Question about Cars & Trucks
I want to take out ignition lock and replace it with a new one.
Remove the plastic cowling and the immobiliser ring,disconnect the wiring plug from the switch and then turn the ignition to position 1.There will be a pin that you push in and this releases the complete ignition barrel/steering lock/wiring assembly,the new replacement will slide in using the same technique.You can put the replacement key blade into your original fob and all will be well.
Posted on Nov 04, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
remove the bits in front of it like the air pipes and the battery and whatever else is in the way ,my favourite vehicles renaults ?? for scrapping not for working on though
Posted on May 16, 2010
Most likely to be a faulty resistor block, which has 3 resistors and a thermal fuse controlling fan speeds 1,2 and 3, maximum speed 4 by-passes the resister block. It may also be poor electrical connections to the resistor block caused by overheating. Renault ask for approximately £350 to carry out repairs, a replacement resistor block will cost £50. If you decide to carry out the repairs yourself, be advised that if you are not competent to carry out such work you, could cause electrical damage or worse an electrical fire.
Posted on Nov 14, 2009
hi off your discription sounds like the engine warning light is your car running ok and have you not got the drivers hand book in the glove compartment as this will verify it the engine waring light is basicly for the emmissions on your car you need to get a fault code reading to give you some idea of what if causing your problem it may be a simple fix example blocked air cleaner but i find guessing usually costs you more money in the long run i wouldn,t ignore it though as they are there for a reason yates210456
Posted on Oct 02, 2008
possible card fault!,ive had same problem with mine .after getting help from rac ,found reader faulty[worn], so if card reader hanging down[out of console]put card in at slight30 degree downward angle would work ,although had to tie strap it so would keep in position but works safely. on getting new card reader £67.17 from renault and fitting it, found that card is fault so just swapped back to old reader untill can afford new card and programming£150. from renault hope this helps rich i...
Posted on Jun 20, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
Posted on Sep 23, 2009
Tips for a great answer:
Apr 18, 2012 | 2001 Renault Renault Scenic Sport
May 12, 2010 | Cars & Trucks
Mar 17, 2010 | 2000 Renault Sportwagon
Dec 29, 2009 | Renault 18I Cars & Trucks
Nov 03, 2009 | Renault Cars & Trucks
Oct 24, 2009 | 2004 Renault 181
Aug 12, 2009 | 2000 Renault 181
Apr 26, 2009 | 2000 Renault 181
Jun 23, 2018 | Cars & Trucks
239 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: