Question about 1991 Chevrolet S-10

Open Question

Diagram of fuel sending unit chevy s10

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: How do you replace the brake lines for a 1996 Chevy S10 Blazer

You have the best diagram right on your car! follow the original lines to replace them. (you can change routing a little with no problems, just make sure they dont interfere with anything and that they are secure so they don't rub through and fail again!

Posted on Mar 14, 2009

Ad
  • 5 Answers

SOURCE: i need a 1987 chevy S10 vacuum hose routing diagram

Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.

Posted on Apr 09, 2009

wracefans24
  • 1985 Answers

SOURCE: need a wiring diagram for a chevy s10. brake

your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.

Posted on Nov 26, 2009

  • 540 Answers

SOURCE: I have 97 S10 4.3L my fuel gauge doesnt work.

just put a sending unit in it I have done tons of them...

Posted on Dec 07, 2009

Testimonial: "OK thanks! "

  • 1757 Answers

SOURCE: firing order for a 1999 chevy s10 pickup

I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?

For the 4.3L:
Firing Order:
1-6-5-4-3-2

Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)

Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Throttle housing diagram for 1996 Chevy S10. 4 cylinder pick up truck


Sorry I have the tech to send diagrams .
However I do have the factory manual for this engine .
Why don't you send some more information and likely I can solve your problem

Mar 14, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

Need a diagram to hook up wires for the fuel gauge on a 2000 s10


the purple wire is voltage, black wire is ground for sending unit. Both wires from fuel pump sending unit, go to vcm.

The vcm sends serial data message to instrument cluster to control fuel gage.

Nov 24, 2014 | Chevrolet Cars & Trucks

2 Answers

Can i replace the fuel pump in my chevy 2000 S10 blazer with one from 1985 S10 blazer?


no, they are different pressure. it has to come from one with central fuel injection, like maybe 94 and up. also, the sending units even then

Jun 09, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

Need diagram of fuel system for 1995 chevy s10


The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Dec 02, 2009 | 1995 Chevrolet S-10 CA Edition

5 Answers

Where is the oil sending unit located on a Chevy S10 Pickup.


MY S-10 IS LEAKING OIL. I WANT TO KNOW WHERE THE OIL SENDING UNIT IS.

May 29, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

'99 chevy caviler fires right up, but then dies after started, like out of gas. Fuel relay sensor? fuel filter? fuel pump?


If it is fuel injected it will get enough fuel to start but not stay running. I had the same problem with my S10. Turns out the hose that went on to the end of the fuel pump was roted. pull the sending unit and check the hose connections to the pump and the sending unit. If problem presists replace filter first the pump.

Jan 25, 2009 | 1999 Chevrolet Cavalier

Not finding what you are looking for?
1991 Chevrolet S-10 Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...