Question about Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: P1457 - Honda Civic 2005 LX
this car come with tree diferent engines the answer i'm going to give you is for a 1.7 engine sohc that codes means you have a leak on the evaporative system this system monitor the vapors from fuel tank this code some time might appear for filling the fuel tank with car runing i recomend you to clear code and make sure the fuel cap is not loose because there is a fuel pressure sensor in the tank and if the sensor don't read the right pressure then it will set the code
Posted on Jun 01, 2008
P1362 = TDC (top dead center) sensor (1) no pulse.
Reset your car's power control module (PCM or ECU) by turning off the key and pulling the clock/backup fuse for 10 seconds then reset. Start the engine and see if the code returns. If not, it was an intermittant fault and the system is okay--but check for dirty or loose wire connector at TDC1/TDC2 sensor. If the code returns, check wiring to the sensor---if the wiring checks out, replace the sensor.
Posted on Apr 05, 2009
Hey I had the same code and I have a 2000 honda civic lx. My cousin
works at honda and drives a '96 honda civic and he has had that code
before on his car as well.
First thing he came up with was that the catalytic converter was cracked. We checked mines, and lo and behold, that's what it was.
Look under your hood, and there should be a catalytic converter with a sensor sticking out of it. It is connected to the exhaust manifold and the sensor sticks out of the heat shield. Around the sensor, look for a crack. If there's a crack, that's your problem.
Posted on May 03, 2009
I am sorry to bum you guys out, but this usually means the piston in the torque converter is bad. The converter needs to be replaced along with a transmission flush.
Posted on May 26, 2009
SOURCE: p 1705 code, honda civic lx 2001
Have tranny serviced . Check tranny fluid level fill with HONDA ONLY fluid. If not fixed have fluid drained and filter replaced on tranny
Posted on Jan 21, 2010
Testimonial: "thanks u very much. the problem has been resolved. very good advice."
Tips for a great answer:
Trouble Code: P0128
Trouble Code Conditions: DTC P0107, P0108, P0112, P0113, P0116-118, P0335, P0336, P0300-P0306, P0401, P0505, P1106-P1108, P1259 and P1519, engine running at road load for 10 minutes, and the PCM detected the ECT sensor input did not reach the correct closed loop value. Note: It is possible for this code to set if the engine is left running while the hood is open for an extended period in a warm climate.
Inspect for low coolant level or for an incorrect coolant mixtureCheck the operation of the thermostat (it may be stuck open)TSB 01-064 (9/11/01) contains a repair procedure for this code
Jan 27, 2013 | 2001 Honda Civic 1.7
Sep 15, 2011 | 2001 Honda Civic
Feb 12, 2011 | 2001 Honda Civic
Apr 10, 2010 | 2001 Honda Civic
Jun 02, 2009 | 1990 Honda Civic
Apr 04, 2009 | 2002 Honda Civic
Apr 03, 2009 | 2001 Honda Civic
Feb 22, 2018 | Cars & Trucks
217 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: