Question about 1998 Lincoln Navigator

Open Question

ALARM SYSTEM WILL NOT DISARM,98 LINCOLN NAVIGATOR

DON'T KNOW HOW TO DISARM MY ALARM SYSTEM

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jigsaw_9077
  • 308 Answers

SOURCE: 98 lincoln navigator compressor was shorted

To probe that there is a power on the relay on your 1998lincoln navigator is this what you should do. Have or use two wires then a 12Volt bulb.Then connect the end of the two wires to the bulb, then taped it to the bulb.then the other end of the two wires is going to be used . To connected to the relay to find if there is a power . One end of the wire will be positive, one end of the wire will be negative. If there is a power the bulb will light.

Posted on Jul 28, 2009

Ad
  • 3911 Answers

SOURCE: Does anyone have diagrams for

don live in the real world, that suspension is never going to work right again. you are going to spend a ton of money, and no matter what you do something else will go wrong. big mercs, lincolns, BMW, caddies, land rovers, etc all sit in the same saggy swamp. there are still thousands of collapsed Peugeots sitting in barns since the 1970s across the land waiting for a real suspension fix.

take a long look at www.strutmasters.com and consider junking the air or hydraulic suspension system and trading up to a real one with springs and shocks.

Posted on May 21, 2011

SOURCE: how do you replace the fuel relay on a 2006 lincoln navigator

Its inside the fuel pump assembly. Unfourtunetly, you cannot buy it alone. You have to replace the entire fuel pump assembly (unless you can find the assembly at a junk yard and then take out the relay.

Good luck!

Posted on Nov 11, 2011

  • 39 Answers

SOURCE: why my headlights on my 1998 lincoln navigator don't work?

check fuses and headlight switch

Posted on Mar 23, 2012

  • 3 Answers

SOURCE: can't turn off alarm 88 lincoln

Try unlocking the driver's door with the key. If it does not work thy the key in the pasongers door.

Posted on Sep 15, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do you get a master key for a lincoln navigator?


YOU RESET THE ALARM BY GETTING OUT OF THE CAR WITH KEYS IN HAND AND LOCKING TRUNK HOOD DOORS ETC. THEN OPEN DOORLOCKS AND ENTER CAR AND START IT

Apr 18, 2013 | 2000 Lincoln Navigator

1 Answer

How to disable anti thieft on 96 lincoln mark8


WELL IT MAY HAVE A PROBLEM. DON'T KNOW. TRY THIS DISCONNECTED THE BATTERY CLEAN AND CONNECT. NOW IT THE ALARM IS ARMED MOST CAR WILL DISARM BY UNLOCKING THE CAR WITH THE KEY. SEE IF THAT HELPS.

Dec 13, 2012 | 1996 Lincoln Mark VIII

1 Answer

Can't find out which relay switch is for my


How would you know anything needs to be replaced,
unless you tested it & you can't find it ,to do that?

HELM.Com ---- spend enough money for the factory
wiring diagrams & you will be read to start the process

I never even approach any vehicle without having referrence
material in hand first,your wasting your time

You can't do a thing, if you don't know how a system works
or where things are.

if you have to ask,it is beyond your current skill level

May 18, 2012 | Lincoln Navigator L Cars & Trucks

2 Answers

Don't know what the picture on the dashboard is for? Looks like a radiator, but not sure. Misplaced car manual


the alarm automatically arms 30 seconds after you lock the doors
i looked around online and found info for you

The FACTORY ALARM DISARM WIRE IS
lt. green/orange '-'conn. 2, pin 9 @ the BCM.

The factory alarm disarm wire is
negative trigger thru a 473 ohm resistor.
MUST use relay. The BCM
(Body Control Module) is attached to
the left of the fusebox.
Connector 1 is a gray 26 pin plug,
and connector 2 is a gray 22 pin plug.

Once Located, splice into this wire with
a simular guage wire, add the specified resistor
and put it to a solid chassis ground.
This terminates the alarm functions entirely.

However, at this point, this car would be exceedingly
easy to steel, so I suggest you get an aftermarket
alarm system to protect it from here on in.

Take this info to your local
stereo/car alarm guy and have them
do this for you.

