Question about 1998 Ford Expedition

Open Question

How do u install a heater coil in a 1998 ford expiditon

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
blueextc3221
  • 15935 Answers

SOURCE: 1998 ford expedition heater coil repair

Big Pain - Must remove entire dashboard. Drain the coolant Remove the Freakin' pain in the arse dash Open up the box that house the A/C system core and the Heater core Remove and inspect the blend door for cracks where it attaches to the actuator Check the blend door actuator then cut the metal lines on the top of the heater core off for easy removal From the engine compartment pull the heater core lines through the firewall for easy disconnect and that is it You are now ready to start the re-install process. One thing I recommend is while you have everything apart change the blend door actuator, especially if you see traces of where the coolant was leaking in the box. 9 out of 10 times the coolant leaked out through the actuator and it is just a matter of time before the electrical circuitry in the actuator quits working leaving you with no heat or only heat. When I replaced mine it was still working, but the electrical motor with the spiral gear was making a funny noise compared to the new one. Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Posted on Mar 26, 2009

Ad
duane_wong
  • 6826 Answers

SOURCE: put fual pump in will not start were is the reset button

Inertia Fuel Shutoff (IFS) Switch Removal & Installation There is no 6.4L engine, it's a 5.4L engine, right?

Also, for the To Remove:

  1. Disconnect negative battery cable.
  2. Remove right rear interior trim panel. ford-05-00-3949.gif

  3. Disconnect IFS switch connector.
  4. Remove IFS switch bolts.
  5. Remove IFS switch.
To Install:
  1. Install IFS switch.
  2. Install IFS switch bolts.
  3. Connect IFS switch connector.
  4. Install left rear interior trim panel.
  5. Connect negative battery cable.
prev.gif next.gif

Posted on Jul 08, 2010

jasmoy89
  • 91 Answers

SOURCE: need firing order for a 1998 ford expiditon

4.6 liter & 5.4 liter are both: 1-3-7-2-6-5-4-8

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat in car


Check low antifreeze level--- Replace thermostat-- heater coil plugged, check for flow through heater coil, heater coil outside plugged no air flow replace air filter in dash and clean outside of heater coil if you have very low air movement to defrosters--- try this last thing first --- cheapest things first ,

Oct 08, 2012 | 1998 Ford Taurus

1 Answer

I have a 99 5.4 expiditon.had heater coil put on . when i pull my boat9pontoon0 it wants to over heat no other time.is there such a thing as a weak t/stat or should i flush out the radioator it has over...


if the radiator has never been flushed i would definatly flush it as well as change the thermostat. Radiator flush is cheap and a thermostat shouldnt be more than $15. is your cooling fan working?

Jun 24, 2011 | 1999 Ford Expedition

1 Answer

I need to install heater hoses driping on #4 coil


If you're saying it's dripping on the number 4 coil on the heater core the the core will need to be replaced as that's cheaper than repairing the core.

Mar 03, 2011 | 1998 Ford Expedition

1 Answer

Need firing order for a 1998 ford expiditon


4.6 liter & 5.4 liter are both: 1-3-7-2-6-5-4-8

Aug 04, 2010 | 2000 Ford Expedition

1 Answer

Put fual pump in will not start were is the reset button


Inertia Fuel Shutoff (IFS) Switch Removal & Installation There is no 6.4L engine, it's a 5.4L engine, right?

Also, for the To Remove:
  1. Disconnect negative battery cable.
  2. Remove right rear interior trim panel. ford-05-00-3949.gif

  3. Disconnect IFS switch connector.
  4. Remove IFS switch bolts.
  5. Remove IFS switch.
To Install:
  1. Install IFS switch.
  2. Install IFS switch bolts.
  3. Connect IFS switch connector.
  4. Install left rear interior trim panel.
  5. Connect negative battery cable.
prev.gif next.gif

Jul 08, 2010 | 2000 Ford Expedition

2 Answers

1998 ford expedition heater coil repair


Big Pain - Must remove entire dashboard. Drain the coolant Remove the Freakin' pain in the arse dash Open up the box that house the A/C system core and the Heater core Remove and inspect the blend door for cracks where it attaches to the actuator Check the blend door actuator then cut the metal lines on the top of the heater core off for easy removal From the engine compartment pull the heater core lines through the firewall for easy disconnect and that is it You are now ready to start the re-install process. One thing I recommend is while you have everything apart change the blend door actuator, especially if you see traces of where the coolant was leaking in the box. 9 out of 10 times the coolant leaked out through the actuator and it is just a matter of time before the electrical circuitry in the actuator quits working leaving you with no heat or only heat. When I replaced mine it was still working, but the electrical motor with the spiral gear was making a funny noise compared to the new one. Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Mar 26, 2009 | 1998 Ford Expedition

2 Answers

Heater not working in ford escort


Hi Roger,

This is prashant from india. well i am mostly into cars especially ford escort. the problem that you have seems to be with the heater coil, if the compressor and blower is working fine then definitely its the problem with the heating coil. Might be wiring issue or the coil might have gone bad. so you may need to replace.

Prahant Dwivedi

have a nice day!

Jan 05, 2009 | 1998 Ford Escort

Not finding what you are looking for?
1998 Ford Expedition Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...