Question about 2001 Mercury Cougar

Open Question

2001 mercury sable transaxle warning light - 2001 Mercury Cougar

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
warlock61
  • 659 Answers

SOURCE: Oxygen Sensors

ok Bank 1 is the rear bank and bank 2 is the front bank sensor 1 in each bank is the one closest to the manifold they have green connectors sensor 2 is the sensor after the cat converter and is a blue connector

Posted on Dec 02, 2008

Ad
smartr10U
  • 1305 Answers

SOURCE: 1999 Mercury Sable Dome Light won't shut off

Next to the headlight switch is a dimmer dial for the interior dash lights... if you turn it all the way up, the interior lights remain on... there is a "detent" on the dimmer. turn the interior dash lights all the way full on ...you'll feel the detent, then turn it down back past the detent a little bit...that should cancel the interior courtesy lights... wait a bit because the interior lights are sometimes on delay timers....
good luck let me know what happens.

Posted on May 09, 2009

greg_margo
  • 1959 Answers

SOURCE: mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401". Any suggestions?

Barring any vacuum leaks, P0401 is indicative of a bad EGR valve. Hope this answers your question. Best of luck.
Greg

Posted on May 30, 2009

emissionwiz
  • 76164 Answers

SOURCE: codes for keyless entry on a 2001 merc sable

the numbers are on the keyless module in the trunk, it is a paper tag

Posted on Jun 05, 2009

greg_margo
  • 1959 Answers

SOURCE: Check engine light with codes

P0171 & P0174 indicate Lean burning on banks 1 and 2. The most common cause is a dirty or defective MAF (Mass Air Flow) sensor. Other causes are bad fuel filters or a broken vacuum line.

Posted on Jul 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 mercury sable transaxle light is flashing and jerks when trying to go forward seems to move ok in reverse.


You need to the transmission control module scanned for fault codes, one is recorded whenever the light starts flashing.

Mar 16, 2017 | 2002 Mercury Sable

1 Answer

What does it mean when my transaxle light comes on I have a 2000 mercury sable


It means that the Transmission control module has detected a fault in the operation of the transmission or its controls. You now need it scanned to see what fault code or codes was set in the memory of the TCM.

Sep 29, 2016 | 2000 Mercury Sable

1 Answer

2003 Mercury Sable when apply brakes hard theft light comes on


check the over load circuit breaker for the lights going out. Run fault codes to find the ABS/ Traction control sensor problem

Feb 16, 2014 | 2001 Mercury Sable

1 Answer

Transmission fluid


30k on trans fluid may set the sensor off. The wiring to the sensor could be a problem too. A faulty sensor will give the indication too.

Jan 12, 2014 | 2001 Mercury Sable

1 Answer

2001 Sable ECU bad???


I suggest scanned the ABS module in order to know fault codes stored there. Just with this code number could send you solution details. Could be a probem with the sheel speed sensor misadjust, but will need confitm with the codes finded.

Jul 16, 2012 | 2001 Mercury Sable

1 Answer

2000 mercury sable transaxle flashing light comes on


indicates a problem. have someone scan it

Jul 25, 2011 | 2000 Mercury Sable

2 Answers

The Warning Light "Service engine soon" came on. We have a 2001 Mercury Sable. How many miles can the car be driven before dealer inspection?


This light means that the computer in the car has sensed a problem with something on the car. You should take the car to a local auto parts store and have them read the codes from the service engine light. Post the codes they give you here and we can help more. Most likely you wont hurt the car by driving it with that light on. Better to ba safe then sorry thought.

Mar 02, 2010 | 2001 Mercury Sable

2 Answers

Mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401". Any suggestions?


Barring any vacuum leaks, P0401 is indicative of a bad EGR valve. Hope this answers your question. Best of luck.
Greg

May 30, 2009 | 2001 Mercury Sable

1 Answer

Dashboard lights


Transaxle issue according to the manual. I have the same car. After I had to have the tranny rebuilt at 126K it started to blink. When I had a mechanic check into this deeper it turned out to be a bad transmisson tempature sensor. About a $400 fix.

Apr 02, 2009 | 2001 Mercury Sable

Not finding what you are looking for?
2001 Mercury Cougar Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...