Sep 16, 2011 | 2005 Jeep Liberty

1 Answer

How can I disarm the Alarm. I bought my 97 Cabrio used (it didn't come with the remote) The Door locks also don't work. I can't drive it because when I turn the key the alarm goes off and it...


If you don't have the remote then its pretty much useless. I have seen at Pep Boys where they sell replacements for the factory/dealer installed alarms. Or just remove the alarm completely and reconnect everything the way it was.
Without knowing what brand alarm it is a person cannot honestly answer how to disarm it as they all work differently.
If you know a brand and model you may be able to find downloadable instruction on the manufactures web site.

Sep 08, 2011 | 1997 Volkswagen Cabrio

1 Answer

When i try to start me 2008 sonata the alarm goes off and the engine will not turn over. what can i do?


Your Sonata is equipped with a "Keyless Entry & Burglar Alarm" system. When the Burglar Alarm is activated, it KILLS the starting system through the used of a relay called the "Burglar Alarm Relay". This mode prevents engine starting with the key.
Solution #1
Disarm the system with the Keyless Remote (key fob) If you don't have this remote (or its battery is dead) replace the battery & try disarming again.
Solution #2
Enter the vehicle & insert the key in the ignition and turn the ignition switch to 'RUN'. Wait 3 to 5 minutes until the alarm stops. You should then be able to start the engine.

Have a qualified/certified Hyundai Service Technician properly diagnose this issue.

Sep 07, 2011 | Hyundai Motor 2004 Sonata

1 Answer

My 1994 Jeep Grand Cherokee Laredo wont start, everytime I try to start it, it makes this loud noise like a buzzing sound, and then the security light starts flashing and the brights light starts flashing...


If your battery has not been drained, try unlocking the lift gate or the passenger side door. That should disarm the alarm. You may need to get a jump if you're getting the flashing lights.

Another thing it does is to shut off your fuel pump. If you get it started after trying the above procedure, the issue is definitely your alarm system.

It is armed whenever you normally leave your car (using power locks seems to arm it on my 94 GCL.

There is a permanant disarming procedure on FixYA but it is pretty radical -- you have to find one of the wires that sends the signal to the alarm system from one of your door locks and ground it.

Jul 13, 2011 | 1994 Jeep Grand Cherokee

1 Answer

1999 navigator


i know this worked with my 99 navigator 32 valve used a viper car starter.

Lincoln

Navigator

1997-2003

Remote Starter Wiring Colors and Notes

Function
Vehicle Color
Location

Start:
RED/LT. BLUE
IGNITION SWITCH HARNESS **

Ignition #1:
D BLUE/GREEN
IGNITION SWITCH HARNESS

Ignition #2:
GRAY/YELLOW
IGNITION SWITCH HARNESS

Ignition #3:
RED/BLACK
IGNITION SWITCH HARNESS***

Accessory:
BLACK/LT. GREEN
IGNITION SWITCH HARNESS

Brake Light:
L GREEN (+)
AT SWITCH ABOVE BRAKE PEDAL

Tach Signal:
WHITE/PINK
AT POWERTRAIN CONTROL MODULE *

Parking Lights:
BROWN (+)
AT HEADLIGHT SWITCH

Headlights:
RED/YELLOW (+)
AT HEADLIGHT SWITCH

OEM Alarm Disarm:
D GREEN/PURPLE (-)
DRIVER KICK PANEL

OEM Alarm Arm:
N/A


Diesel Glow Plug:



Clutch Bypass Wire:



Notes:
* Powertrain Control Module (PCM) Located On Passenger Side Of Engine Compartment On Passenger Wheelwell. This Wire Can Also Be Found At the Firewall Harness On the Driver's Side of Vehicle. ** This Vehicle Is Equipped With Ford's PATS Anti-Theft System. Use Universal Alarm Bypass Module part # 2x402 where X can be any number. *** Must power ign3 using a relay. Tap relay coil to ign3 connection of remote start along with bypass module. No diode isolation is required.

Aug 07, 2008 | 1999 Lincoln Navigator

Not finding what you are looking for?
1998 Lincoln Navigator Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...