Not Operate Properly
  • Circuits.
  • Fuse junction panel.
  • Warning chime module.
  • GO to Pinpoint Test D .
Let me know ,mite work this out !
Don't

Apr 29, 2015 | Ford Escort Cars & Trucks

1 Answer

How do I disconnect the warning chime?


Key in ignition chime ?
Saturn L-Series ?????? L what ? L100 ,L200 , L300
Audible Warnings
The body control module (BCM) will provide an audible warning for various events relating to the vehicle. The functions that provide an audible warning are the key in ignition, the lights on, the occupant restraint (seat belt) and the park brake.
Key in the Ignition Audible Chime
The BCM will provide an audible chime if the key is left in the ignition in either OFF or the accessory position with the driver's door open. The chime rate for this is 150 chimes per minute. The key in the ignition chime has a higher priority than the lights on chime.
Lights on Audible Chime
The BCM will provide an audible chime if the park lights are on and the driver's door is open. In addition, 1 or 2 other conditions exist. The key is out of the ignition, or the key is in the ignition in the OFF position, and has not been turned. The BCM will chime at a rate of 200 chimes per minute until the conditions are removed.
Occupant Restraint Audible Chime
The BCM will provide an audible chime based on the class II message received from the SDM if the driver's seat belt is not buckled when the ignition is turned to run or crank. The chime rate for this feature is 50 chimes per minute.
Park Brake Audible Chime
The BCM will provide an audible chime for park brake when the park brake is applied and the vehicle speed is higher that 3 mph. The chime rate for this feature is 200 chimes per minute.

You can't disconnect anything . The problem has to be fixed .

The BCM will provide an audible chime for park brake when the park brake is applied and the vehicle speed is higher that 3 mph. The chime rate for this feature is 200 chimes per minute.
Audible Warnings (Chime)
Chime Rate Per Minute
Key in the Ignition Audible Chime
150
Lights on Audible Chime
200
Occupant (Seat Belt) Restraint Audible Chime
50
Park Brake Audible Chime
200
Content Theft Pre-Alarm Audible Chime
200
Telltale Chimes
The body control module (BCM) will provide 4 chimes for each telltale activation per ignition cycle, at a rate of 150 or 200 chimes per minute. The chimes are limited to 1 chime event per telltale for each ignition cycle. The power up telltale function will not activate the telltale chime function. If the telltale becomes active during a cycle then the chime will sound.
The following telltales will activate the chime function:
• Low Washer Fluid
• Change Oil Soon Indicator
• Brake Fluid Low
• Oil Pressure Low
• Coolant Temperature Hot
• Low Coolant Level
• Low Fuel Level
• Antilock Brake System
• Volts Light (Generator)
• Supplemental Inflatable Restraint System (Air Bag)
• Trunk or Hatch Ajar

Having the vehicle checked for DTC'S - diagnostic trouble code's in the BCM would be the first step in the diagnostic procedure .
DTC B2965
When the ignition key is seated in the ignition switch, the key-in-ignition switch contacts the close, grounding circuit 80. The body control module (BCM) monitors the state of the key-in-ignition switch, the state of the ignition switch (OFF, ACC, or RUN) and the driver's door to control the key-in-ignition chime.

Nov 28, 2017 | 2002 Saturn L-Series

1 Answer

My door chime does not ding when the key is in the ignition and the door is open


Do the interior lights come on when door is open? If not, you need to check driver's door jamb switch. The driver's door control module could also be the problem. If the interior light do come on, then I would suspect the ignition switch.
You haven't changed out the radio recently? All chimes go thru the radio.

Sep 05, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

My Chevy Venture 2003 door chime on drivers side chimes without key in ignition with door open. Before this happened my dash lights acted funny and then went out. When I shut off the van and opened the...


Sometimes the ignition key does not "deactivate" when removing the key...try wiggling the washer behind where the key goes...sometimes this sticks...:)

Dec 08, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

I am in the Army and away from home attending a course and my wife calls me to inform me that a steady warning chime is going off inside the truck. When I asked to hear the chime it sounds to me like it...


The headlight switch turns on the courtesy light when twisted. Tell her to make sure that the headlight switch is twisted off the indent. If this isn't it, it may be the body control module.

26fe158.gif

Oct 20, 2010 | 2001 Chevrolet Blazer

1 Answer

93 chevy g20 van interior lights not working


Auto Zone, Discount Auto, Pep Boys

Sep 16, 2009 | Cars & Trucks

2 Answers

Keyless entry


watch this video if the video dosent work go to www.vehix411.com to see the video " />

Dec 03, 2008 | 2000 Chevrolet Venture

1 Answer

1997 venture keyless remote programming


SYSTEM OPERATION

System warning lamp located on top of the instrument panel
Press UNLOCK button once , turns on interior lamps and deactivates alarm (if fitted)
Press UNLOCK button twice w/in 5 seconds unlocks all doors, turns on interior lamp and deactivates alarm (if fitted)
To activate alarm system (if fitted):
Switch ignition OFF
Open driver's door
Press Lock button on remote
Close Driver door
warning lamp will flash when system is activated
Press remote power sliding door button will open sliding door (if fitted) only if unlocked first
Pressing remote panic button:
*Sounds horn intermittently
*Flashes exterior lamps
*Turns on interior lamps
**Pressing panic for the second time OR switching ignition ON deactivates alarm.


PROGRAMMING
Remobe key from ignition switch
Remove the "BCM PRGRM" fuse, from the fuse box
Close all doors
Turn ignition switch to the ACC position
With in 1 SECOND , turn the ignition switch to OFF then back to 'ACC'
(really, with in one second)
Open and close the driver's door. A chime will sound, indicating programming mode activated
Press and HOLD LOCK and UNLOCK SIMULTANEOUSLY untill a chime sounds 2 times ( about 15 seconds)
Repeat this exact procedure for all remotes to be programmed
Remove key from ignition
Refit 'BCM PRGRM' fuse.

4 REMOTES MAXIMUM CAN BE PROGRAMMED

Aug 24, 2008 | 2000 Chevrolet Venture

Not finding what you are looking for?
2002 Chevrolet S-10 Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...