- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The Crank shift sensor is located in front of the motor in between the intake manifold and oil filter housing, nest to the knock sensor. Look on side cylinder block beside starter.you have to remove the starter to remove the crankshaft sensor.
Hope this helps.
Thanks for choosing Fixya,
on a 2-2 remove starter motor. disconnect sensor wiring,remove crankshaft mounting bolt and take out crank sensor. the sensor is located by the oil filter. as for the camshaft sensor, (the 2-2 is not equipped with a camshaft sensor)
1990 Chevrolet Cavalier 2.2L TBI 4cyl The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
The camshaft position sensor is located on the timing cover, near the top of the motor. The crankshaft position sensor is located on the same timing cover near the crankshaft. Just a side note, more than likely the crankshaft position is your issue and it's under a recall from Nissan and they will replace it for free.