Question about Cars & Trucks

Open Question

Rover 25 fuse blowing side light and tail light

Checked earth and changed bulbs

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75197 Answers

SOURCE: Need fuse schematic

if the fuse was blown the stop lights on both sides would be inop, also if the stop light circuit were dead u would be unable to get the trans out of park, use a 12 volt test light and test the brake light switch at the top of the brake pedal, u can buy a test light from Autozone, kragen and others for about $5 US. If the system has power cjheck the bulb socket it may be defective, use the 12 volt test light while someone pushes the brake pedal. let me know what u find and i will give u further assistance as ness.

Posted on Jan 13, 2009

ryan7896
  • 31 Answers

SOURCE: 1995 Land Rover Discovery Tail Light Problem

Check the circuit board that the bulb plugs into and make sure it is not burned or that the contacts are not damaged.

Posted on Mar 20, 2009

  • 490 Answers

SOURCE: 97 CAMRY TAIL LIGHTS PROBLEM

You are right you do have a short,but it's easy to fix at the same time it is expensive. In your trunk area you will find a bulb out relay it can be either in the right corner or left corner panel in the trunk area,if not there if may be under the rear deck of the trunk(under the rear window inside the trunk) It might be yellow brown or green.One fron the junk yard will work just as good as a new one.If you are skillful you can open it and solder the burned circuit,but you have to know what you are doing.You also neet to find out if you had a bad bulb that shorted so you can rest knowing that what caused it to burn out in the frist place is fixed.

Posted on Jul 23, 2009

wracefans24
  • 1985 Answers

SOURCE: brake lights won't work. tail lights do. I

need to know if your third brake light up high is working or not.if it isn't,you need to check the brake light switch on the brake pedal with a test light,one side hot all the time,the other side should turn hot when brake pedal is pushed.

Posted on Jan 19, 2010

johnjohn2
  • 5763 Answers

SOURCE: brake lights don't work

This sounds like a bad brake light switch, this switch is located on the bracket that holds brake pedal,you can test for power at switch,also if you remove connector and jump terminals with a wire and see if lights lite, if lights light then switch is bad,

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2011 Chevy Malibu tail lights are out, is it a fuse or bulb? Thanks


IF both lights are out most likely a fuse, check the drivers manual for location of fuse, check both sides of the fuse with a test light, must be voltage both sides, no voltage , cable from light switch to fuse faulty. voltage to only one side of fuse, fuse faulty. voltage to both side of fuse , cable to tail lights faulty, bulbs faulty or bad earth to tail lights.

Mar 03, 2016 | Cars & Trucks

2 Answers

I have a 2004 rover 25 1.4, this morning tail lights and number plate light not working, reverse, fog and brake lights all fine, advise pleas?


Brake light? Some bad connections to light sockets if bulbs not burned out. Of course you will need help to see brake light when brake is pushed.

Mar 08, 2015 | 2004 Rover 25 1.4

6 Answers

Why would my 2002 Dodge Durango passenger side tail lights work but the brake and blinker do not? Bulbs are the same and it has a single fuse. All are good. What would keep the blinker or brake light...


I had a similar problem, you might want to try changing out the BWD - Relay - Multi-Use Part #R4823. It is located under the Dash, beside the Steering Column. I purchased one from Canadian Tire for $25.00 b71e50cc-8a90-4fe6-8fc0-e129852746b5.jpg

Apr 24, 2014 | 2002 Dodge Durango

1 Answer

Rear park lights keep blowing fuse


first mistake you make is to increase the fuse capacity to above that required. You have a short in the circuit and by putting such a large fuse in you run the very real risk of burning the wiring loom. Check the bulb sockets and check that the right bulbs are in the sockets. bulbs come in two styles. one has 2 contact points and is either for 2 filaments (stop and tail) or a earth wire (Plastic light units) and the other is a single contact that earths out through the metal base . If you have the wrong bulb in place the current will short directly across the contacts and the light will not come on and the fuse will blow. Fuses for tail lights will be 5 amp maximun

Dec 31, 2013 | 2008 Hummer H3 Alpha

1 Answer

I have a 1997 cavalier z24 that is having some electrical problems. The tail lights, side marker lights, and instrument cluster lights do not work. I've already replaced the fuse, but it keeps...


you have a dead short immediately after the fuse Check wiring for rub points/ pinch points. Check all bulb sockets to ensure that the power wire is not touching earth or the earth wire.

Jun 13, 2013 | Cars & Trucks

1 Answer

Fuse keeps blowing out


check for a short in the wire to the r/tail light. check that the bulb is the correct one and that if there 2 terninal on the bulb that the unit has a return earth check in the kole for the bulb and if you see only 1 contact and you have a 2 contact bulb that may be you fault .

Jan 10, 2013 | Cars & Trucks

2 Answers

My tail light fuse on my92 s-10 just keeps on blowin and when it blows my tail lights and my inside dash lights doint work, howcome it would b doin that??


Check your tail light and other running light sockets for corrosion.
Pull each and every bulb to check it, also check the back side of the socket.
(Your headlights are not part of this circuit.)
Rust or water with rust will conduct enough current to blow the fuses.
Please revert back to the 20 amp fuse, as you may damage the wires leading to the bulbs in places you won't be able to find or fix.
It's unlikely that it's one of the actual light bulbs, all light bulbs tend to go open instead of shorted, but you can check them too.

May 31, 2012 | Cars & Trucks

2 Answers

Tail lights do not work all lights work but the back lights do not work. I change the fuse but lights still don't come on. all the other lights work is there other fuses i need to replace


if the bulbs are ok! check bulb socket to see if you have power.with test light, if not make sure sockets are clean. check the bulbs first, because they are a double filiment bulb. for brakes and tail lights. did you change the correct fuse!! it is located in interior fuse box on drivers side end of dash. its on bottom left side of fuse box. its labled "stp lps". hope this helps,

Aug 13, 2010 | 2000 Chevrolet Malibu

1 Answer

Fuse block #33 immediatly blows the fuse. controls left tail light and about 4 other circuits. Problem started after my alarm started going off for no reason. 1998 323is coupe


According to the BMW manual circuit diagram F33 feeds power through the parklight 'on' switch to left front parklight and left tail lights (all grey/violet wire).

Suggest you remove all left side parklight bulbs, then check fuse does not blow.
If it blows without bulbs installed, check wiring/lamp sockets for short to earth.

Instal one bulb at a time, checking fuse status each time.

Perhaps spurious alarm problem is related to faulty alarm wiring- especially if the alarm is an aftermarket installation. Check quality of any spliced joints to the parklight circuit for possible shorts or water ingress.

Jul 10, 2009 | 1998 BMW 3 Series

1 Answer

1995 Land Rover Discovery Tail Light Problem


Check the circuit board that the bulb plugs into and make sure it is not burned or that the contacts are not damaged.

Feb 24, 2009 | 1998 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...