Question about 2006 Jeep Wrangler

Open Question

How to replace the fan resistor on a 2006 jeep wrangler

How do you replace the heater fan resistor on a 2006 jeep wrangler

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 82 Answers

SOURCE: 2006 Jeep Wrangler heater fan only works on high speed

It is located on the passenger side , usually behing the glove box. This part can be bought in the aftermarket like pep boys or autozone fairly cheap. real simple to replace. First locate it, unplug it, pull it out, replace with new one, plug it in, replace the glove box. Then you are done.

Posted on Jan 12, 2009

  • 323 Answers

SOURCE: 2006 jeep wrangler check engine light came on it

There is a software update for the PCM that addresses this issue. TSB 18-028-06

Posted on Jun 08, 2009

  • 2 Answers

SOURCE: 95 Jeep Wrangler. Heater fan won't blow air.

qss

Posted on Jan 10, 2010

  • 3640 Answers

SOURCE: how to replace 2006 Jeep Grand Cherokee fan Heater

the blower motor is under panel near glove box. remove connector then the 3 mounting screws that hold it in. if changing the motor, use old fan cage from blower to new one, remove retainer clip to take off of motor shaft. CARL,

Posted on Jan 20, 2010

  • 645 Answers

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Posted on Feb 13, 2010

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hevac fan motor works only on high, replaced switch panel and resistor only worked then resistor burned out


The winding in the motor may have a short. drawing too much current when trying to run on a lower speed.

Jan 23, 2014 | 2006 Jeep Wrangler

1 Answer

2005 Jeep Wrangler Heater and Cigarette Lighters won't work


seriously I would be making a jumper wire to the battery for the blower .. power it directly..as long as you put a fuse in the line..and an on-off switch..

Jan 03, 2014 | 2005 Volkswagen Jetta

1 Answer

2005 Jeep Wrangler Heater and Cigarette Lighters not working.


May help - fuses supply power but also needed is earth return to battery. This is usually black wires running from device to the car metal. To diagnose you need a multimeter. Check body of cigar lighter is connected to the chasis with meter on ohms. (continuity test) good is zero ohms. If earth problem, check under dash to ensure all earth wires connect to metal chassis. Then with ignition on, check centre pin at back inside cigar lighter has 12 volts to side.
If not then check fuse has 12 volt to it, Now you can get to the fan, repeat all the tests on fan. Best wishes, its tedious work.

Jan 03, 2014 | 2005 Jeep Wrangler

1 Answer

2006 Jeep Wrangler Sport - blower won't turn on. What is the problem?


Check the fuses or the blower resistor that should be located on the passengers side under the glove box near or on the fan housing.

Jun 07, 2011 | 2006 Jeep Wrangler

2 Answers

I have a 2006 erangler X And the heater fan control low speed does't work. I dont know where the resisters are. Need help!


They are near the blower motor as the air is used to cool the resister, usually on the bottom of the blower housing.

Mar 30, 2010 | 2006 Jeep Wrangler

2 Answers

2001 Jeep Wrangler heater blower stopped working


Yes I would go with the switch, BUT, does it have a resistor bank? That is, how does it reduce the speed? Many systems use resistors to lower the speed. Burnt or bad connections can cause this as well.
You can test the blower motor by connecting direct power from a source like the cigarette lighter if you are handy.
Most of the time the lower speeds konk out but the high speed continues to work this is the resistor bank that goes out.

Mar 25, 2010 | 2001 Jeep Wrangler

2 Answers

I have a 1999 Jeep Wrangler and the heater fan stopped working for all the fan speeds. The fuses are fine. How do you know if it is the blower resistor or the blower motor?


If you bypass the resistor pack and connect the motor directly to the fused 12v supply then the fan should run at maximum speed. If so, it's the resistor pack that's blown: a very common fault on a huge number of makes and models.

Feb 13, 2010 | 1999 Jeep Wrangler

2 Answers

2006 Jeep Wrangler heater fan only works on high speed. I have heard this is due to a resistor. Where is it located and is this a factory part only ?


It is located on the passenger side , usually behing the glove box. This part can be bought in the aftermarket like pep boys or autozone fairly cheap. real simple to replace. First locate it, unplug it, pull it out, replace with new one, plug it in, replace the glove box. Then you are done.

Jan 12, 2009 | 2006 Jeep Wrangler

1 Answer

Blower quit working


check fuse first, every jeep ive had had the same problem ,its the fan speed resistor,most are located on the heater core /fan housing.NAPA 25.00 PLUS SHIPPING.

Dec 13, 2008 | 2006 Jeep Wrangler

Not finding what you are looking for?
2006 Jeep Wrangler Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...