Question about 2000 Toyota Avalon

Open Question

Rear rotor removal toyota avalon 2000 - 2000 Toyota Avalon

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: I need to remove the

Pull up on the lower front edge to dislodge the seat from the clamps that holds the seat to the floor. Pull hard, if the seat has never been removed. the clamps will be tight. Once the seat bottom is out, you will be able to see the bolts that holds the rear seat backs onto the body.

Posted on Nov 12, 2008

  • 76 Answers

SOURCE: Replacing 2000 toyota avalon fog light bulb

o easy enough just jack frontcar up use jackstand for safety now loo up under the bumper where fog lights sit depending on style fog light u might need to pull the whole assembly out or just twist the bulb not a hard task once u see it from underneath it is pretty easy

Posted on Dec 02, 2008

  • 101 Answers

SOURCE: Trying to remove and replace rear brake rotors

First, make sure your parking brake is off.
Remove the rear caliper and then the brake pad housing. In the center hub of the rotor the parking brake shoes are located. The may need to be loosen first. There is a hole between 2 of the studs you need to align at the bottom. Look in the hole with a flashlight and find the star wheel. Use a screw driver to turn the wheel up a few turns to loosen the parking brake shoes from the rotor hub.
After that there are 2 threaded holes in the rotor near the studs you put two 8mm bolts in and slowly tighten each and it will pull the rotor off the hub. They rust up pretty bad so use penetrating oil on them.

Posted on Apr 11, 2009

  • 1 Answer

SOURCE: I need to replace the rear struts on my 2000

remove the rear seat.
(pull up on the front of the rear seat to remove)

Posted on May 21, 2009

  • 185 Answers

SOURCE: how to remove rear struts from a avalon toyota

yes you will have to remove the rear seat. the bottom of the seat pulls straight up and out. the back of the seat has twelve mm bolts holding it at the bottom. once those are removed you lift straight up and out, its hooked at top.

Posted on Oct 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Avalon, all of the speakers (except the subwoofer) work, I noticed there is no bass and then found out the subwoofer makes no sound, does anyone know what might be the problem?


Toyota Avalon JBL Speaker Subwoofer Foam Repair 86160 ...

? 18:34
https://www.youtube.com/watch?v=vDHEbiyBt9I
Jul 16, 2012 - Uploaded by Simply Speakers
Toyota Avalon JBL Speaker Subwoofer Foam Repair 86160-AC180 .... Luckily you don't have to remove the rear deck to get at the subwoofer, ...

Removing rear subwoofer / rear deck - Toyota Nation Forum : Toy



Nov 19, 2015 | 2004 Toyota Avalon XLS

1 Answer

How to chang front rotors on 2000 Toyota Avalon


should be as simple as remove the wheel, remove brake caliper, remove rotor. some rotors and I believe Toyota is one of them have machined threaded holes in the rotor where you can thread a bolt to sort of press the rotor off the hub. however there are some rotors that are part of the hub. I don't believe I have run into one on a light duty front wheel drive vehicle but none the less common sense would tell you to use caution when removing the rotor and not cause damage to parts but over exerting force to remove. re assembly is reverse of disassembly. when putting on new rotors I always use a sanding disc or some emery cloth to put a swirl pattern on the rotor surface and scuff the new pads. speaking of pads in order to replace the pads you may need to have a special tool to press and rotate the caliper piston back into the caliper (thanks Toyota). I believe it is easy to find at auto parts store. hope I have provided some help to you.

Jul 17, 2014 | Cars & Trucks

1 Answer

2000 toyota avalon new disc thickness


New they should be;
Nominal Thickness ( mm ) 28 (27.94)
Discard when;
Nominal Thickness ( mm ) 26

Mar 09, 2014 | 2000 Toyota Avalon

1 Answer

Min thickness of front disc rotor


Perform this measurement in four areas of the rotor and make a note of each measurement taken. If the rotor is below 1.024 inches thick on the front or 0.413 inches on the rear, it must be replaced.

Mar 09, 2014 | 2000 Toyota Avalon

1 Answer

My 2002 Toyota Avalon is shaking when I apply the brakes. I have replaced the front and rear brake pads and the front rotors with Raybestos ones. It still shakes. Could the rear rotors be warped?


That's what I would imagine. It is usually the front rotors that warp due to the fact that they work a little harder than the rears. However, rear rotors can warp. If you feel the shake more in the body of the car, so in the seat and you feel like the whole car is moving and the steering wheel stays mostly calm then I would imagine the rear rotors are warped. However if the shaking is felt mostly in the brake pedal and the steering wheel shakes too then it is probably your front rotors. Shops can usually resurface rotors and it may be cheaper than buying new, so that could be an option for you.

Apr 08, 2011 | 2002 Toyota Avalon

1 Answer

How to reset hand brake toyota avalon 2005


you have to check the e-brake shoes. these shoes live inside the rear brake rotors. the shoes will either just need to be adjusted or possibly replaced if they cracked from the heat of driving w/ them engaged. sorry there's not a quick fix to this one

Sep 29, 2009 | 2002 Toyota Avalon

1 Answer

Need to access the rear struts - 2000 Toyota Avalon


remove tires and remove the cap over the tower in the trunk the bolts are accessible from this point on

Sep 07, 2009 | 2000 Toyota Avalon

1 Answer

I need to replace the rear struts on my 2000 toyota avalon. How to get to top strut mount?


remove the rear seat.
(pull up on the front of the rear seat to remove)

Apr 08, 2009 | 2000 Toyota Avalon

Not finding what you are looking for?
2000 Toyota Avalon Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...