Question about Cars & Trucks

Open Question

2004 x3 bmw how to remove differential right front

Differential leaking oil on right front

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

p_murfy
  • 63 Answers

SOURCE: window dropped into rear door panel. How do I remove the panel & repair

the window regulator has failed. the door panel has to be removed first which requires removing the trim piece that is on the grab handle (extremely hard to remove without breaking) there are three of four screws that hold the door panel on. once the door panel is off, the vapor barrier has to be removed. don't tear it, it is there for a reason to keep water out of the vehicle. make sure you reseal it properly with window weld. once the vapor barrier is removed you will need to unclip the window glass from the regulator. i typically will take and break the tab that holds the window. once the window is loose, move the glass all the way to the top of the door. now remove the regulator, swap the motor over, and reassembly. i would recommend taking the vehicle to a bmw dealership, around $650 for the complete repair and the dealership will stand behind their repairs

Posted on May 03, 2009

  • 335 Answers

SOURCE: Drivers side front differential leak

You will need an exploded veiw for you to take this on. This can be found at http://www.eautorepair.net/ I have used this site many times and it has been helpfull in getting the info you need. Rate if this helps.

Posted on May 18, 2009

dealt_soul
  • 296 Answers

SOURCE: I have a 2004 bmw x3 and I am getting a whining

Check the power steering fluid level. It sound like its low, if its not then have the power steering pump checked.

Posted on Jul 14, 2009

  • 59 Answers

SOURCE: front axle differential on 2000 chevy silverado

Your pickup leaks just like everyone elses. what you need to do is go down to your local parts store and get an inline fuel filter (your local chevy dealer should also have these available just for this problem), preferably see thru then, where your vent runs up the inner fender cut the line about 4 inches down from the vent and install the filter. this will cure your problem

Posted on Jul 28, 2009

  • 198 Answers

SOURCE: 2004 gmc sierra rear differential

remove cover.take off back wheels and calipers (or drums).turn differential to where you see small bolt/pin (5/16) horizontally (same direction as axles)on right side of differential.remove bolt/pin.A large pin (about 5"long 3/4"diameter) should slide out differential with ease ( you may have to tap one side of the large pin).turn differential to completely remove large pin.turn differential so you can see in the view window.push each axles in (they'll go in about 1 1/2"each) You may hear one of the axle C-clips fall.If not use a small telescoping magnet to remove the C-clips from the axles through the differential window.pull each axle out about 10"so they are out of the diff.Now remove the cap bolts(4-5/8"bolts) and remove the caps(mark the caps so they go in excactly the way they came out.be careful the diff might fall out.If not you may have to use a long bar or 2x4 to wedge and pry the differential out. Have a basket/crate w/rags in it to catch the diff.TIP:If you are removing the ring gear from the diff, the bolts are left handed bolts meaning you have to turn them clockwise to loosen and counter clockwise to tighten ; )

Posted on Sep 15, 2009

Testimonial: "thank you helped ALOT perfect instructions "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you repair the rear differential on a BMW X5, 3l, diesel, auto. Makes grating sound in reverse, not engaging forward. Oil leaked out through diff.


Hey Jordan, Repairing a differential is a complex task..( to make it RIGHT and have it last)... Please take it to a qualified professional!!

Aug 11, 2017 | BMW Cars & Trucks

1 Answer

2005 bmw x3 3.0l automatic. Swapped out starter from underneath. Removed drive line from frt of tr/case, removed t/cs crossmember.


BMW X3 Starter - PartsGeek.com

www.partsgeek.com > Starter > BMW Starter > X3 Parts
BMW X3 Replacement Starter Information. Read Reviews for ... Search our onlinestarter catalog and find the lowest priced discount auto parts on the web. We sell wholesale ... They are available for the following BMW X3 years: 2006, 2005, 2004, 06, 05, 04. This part is also ... 07 2007 BMW X3 Starter 3.0L 6 Cyl N52 Bosch.

