Question about 1998 Chevrolet Blazer

1 Answer

Dont start wants to.ran two days got next day to start wont. gets fire

Also pressure sensor code comes up .

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Master
  • 1,007 Answers

I'm sorry. The English in this message is entirely incomprehensible. Please try again.

Posted on Nov 04, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: 1997 S-10 fuel line/fuel pressure regulator

Please this link :

http://www.autozone.com/addVehicleId,2336303/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800bfe20

Posted on Jul 08, 2008

  • 3 Answers

SOURCE: new fuel pump replaced on 2000 chevy s-10 blazer, no fuel

BAD FUEL PUMP


Posted on Apr 19, 2009

mcgyver468
  • 710 Answers

SOURCE: 99 chevy blazer start truck fine then next time go

Fuel pump relay sound bad. Under the hood in the fuse box is the location of the relay. Look under the cover for the diagram to locate it faster. Hope this helps. Please keep me posted. Good luck

Posted on Apr 28, 2009

MNfisherman
  • 11896 Answers

SOURCE: engine cranks but won't start

I firstly would check relay. You can use an ohmmeter to check the resistance of the relay. If you get a reading, it is good, If not it is bad. Than disconnect fuel pump wire harness and do the same.

Posted on May 28, 2009

  • 3 Answers

SOURCE: engine wont start

if you can hear the fuel pump when turn the key on with out turning the engine, then it could be that your fuel pressure regulator is broken, check your fuel pressur.

Posted on Jun 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my car start. No Codes.


Did you check for spark an fuel pressure ? Videos on you tube showing how to check these thing's

Sep 29, 2016 | 2002 Ford Escape

2 Answers

2011 Camaro engine miss-firing


Very hard to diagnose without trouble codes, but sounds like a fuel problem - bad gas, fuel filter plugging, fuel pressure regulator acting up, etc. I would certainly check fuel pressure at the engine with key on but not started, and then while trying to start.

Apr 18, 2017 | 2011 Chevrolet Camaro

1 Answer

1992 jeep cherokee sport 2 door 4.0 inline six. Jeep was running fine except when you went to start it it took two cranks sometimes three then would start. Went to start it the other day and it took alot...


Sounds more like a timing problem than an O2 Sensor. Distributor out of Sync would be my guess. It ran better at Higher idles because the timing belt/chain was tight from tension at low idle the timing was off which caused your problems. Now the belt is either broken or so loose the timing is out and the vehicle won't fire. If it has a Distributor cap remove it and watch the rotor. If it turns the belt is intact but Timing may still be off.

Dec 27, 2010 | 1992 Jeep Cherokee Limited

1 Answer

2003 land rover freelander will not start


cheaper to have codes read than replacing parts that may not be required, but yes could be crank sensor

May 26, 2010 | 2003 Land Rover Freelander

1 Answer

O2 lincoln ls check engine light & fuel gauge went to empty the next day it wouldny start replaced fuel pump & fuel gauge ran fine drove about 40 miles the next day started it up check engine light...


You have two pumps,I guess you know that ,if you already did one. Did you check fuel pressure at the rail and check out the electronic pressure regulator? What codes are coming up and do they stay set?

Feb 05, 2010 | 2002 Lincoln LS

1 Answer

2001 VW JETTA SPUTTERING AND BACK FIREING WONT GO OVER 10MPH


First check all wires for any thing loose.
The muffler blowing up leads me to think the engine is so far out of time the PCM cant correct it.

REally you need to get it to a good mechanic.

Jun 26, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

Car will not start


sounds like a fuel delivery issue, check your fuel pressure should be around 45 psi

Dec 27, 2008 | 1995 Chevrolet Corsica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...