Question about Nissan Cars & Trucks

Open Question

2004 nissan quest brake and battery light stays on and car wont start

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
gforce3s
  • 31 Answers

SOURCE: brake and battery lights stay on

when both lights stay on with the car running it usually indicates an alternator that is not charging at an acceptable voltage level. check the battery voltage with the car running, if it is under 13.5V you should replace your alternator.

Posted on Dec 12, 2008

Ad
  • 4369 Answers

SOURCE: 1999 nissan quest brake pad replacement

Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.

Posted on Jan 21, 2009

  • 139 Answers

SOURCE: dashboard warning brake light stays on continuosly nissan altima

Try this, Since you are applying the hand brake. Manually pull up on the emergency pedal and see if the light goes out. If this does work then you could have one of several problems. but, I am thinking that you might be able to adjust the brake tensioner if this car has one.

Posted on Jul 05, 2009

dsacco86
  • 1077 Answers

SOURCE: service engine soon, TCS off, SLIP

The oil change wouldn't cause this problem. Just in-case, check the engine oil level.

There are many emission sensors in the car that will make the engine light come ON. Best way to find out what's going on is to have an auto-parts store hook up a engine code reader and tell you what the code means. Most auto-part store will do this for free.

Posted on Oct 11, 2009

Testimonial: "very helpful. i have the mechanic checked the car , the sensor says it has a malfunction in P0340"

  • 454 Answers

SOURCE: My brake, slip and VDC indicators stay on.

Check brake fluid level, add fluid from sealed container if needed.

Also check for leaking rear axle seals. Look for oil on the inside of rear wheels.

Posted on May 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 Nissan quest vdc off battery and brake lights all on and no power


You need t have the system scanned for fault codes. This is the first step to understanding what the problem is.

Jun 30, 2016 | Nissan Cars & Trucks

1 Answer

Stay running after starting


Try cleaning the throttle body
CRC Throttle Body Cleaner
Instructions on the can

Jul 21, 2013 | 2004 Nissan Quest

1 Answer

I have a 2004 nisan quest the service eng. light is on and the trans. acts like it is starting out in 4th gear. I pulled out the ecm fuse for a couple min. and now the trans. shifts fine but the egn. light...


the engine light wont shut off by itself u have to have it cleared with a scanner or disconnect the negative battery cable.. if it still stays on then u have a hard code and a problem with the vehicle.....

Jul 06, 2012 | Nissan Quest Cars & Trucks

1 Answer

3.5s v6 2004 nissan quest. brake lights not working.Already check fuse. kish.


First, replace bulbs and then check brake light switch, which is located near the top of the brake pedal. Use a voltimeter or test light to verify that there's voltage at the switch connector. It's not bad idea to replace brake light switch. Also make sure the brake pedal is correctly adjusted.

Aug 10, 2010 | 2004 Nissan Quest

3 Answers

My 2004 nissan quest has awful Brake judder even after new rotors and pads. Went with after mkt set up and still same problem.


is your abs light on could be abs problems or you could have air pockets in brake line may need to bleed brakes

Feb 17, 2009 | 2004 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...