Question about 1995 Ford Taurus

2 Answers

Location of the oxygen sensor

Could you tell me where the oxygen sensor is located on 3.8 v-6 motor 1995 Ford Taurus. Also will I need to put my car on a lift in order to replace it?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 52 Answers

Yes, you will have to lift your car to get at the O2 sensors (which are on the exhaust pipe, and there should be more than one) but you don't necessarily need a lift.
Good luck!

Posted on Jan 04, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

There are two O2 sensors on this engine. Both are mounted in the exhaust just past the exhaust manifolds. You will be able to replace them without a lift. You will probably need an O2 socket to remove them. They usually are in pretty tight.

Posted on Jan 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Find oxygen sensor location on 2000 Ford Taurus v6 3.0


there are four of them. Two up front, under the hood, you can look down by the radiator and see them. One before the catalytic converter one after. The other two are under the engine on the back side of it. You'll have to raise the car to access them. Same as front, one before and one after.

Oct 12, 2014 | 2000 Ford Taurus

1 Answer

I need the location for a bank 1 sensor 1 oxygen sensor in a 19999 ford taurus


Bank 1 is the side nearest to the firewall and sensor 1 is pre-catalytic converter. It should be located on the exhaust pipe after the exhaust manifold and before the catalytic converter. Follow the exhaust pipe.

Dec 12, 2013 | 1999 Ford Taurus

1 Answer

See a visual diagram of heat oxygen sensor bank 1 sensor 2 for ford taurus 2001


bank 1 exhaust is the rear manifold towards the windshield side. Follow the exhaust down. There should be one oxygen sensor before the catalytic converter and a monitor after the catalytic converter. Be Careful.. they look the same.

Nov 26, 2012 | 2001 Ford Taurus

1 Answer

02 ford taurus crankshaft position sensor location


Its located in the front of the engine mounted to the timing cover near the crankshaft pulley.

Oct 29, 2012 | 2002 Ford Taurus

1 Answer

Location of the heated oxygen sensor on a 98 taurus


there are two O2's and they are under the car in the exhaust pipes just off the engine exhaust manifolds and before the catalytic converters.

Oct 28, 2010 | 1998 Ford Taurus

1 Answer

I need to know the location of the oxygen sensors and related sensors in the line of 1999 ford taurus3.0 engine


On you engine there are 4 Oxygen sensors. 2 Pre cat sensors( upstream) and 2 post sensors (down stream). There are 1 pre and 1 post sensors for each side of the engine. If further assistance is needed, please leave me a message here. Craig

Mar 07, 2010 | 1999 Ford Taurus

1 Answer

Finding access to front corner lamp base location to


u do this from under the car between the fender and the wheel well liner

Oct 04, 2009 | 1995 Ford Taurus

1 Answer

The location of a oxegen sensor for a ford taurus


Not familiar with your car, but all cars have 3 or 4 of them, older cars maybe 2. Located on exhaust manifolds, in the exhaust piping. Which O2 do you need?

Jul 04, 2009 | 1999 Ford Taurus

1 Answer

2002 taurus SEL-5 engine codes to go with light and problems


Cylinders 2, 3 have coil packs change out located on back of motor. you will have to take the upper intake off to get to them. Very easy to do. #2 center plug on back of motor #3 is on drivers side of motor. Crank sensor you will have to remove tire on car passenager side next look at crank pulley on left side of block you will se two wires the heat cover running to it.
Change these first it might correct the O2 sensor problem.

Jun 15, 2009 | 2002 Ford Taurus

1 Answer

Oxygen Sensors 1995 Ford Taurus


Replace them Both. There is no way to tell which one is sending the Codes.

Jan 04, 2009 | 1995 Ford Taurus

Not finding what you are looking for?
1995 Ford Taurus Logo

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...