Question about 1993 GMC Sierra K1500

1 Answer

1990 gmc ihave all my lights butback rear driving lights is this the light switch

Posted by on

  • dementryjim
    dementryjim Nov 06, 2012

    1990 gmc all my lights work but the rear driving lights i turn my lights on i have no back lightss put a new switch in and bulbs cant get the rear lights on



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • GMC Expert
  • 211 Answers

All your lights and brake lights and turn signals go through the turn signal switch. It jobs is to divide the lights turn signals and brake lights. One can test if the lights are going into the switch and out through the same connector where the turn signal switch comes out of the column.

Posted on Jan 19, 2015


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1244 Answers

SOURCE: Dash lights flicker in a 2000 GMC Sierra

yep bad ground in the dash

Posted on Jan 14, 2010

  • 14585 Answers

SOURCE: 1996 GMC 1500, rear parking lights do not work,

There is a module on the frame near the back, passenger side.

Posted on Jan 22, 2011

  • 90 Answers

SOURCE: Where is the brake lights switch on 1999 GMC suburban?

brake pedal arm

Posted on Sep 03, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers


keep going if those didnt fix need to check harness for short or damage

May 27, 2018 | GMC Cars & Trucks

1 Answer

1990 GMC suburban actuator and fuse location. There is not one on front differential and no place for fuse in fuse block. 4 wheel will not engage. No owners manual

The actuator will not be on the front differential or drive line, it will be on the transfer case, which is mounted behind the transmission. Follow the front drive shaft back from the front differential, and the component at the rear of the driveshaft is the transfer case. That is where four wheel drive is engaged/disengaged.
I'm not familiar with your vehicle, but if you have a separate lever to engage 4wd, there will not be a fuse for the actuator - it is a manual system. If the 4wd is selected electrically, check that all wiring and connectors on the transfer case are in good condition.

Sep 25, 2016 | 1990 GMC Suburban

1 Answer

Why are my rear lights are not working on my 93 GMC Suburban? All other lights work. I am unable to drive at night as I can only be seen if I apply the brakes. Which is the fuse for these lights or w

If front running lights work, I would crawl under rear and find light wires and use a test lamp to find the hot wire with only running lights on, then trace that wire to find the break. If front running lights are not working, check all fuses, then check headlamp switch.

Jan 13, 2015 | 1993 GMC Suburban

1 Answer

2003 gmc envoy rear lights won't turn off

As for the brake lights i would think that the brake light switch is faulty.As for the parking lights i think that the parking light relay is sticking.Switch the relay with another one in the fuse panel with the same part number to see if thats the problem or not.

Jun 05, 2012 | 2003 GMC Envoy

1 Answer

1990 GMC 350 engine stops while idling at light. Replaced distributor cap,rotor, spark plugs and cables, new battery. and air filter. Engine is running without missing and no hessitation. Starts strong...

The Idle Air Control runs idle speed, it may be stuck or just bad. its located at the left rear corner of the throttle body, make sure its plugged in.

Dec 06, 2010 | 1990 GMC Sierra

1 Answer

I have a 1994 GMC Yukon and the park lights do not work so now I have no rear lights when driving at night

it sounds like the contact that turns your parking lights on has gone bad. the contact is located in the light switch. so, you probably need a new light switch. make sure you check your fuses first before you replace the light switch. good luck.

Sep 20, 2010 | 1994 GMC Yukon

2 Answers

1990 mark v11, both the dash and tail lights out? fuse replaced.

may be the switch, these dash mounted head light switch had problem with the electrical connector burning.

Mar 07, 2010 | 1990 Lincoln Mark VII

1 Answer

Have a mazda eunos year 1990. switch for fog light lights up when switched on ...cant find fog light on rear? which bulb is for fog light please!

Many MX5 owners convert the extra brake light on the boot lid to a fog light. Has this been done to yours?

Jun 15, 2009 | 1990 Mazda MX-5

1 Answer

1990 GMC Suburban Wiring Problem

Have a Surban that did the same thing .. problem was the wiring harness for a trailor if your vehicle is equiped with it.

Sep 17, 2008 | 1990 GMC Suburban

Not finding what you are looking for?

Open Questions:

See all 1993 GMC Sierra K1500 Questions

Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides