SOURCE: trans in limp mode with codes P0700, P0733 and P0734
1998 dodge caravan code P0700-Transmission Control System (Malfunction Indicator Lamp Request) How do I fix this?
SOURCE: My van is not shifting
734 is "Gear 4 Ratio Incorrect
the acumulator inside the tranny is bad
SOURCE: p0700 p0733 p0734 1997 chrysler intrepid
P0700 codes are Transmission DTC's (Diagnostic Trouble Codes)...
The specific codes are Incorrect Gear Ratio codes. This problem could be caused by low transmission fluid, deteriorated transmission fluid, a shift solenoid malfunction, the transmissions line pressure, quite a few electrical problems, etc. First step would be to check the fluid level the correct way. The vehicle must be up to operating temperature, and the shifter must be in the Neutral position. Also look at the color of the fluid. If the fluid is no longer the right condition, (most of the time it is bright red) it will be brown, or darker looking. Also smell the fluid, it may smell burnt. If this is the case, the clutch may also be slipping. In conclusion, if the fluid is NOT the problem, you may need to have the transmission tested by a certified technician. Hope this helps you.
SOURCE: 1998 Dodge stratus with error coded P0715 and
Welcome to Fixya
DTC P0700 means Internal Transmission Controller. This means a fault in the Transmission Control Module (TCM) or an interruption in power. Check the connector on the transmission and make sure it is clean and tight. Also check to see if the terminals inside the connector are damaged.
For the P0731 - does the speedometer works? If yes, then its the output speed sensor. Since you already replaced it. Check the connections if it is intact.
Thank you for using Fixya!
If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
SOURCE: 04 SAAB 9-3 THREE CODES P1743, P0735, P0734, TRANSMISSION WON'T SHIFT
Could be that a sensor has failed.My suggestion would be have local shop scan it....Could be so many things.......
Trouble Code Conditions:
Vehicle driven to a speed of 4-37 mph at more than 500 rpm, gear selector in 4th Gear in Drive, and the PCM detected too much difference in the engine speed and output shaft speed.
Possible Causes:
Trouble Code Conditions:
Vehicle driven any forward Gear, and the TCM detected the ratio of the Input speed to the Output Speed did not match the current Gear Ratio (this test can take up to 5 minutes).
Possible Causes:
126 views
Usually answered in minutes!
×