Question about 2006 Pontiac Grand Prix
If you have the 3800 Series II or Series III engine, this should help you out.
If you dont have the supercharger, just disregard the belt routing with the S/C on it.
Posted on Jan 04, 2009
Here's a link to the diagram you need...
Good luck and please rate this solution. Thanks.
Posted on Oct 17, 2009
Testimonial: "Looks good."
Tips for a great answer:
Mar 31, 2016 | 2004 Pontiac Grand Prix GT2
Jan 11, 2015 | 2004 Pontiac Grand Prix
Aug 17, 2012 | 2004 Pontiac Grand Prix
Below is the master help link
provided to go through belt routing diagram:---Timing belt, drive belt,
serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all
types of car models?
Click the link below: ----
----------This will help. Thanks.
Feb 07, 2012 | 1992 Pontiac Grand Prix
Park the Pontiac in a safe work area and open the hood.
Inspect the top of the black plastic cover that surrounds the fan for the serpentine belt routing diagram. This diagram has the instructions for installing the new serpentine belt around the accessory pulleys.
Inspect the front of the engine and locate the automatic belt tensioner. The tensioner on the 1999 Pontiac model vehicles is located between the alternator and the crankshaft pulley. The tensioner has a pulley on one end with a bolt head in the center of the pulley. Use the bolt head to rotate the tensioner.
Turn the tensioner counterclockwise with the breaker bar and a metric socket. Pull the belt out from under the tensioner pulley with your other hand. Then, slowly let the tensioner retract until it stops.
Pull the belt out of the other remaining pulleys. Then, pull the belt out of the engine bay and lay it on the ground.
Route the new belt around the crankshaft pulley. Then, route the new belt around the other remaining pullleys by using the serpentine belt routing diagram for instructions.
Rotate the tensioner pulley counterclockwise with the breaker bar and socket. Then, slide the new belt under the tensioner pulley. Slowly let the tensioner retract until it stops. The tensioner pulls all of the slack out of the belt and brings the new belt to the proper tension. Remove the breaker bar and socket from the tensioner pulley.
Inspect the new belt to ensure that it is seated inside of all the accessory pulleys as directed by the diagram. Then, crank the engine and allow it to run for about 15 seconds. Turn the engine off. Inspect the belt again once more to ensure that
the belt is still around each pulley. Close the hood.
May 22, 2011 | 1999 Pontiac Grand Prix
Nov 28, 2009 | 2006 Pontiac Grand Prix
Jan 27, 2009 | 2004 Pontiac Grand Prix
710 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: