Question about 2006 Buick LaCrosse

Open Question

When I make a right turn my 06' Buick LaCrosse makes a grinding noise

When I'm making a right turn..

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 39 Answers

SOURCE: 1997 Buick LeSabre has squeak noise coming from right front.

More likely this is a wheel bearing or CV joint than suspension components.

One good indication is if, when your making a right turn or accelerating, there is a shudder or shaking in the steering wheel then its likely a wheel bearing.

Another good indicator can be found when you jack up the suspicious wheel. Put one hand on the top of the wheel and one on the bottom and pull back and forth. If the wheel makes a clunking noise and moves in either direction, then wheel bearing is shot.

Posted on Aug 13, 2009

  • 6 Answers

SOURCE: My 2005 Buick LaCrosse makes a whiny noise

I am guessing the steering rack is starting to go bad. That is quite expensive to fix. The whining noise is the rack sucking air due to the steering fluid has leaked out. You can check your power steering fluid level and add some with stop leak to see if that helps. The filler cap is at the rear of the engine on the passenger side and is quite hard to get to. Be sure to not reach down to remove the cap unless the engine is cool. There is a high risk of burning yourself on the exhaust manifold.

Posted on Oct 26, 2009

  • 2007 Answers

SOURCE: my 1994 Buick Regal makes loud roaring noise on freeway

Jack it up , and see which one wiggles. It could also be your CV joints are shot.

Posted on Mar 09, 2010

  • 86 Answers

SOURCE: heater or air conditioner is making a grinding noise

change blower motor you probably have something in there messing up the cylinder for the blower

Posted on Apr 01, 2010

  • 1 Answer

SOURCE: When I make a sharp left turn at 20 mph or so

mine has this same problem. did you figure out why?

Posted on Apr 20, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2011 Lacrosse makes a ticking sound under the hood

That noise is most likely the valve lifters, some noise is normal on these GM engines, if it is really noisy that is a problem. Do you use the correct grade of oil and change at least every 6,000 miles.

Jan 14, 2017 | 2011 Buick LaCrosse

1 Answer

My right turn signal isn't working correctly. When I'm driving down the road my dashboard indicator for my right turn signal will turn solid green but wont flash, But when i turn my...

I had the same problem on a 92 & 95 Dakota years ago, replaced the turn signal switch in the column & found a loose ground wire in the harness back by the tail lights. Never had a problem again. If you're gonna try to replace the switch you will need tamper proof torques bits just FYI. Good luck. Let us know how it turns out.

Nov 07, 2012 | 1995 Dodge Dakota

1 Answer

Uneven tire wear on passenger side--front & back. Inner tread worn more than outer.

you'll need an alignment to determine if their is any parts failure

Sep 17, 2012 | 2011 Hyundai Equus

1 Answer

Steering wheel is hard to turn to the right

Worn Strut Bearing Plates, on top of struts

Could also be a Rack & Pinion Steering Gear
worn & close to needing replacement

Don't think that you only have one or either
issue,diagnose & repair one area at a time,
& then see if the issues correct themselves

I believe you have time & mileage that has brought about
strut brg,possible complete lack of steering fluid changes
every 3 years,possible lower ball joints worn,all adding a
small piece to the problem.

No big deal,just normal wear & doubtful a repair shop
or dealer will get it right the first couple tries.

Also worn parts & lack of or improper wheel alignment
could also be an issue.
Don't just have it aligned at some chain store place &
think your going to solve anything

Aug 28, 2012 | 2003 Cadillac Deville

1 Answer

The left rear wheel on my 2005 Buick Lacrosse is not parallel to the right rear wheel. I would greatly appreciate any suggestions about this problem. Thank you in advance for having read my message!

Hi Michael, make sure the vehicle has not been involved in an accident. If the vehicle is sound have the suspension bushes inspected and the rear mountings checked. If there is a drumming noise from the rear it will most likely be from worn bushings. Regards John

Jul 21, 2012 | 2005 Buick LaCrosse

1 Answer

I hear a loud grinding noise when i drive my car

Check front tyres & wheel bearings espesially the R/H/F. Feel tyre for high / low spots on inside & jack up & spin wheel if you get noise while jacked up it is not the tyres but wheel bearing or brake pads but more than likly a crook bearing by the sound of it. It needs to be tended to ASAP

Jun 28, 2012 | 2004 Volkswagen Passat

1 Answer

99 Firebird turn signal/parking light short.

So, you say that a 1600 Watt amp doesn't make your ammeter move, that is 120Amps, but your indicator lamp does ... something not right here.

Jun 04, 2017 | 1999 Pontiac Firebird

Not finding what you are looking for?
2006 Buick LaCrosse Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides