Question about Ford Thunderbird

1 Answer

Blower motor location and installation on 73 ford gran torino

New heater core installed two weeks ago. Now it won't blow heat! There's some heat radiating from defrost area but nothing blowing from anywhere- Heat or defrost! Don't know location of blower motor or how to replace.

Posted by on

  • 1 more comment 
  • evemarie Jan 04, 2009

    This is not a t=bird. It's a 73 ford gran torino.

  • evemarie Jan 04, 2009

    After heater core installation, it WAS blowing until yesterday! No, didn't check the fuse. Where is it? By the way, thank you so much for the reply. Any other advise after this addition?

  • Anonymous Mar 25, 2014

    replace heater blower motor

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

It's less than foot from the heater core. I would guess that either the damper doors are not on correctly or the vent hoses are not hooked up. Can you hear the blower motor running? Maybe they didn't hook the motor back up when they replaced the heater core. It takes a ground and a hot wire.I can't remember where it's at but it may be part of the same unit. Did you check the fuse?

Posted on Jan 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater blowing cold


if u flushed heater core n both hoses to heater are hot, then more than likely the blender door is not allowing heat to enter the inside of car...a lotta times itz located behind glove box where u can chek it...dependz on the car...

Dec 18, 2013 | 1999 Ford Taurus

1 Answer

Heater core or thermostat


Nothing in or around the heater core could make a noise. The core is just a small radiator with coolant circulating through it. And if you feel both heater hoses, and both are hot on a warmed up engine, then coolant is circulating through the core and the heat should be working. There must be a door in the heater case that is not letting heat come out.
The noise may be from the blower motor and its plastic fan assembly. It should be pretty easy to take out the blower motor and check for any obstruction.

Dec 10, 2013 | 2003 Ford Windstar

1 Answer

How can i fix the heat to blow hot air in my 1996 ford econoline250 cargo van


so either the blower motor isn't blowing or its just blowing cold air-always start with fuses-then check for 12v at the blower motor-use a volt ohm meter- if you have 12v then the blower motor is bad-if there is no warm air blowing out-look for the water valve that lets the hot water into the heater core-its on the small hose going back to the heater core-make sure its operating-cheers Denny

Nov 30, 2013 | Ford E-250 Cars & Trucks

1 Answer

Location for blower motor fuse on a 1994 ford escort hatch


this isnt the heatercore as it is producing heat and the blower is a fan. the issue could be there is a bad connection to the blower or that the fuse is no longer good.



this site should have what you need:
http://www.books4cars.com/

Sep 22, 2012 | 1994 Ford Escort

4 Answers

2001 Ford Taurus Heater blower not working


heater is not blowinig warm air.

Sep 30, 2009 | 2001 Ford Taurus

1 Answer

Heater control not working on 1997 pontiac Gran Prix


There is a flat filter that sits between the firewall and the blower. Sometimes the filter is blocked and needs to be cleaned or changed. On older cars the filter is located on the firewall in the engine compartment infront of the blower. In the newer cars the filter is under the dash inside the car and much harder to get too.,

Sep 14, 2017 | 1990 Porsche 944

1 Answer

Heater core or blower motor?


Sounds like your blower motor , you heater core is a non mechanical part and if it were the issue you are correct in thinking you would see fluid on the floor or mist on the windshield.

Dec 17, 2008 | 2005 GMC Envoy

3 Answers

MY CAR WONT BLOW HEAT


The problem is A small device that is called A (blend door actuator )it is located on side of heater core under the dash its A small white box with wires coming out of it .it opens the valve so coolant can run through the heater core.
you can open it manualy with ascerw driver by pushing the temerature control door shaft that is located behind it up.this is only temprerary fix until you replace this part.

Dec 15, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

598 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5636 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...