Jul 25, 2015 | BMW Cars & Trucks

1 Answer

How to remove the tank fuel pump on 2004 BMW x3


should have an access panel to the fuel pump...all the other bmw's do....

Sep 26, 2014 | 2004 BMW X3

1 Answer

Bmw x3 troubleshooting


VACUUM LEAK IN THE OIL RE-CIRCULATOR

Aug 25, 2014 | 2006 BMW X3 3.0i

1 Answer

Oil leak on passenger side of car front of engine some sensor


You can try tightening the sensor but you'll likely need to replace it and the seal. Do the work soon, if the flow of oil leaking increases and the oil pressure gets too low you could find yourself needing a new engine.

Oct 11, 2013 | 2009 BMW X3

1 Answer

Need to replace oil pan on a bmw 2004 330ci


Raise engine with special tool 00 0 200 approx. 5 mm.
- Remove suction filter housing. Remove engine splash guard.
- Drain engine oil. On vehicles with automatic transmission:
- Disconnect oil lines from automatic transmission and from oil pan.
- Release guide tube for dipstick.

Note: M52TU and M54 only.
- Detach return hose from cyclone oil separator on oil dipstick guide tube.
- Replace O-ring.
- Remove front end reinforcement.
- Detach steeling spindle from steering gear.
- Remove vane pump for power steering unit (lines remain connected).
- Disconnect plug connection to oil level sensor.
- Loosen top and unfasten bottom of left and right engine mounts.

E46 4WD only
- Remove left and right swivel bearings.
- Remove output shafts. Remove front propeller shaft.
- Remove front axle differential.
- Detach brackets for left and right control arms from engine carrier.
- Release retaining brackets for left and right stabilizer bars.
- Unfasten screw connection on front axle support and lower the front axle support.

Note: There is no need to detach the steering gear from the front axle support.

- Unfasten oil sump screws at transmission and engine ends.
- Lower and remove oil sump.
Sealing faces clean and free of seal debris.
Apply approx.3 mm wide, 2 mm high coat of Drei Bond 1209 sealing agent to the area around seams.

Installation:
  1. Replace gasket
  2. Install oil sump.
  3. Insert all oil sump screws.
  4. Insert screws in transmission end without preload at this stage.
  5. Tighten down screws in engine end.
  6. Tighten down screws in transmission end.

E60 Removing And Installing, Sealing Or Replacing Oil Sump (M54)

Necessary preliminary tasks. -
- Remove intake filter housing
- Remove guide tube for oil dipstick
- Lowering front axle support
- Drain off engine oil
- Disconnect plug connection to oil level sensor.

On vehicles with automatic transmission:
- Detach oil lines from automatic transmission and from oil pan.
- Unfasten oil pan screws at transmission and engine ends.
- Lower and remove oil pan.

Installation:
Sealing faces clean and free of seal debris.
Apply approx.3 mm wide, 2 mm high coat of Drei Bond 1209 sealing agen to the area around seams.

Installation:

  1. Replace seal.
  2. Install oil sump.
  3. Insert all screws on transmission end, without preload at this stage.
  1. Tighten down screws on engine end.
  2. Tighten screws on transmission end.

Or take it to a dealer....

Apr 19, 2011 | BMW 330 Cars & Trucks

2 Answers

BMW oil change at dealer that sold me the car.


make them fix it if it was not leaking before they serviced it / by all mean if it was leaking they should have found it and told you in inspection them responsibility to fix

Jun 20, 2010 | 2005 BMW 3 Series

1 Answer

2008 BMW X3, removing the left rear outer door handle.


2004 x3 Rear passenger door handle came off/apart. What are the steps to remove the inner door panel to access the door handle and repair it?

Apr 06, 2010 | 2007 BMW X3 3.0si SAV

1 Answer

Are there any special tools needed to change brakes and rotors on a 2004 bmw x3


Front or rear. Front just sockets and mabey Allan wrench set. Back set, a spring removal tool and sockets. Metric

Sep 11, 2009 | 2004 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...