SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location
the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.
SOURCE: location of fuses and relays for the rear window defroster
two locations, one under dash and one under hood. without your manual, thats about all I can help you with
SOURCE: pcv valve :where is it located on a 1999 ford explorer sport 2wd
It is located at the back of the engine near the fire wall. It is gray with a T connector at the top with two hoses coming off of the T and going forward into the intake manifold.
SOURCE: 1999 ford explorer sport ac
CHECK THE CLUTCH CYCLE SWITCH.ALSO CALLED THE HI PRESSURE SWITCH IT IS LOCATED ON THE RECEIVER DRYER. YOU WILL FIND IT ON THE PASSENGER SIDE NEAR THE FIREWALL. THE A/C LINES RUN TO IT. IT IS A CYLINDER TYPE CANISTER. THE SWITCH HAS A 2 WIRE PLUG PULL THE PLUG OFF THE SWITCH AND JUMP IT WITH A PAPER CLIP OR PIECE OF WIRE. IT WILL FOOL THE SYSTEM INTO THINKING THE SWITCH IS GOOD THE TRY THE A/C IF IT KICKS ON REPLACE THE SWITCH.THOSE ARE COMMON PROBLEMS AND CHEAP AND EASY TO FIX..
SOURCE: where is flasher located 1999 ford explorer
turn on hazard lights and listen for click and follow noise, there will be 2 flashers in this area. the 1 not clicking is the turn signal flasher.
32 views
Usually answered in minutes!
well the truck has a remote car starter that wasnt working until a minute ago and i was looking to find out where it would be located
No Explorer came with remote start in this year, so this is not a factory system. I have no info on aftermarket stuff
×