Question about Cars & Trucks

1 Answer

I have a 1993 grand marquis , 4.6 v8 engine and when it gets cold out side and I let the car warm up to normal temperature and put it in gear it stalls out but when the car is cold it will go fine unt

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

Check the throttle position sensor

Posted on Nov 04, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 38 Answers

SOURCE: stalls when put into gear

Its possible it could be other things causing the problem, but seeing as you've checked most of the likely causes, it is most likely your Torque-Converter. The lockup clutch in your Stator-Fan located inside the Torque-Converter could be siezed, causing the car to stall.

Posted on May 16, 2008

leetamara
  • 702 Answers

SOURCE: will not start when engine warm

Sounds more like your ignition module is getting hot and not working. I'd go there first before replacing the ECM. You can remove the ignition module and most NAPA stores have the ability to test them for you. Make sure they test it at least 5 times. This way it'll simulate starting and stopping.

Posted on Jul 23, 2008

  • 32 Answers

SOURCE: 1997 Jeep Grand Cherokee Stalls when put in gear V8

Replace the throttle postioning sensor, and mass air flow sensor

Posted on Mar 09, 2009

  • 62 Answers

SOURCE: Car hesitates/stalls when engine is warm and car starts to move.

Sounds like a bad motor mount, pop the hood and see if the motor shakes or moves rapidly when u put it in gear holding down the brake.

Posted on May 10, 2009

  • 6982 Answers

SOURCE: jeep grand cherokee stalls after warming up

You need to check components again when the engine is hot and in no-start condition, otherwise, you will get bad info...obviously whichever part is doing this works fine cold. ones that react most to heat are crank pickup, ignition coil and the fuel pump.(bad ones get hot and bind up)

Posted on Jun 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bottom falls out of idle after revving engine cold


Its probably a problem with the water temperature sensor. Also do not rev a cold engine. The engine has a "cold start sequence" which is similar to a choke. When the engine gives a cold signal, the fuel mix is made richer and the timing is changed until the engine warms.

Let the engine warm at the preset factory settings. Sometimes the O2 sensors will cancel the cold start sequence before the water is warm. Racing the engine will warm the O2 sensors too quickly.

May 14, 2014 | 1993 Mercury Grand Marquis

2 Answers

1997 grand marquis wont restart when cold


change air filter and fuel filter clean fuel injectors.faulty coolant temperature sensor will cause cold start problems.

Jan 04, 2013 | 1997 Mercury Grand Marquis

1 Answer

I have a 1993 mercury grand marquis and reverse doesn't work after it warms up. It does work when cold.


You can check with a local transmission shop, but usually the problem is a worn band or a weak pump. The reverse band also affects low gear.
There may also be a solenoid involved.

Sep 15, 2012 | 1993 Mercury Grand Marquis

2 Answers

Will a 1993 mercury engine fit in a 2002 grand marquis


Without seeing the two, I would say no.
You would have to check motor mounts, bell housing, exhaust pipes, and then all of the emission components and wiring to find out.
Even the radiator hose outlets.
A salvage yard should have an interchange book to help tell you.

Jul 15, 2012 | 2000 Mercury Grand Marquis

1 Answer

How do I put transmission fluid into my 1993 Mercury Grand Marquis?


Look towards the back of the engine at the passenger side and you will see a handle probably marked transmission. It will protrude from a small diameter tube. When you lift this handle there will be a thin metal piece that is the dipstick used to check the fluid level. Before you check the fluid let you car warm up to normal operating temperature and run the selector through the gear positions. Make sure your car is on a level surface and insert the dipstick back into the tube fully and pull it back out and read the fluid level at the tip of the stick. The car must be warmed up to get the correct fluid level.Transmission fluid expands as it heats up. It will show low if you check it when it is cold. If you add fluid when it is cold this will result in an overfill condition when it warms up and will cause foaming and possible transmission damage.

Apr 06, 2012 | 1993 Mercury Grand Marquis

2 Answers

I need a route diagram from coil packs to plugs on a 1993 mercury with 4.6 v8


These are the factory diagrams from the factory service manual for the 4.6 V8


emissionwiz_76.gif

Apr 14, 2011 | 1993 Mercury Grand Marquis

1 Answer

This mercury is a 1994 V8 equipped. It sputters and and backfires through the breather like it would if it had a carb. It does this for miles even after prior warm up.


I'm having the same problem it sputters and backfires between 0 and 30 then just kicks in and acts normal recently did tune up. Any suggestions? Mine is a 94 grand marquis with a 4.6l v8

Mar 01, 2011 | 1994 Mercury Grand Marquis

1 Answer

Jeep grand cherokee stalls after warming up


You need to check components again when the engine is hot and in no-start condition, otherwise, you will get bad info...obviously whichever part is doing this works fine cold. ones that react most to heat are crank pickup, ignition coil and the fuel pump.(bad ones get hot and bind up)

Jun 07, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Engine


I put 1993 grand marquis engine fit into a 1992 grand marquis without too much trouble

Sep 23, 2008 | 1993 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...