Question about Toyota Cars & Trucks

Open Question

Where is the fuel pressure relief valve on a 95 tacoma

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 475 Answers


If cleaning the engine does not work, replace the oil press. sending unit. These senders on Jeeps have had a history of problems where they will work one day and not the next day.

Posted on Jan 27, 2009

  • 30 Answers

SOURCE: i cant find my fuel rail pressure relief valve.

I just did a tune up on a 1995 SL2. The valve is on the fuel filter assembly. Facing the car, on the right side, the fuel filter is attached to the frame. Follow the line out of it, and there should be a cap. Unscrew the cap, and push the schrader valve in. Pressure released.

Posted on Jul 02, 2009

  • 1 Answer

SOURCE: A/C builds up too much pressure and pops off high pressure relief

I have a 93 f150 my ac bulds up to much pressir and pops off the relefe valve ive replaced every thing any sugestions?

Posted on Sep 07, 2009

  • 4088 Answers

SOURCE: is there pressure relief valve on fuel system when

Look for a tire-valve-looking pressure test port located on the fuel rail located over the injectors. Pressing the inner pin releases the pressure along with fuel--catch it in a clean can. You can also remove the fuel pump fuse, then start the engine and run it until it stops.

Posted on Sep 07, 2009

  • 104 Answers

SOURCE: looking for oil pressure relief valve on my 95 cabrio

The oil pressure relief valve should be on the oil pump.If your oil pressure is ok,have the wiring tested to theswitches or try another set of clocks

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 95 Toyota Tacoma 4x4 and It will not start without putting some fuel into the throttle body. Once started it will run. But when you let it stand and cool off it won t start again. I have replaced...

The way you describe this problem the cause seems to be in the fuel system losing pressure. But even then, if you crank long enough it should start. Check your fuel pressure. It may be useful to check your fuel filter.

Mar 18, 2015 | 1995 Toyota Tacoma

1 Answer

2.2 ltr toyota camry has bad vibration at idle but runs smoothly under load

I am chasing this problem also in my 94 Camry. I am investigating

- vacuum leak somewhere in the intake manifolding or hose
- EGR valve malfunction
- IAC valve malfunction
- deteriorated spark plug leads
- head gasket leak
- fuel pressure low from pump
- malfunctioning fuel pressure return or relief valve

Aug 13, 2014 | 1995 Toyota Camry

2 Answers

Fuel tank pressure relief valve

You have some otyher issue here besides the pressure problem.

Jun 22, 2013 | 1995 Geo Prizm

1 Answer

Where is the fuel rail pressure relief valve located in a 91 buick skylark

it is on the fuel rail just next to the alternator

Jan 25, 2013 | Cars & Trucks

1 Answer

1999 Pontiac Grand Prix Turns over but will not start. Zero pressure at fuel pressure relief valve

That would be the pressure regualtor. You have a defective fuel pump is my guess.

Aug 31, 2012 | 1999 Pontiac Grand Prix

1 Answer

I need to know which fuse controls the fuel pressure relief valve.

fuel pressure relief valve is not controlled by a fuse its controlled by spring pressure against a diaphram that is set to a specific pressure to control fuel pressure.

Apr 19, 2011 | 1991 Pontiac Sunbird

1 Answer

Looking for shut off swicth for 1993 mercury topaz for fuel pump

Fuel Injected Engines

If the vehicle is equipped with a pressure relief valve, install an EFI/CFI fuel pressure gauge T80L9974B or equivalent and depressurize the fuel system. If the vehicle is not equipped with a pressure relief valve, the fuel filter connection should be covered with a shop rag or towel to prevent the fuel from spraying during the removal procedure. It is also possible to reduce the amount of pressure in the fuel system by locating the inertia switch (usually located in the luggage compartment) and disconnecting the electrical connection on the inertia switch. Next crank the engine for 15 seconds to reduce the system pressure

Nov 01, 2010 | 1993 Mercury Topaz

2 Answers

95' Honda Civic 1.6 liter, will crank but wont stay running. Distributer, rotar, wires and plugs, fuel Filter and fuel pump have been replaced. We have been able to get the car running on occassions after...

i have a 95 honda civic and it will crank but not start, ive heard they have a common fuel pump relay problem so i bought a new 1 and also a new fuel pump but yet still the car will not start. we i turn the key the fuel pump does not engage and am stumped. ive checked all the fuses but there all good. any ideas please help . thanks

Oct 28, 2010 | 1995 Honda Civic

1 Answer

I need to change my fuel filter on my '95 GMC sierra 1500, is there a relief valve to let pressure off the line?

There is a schrader valve on the fuel line on the engine for attaching a fuel gauge to monitor the fuel pump for testing purposes, and it should have a cap on the valve similar to a valve stem cap on a tire. (relieving the fuel pressure is similar to letting the air out of a tire and watch out for any fuel spray) or you can loosen up a line fitting at the fuel filter until the pressure bleeds off then replace the fuel filter, and you might want to have a pan to catch the fuel in, and be very certain that there is no ignition source anywhere near the vehicle.

Aug 17, 2010 | 1995 GMC Sierra C1500

1 Answer

Looking for oil pressure relief valve on my 95 cabrio

The oil pressure relief valve should be on the oil pump.If your oil pressure is ok,have the wiring tested to theswitches or try another set of clocks

Sep 01, 2009 | 1997 Volkswagen Eurovan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides