Question about Cars & Trucks

1 Answer

Truck turns over good but wont crank.drift 6 inches drop clutch start right up and start all day

Starter,alt ,fuel pump all good just wont start after sitting all nite.wil start all day long after thar

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 1,007 Answers

If the starter motor is fine, then how do you know this if it isn't energizing? Have you tested it independently?
If it isn't receiving power, then it is possibly an issue with the solenoid, or ignition.

Posted on Nov 05, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dustyboner
  • 331 Answers

SOURCE: 1991 honda civic wont start...

try checking the main relay



view larger picture

3470075.jpg

Posted on Jul 10, 2008

repairpal
  • 128 Answers

SOURCE: car wont start engine will crank

One of those relays supply power to the injectors. They fail, as well as the fuel pump relay, rpm sensor, and the main pump. Have you checked the trouble codes in the engine or ignition computers?

Bret
RepairPal.com

Posted on Dec 09, 2008

  • 356 Answers

SOURCE: 2000 blazer 4.3 hard to start (fuel problem)

Do you have the fuel tester hooked the in the overgrown air valve on the fuel rail in the back of the engine? Or do you have the fuel line unhooked in the back and hooked to the pressure pump? You want the fuel pressure to be in that 60 lb range so if you are hooked into the pressure valve on the fuel rail allowing fuel to go through, then I am betting it is the fuel pressure regulator. To get to that, you have to take the throttle body off and take the plastic plenum that covers the injector packs. On the back of the mount where your six pack of injectors are sits the pressure regulator. If it is faulty then it is dumping fuel instead of holding the pressure like it should.
Get a Chilton or Clymer manual and it shows you in pretty good detail how to fix it. I've done it to my 98 S10 with the same engine.

If you unhooked the fuel line so you are losing pressure from the line back to the pump then I would say your pump is letting fuel back to the tank when it shuts off. My money is on the first possibility though.

Good luck

Posted on Mar 28, 2009

  • 1 Answer

SOURCE: 1991 acura legend sedan

i brought a 1991 Legend and changed the battery. Now the alarm keeps the horn blowing and it won't start. Can anyone help me

Posted on Apr 10, 2009

  • 3 Answers

SOURCE: new fuel pump replaced on 2000 chevy s-10 blazer, no fuel

BAD FUEL PUMP


Posted on Apr 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

I have a mercury mountaineer 2002 awd 4.6litre that stalled without warning and now wont start, it also turns over like a low battery but had battery and alternator checked at two different places bo


Its a possibility but I would think the fuel pump? That's where I would start. If it turns but doesn't crank then your most likely not getting gas.

Jan 11, 2015 | 2002 Mercury Mountaineer

3 Answers

Why is my 2003 Jeep Liberty- Starter turning, but eng won't start (intermittent problem)?


you didnt stated the symptoms correctly

it either cranks or it does not.
that means the starter ACTUALLY turns the cranks shaft over
robustly.
the crank shaft damper pulley is the clue to this , it turns or not.
if it always turns this is a :
cranks ok but wont start.
so, that means tune up the engine,
1: low battery voltage (slow cranks)
2: never tuned up this decade?.
3: bad fuel.
4: weak spark at any of the spark plugs, sure all must be good.
5: flooding, (wet spark tips)
6: fuel starvation.
7: any of 50 other engine mech. issues,(burned valves, is 1)

Sep 02, 2014 | 2003 Jeep Liberty

1 Answer

2002 yukon denali xl wont start


Does the starter crank the engine over? If so, check for spark on a spark plug wire when cranking. If you have a strong blue spark, ignition is probably good. Check fuel pressure. Do you hear the fuel pump turn on for 2 seconds when turning key to on?

Dec 15, 2013 | Cars & Trucks

2 Answers

Car won't crank over.


Are you sure you have all wires on Starter and Alt, Have you checked fuses for fuel pump, check starter relay, Reason for changing Starter and Alt??? DID YOU DISCONNECT BATTERY BEFORE YOU STARTED REPLACING PARTS???

Dec 13, 2013 | 2005 Ford F-150

1 Answer

98 GRAND PRIX WONT CRANK SOMETIMES


This is a trick some folks do to figure out if it's the starter. When the car doesn't crank, take something like a bat or a metal bar and hit the starter and few times. If the car starts right away then it's your starter, otherwise you might consider the fuel pump relay/fuel pump.

Nov 21, 2013 | 1998 Pontiac Grand Prix GT

1 Answer

WillNot start batt., good starter, good all fuzzes good


If the engine is not cranking over, it could be the clutch safety switch
(standard trans), Neutral safety switch (automatic) or ignition switch.

If the engine is cranking but not starting, it is not the starter, battery
or alternator. Check fuel supply, ignition and compression.

Sep 27, 2012 | 1997 Chevrolet Cavalier

1 Answer

2004 325xi BMW wont start - replace spark plugs and fuel pump


If u hear the engine cranking in the AM, the batt & alt sound good. If you don't get any engine cranking in the am you may have an electrical short draining the battery. Before u convict the starter u must make sure the battery has full power in the AM. (12V) & 12 V to the starter

Apr 10, 2017 | 2004 BMW 3 Series

1 Answer

Wont turn over


have your starter checked. if you force start your engine with a weak battery, the starter current draw increases and overheats the starter commutator especially with a big engine.

Jul 11, 2009 | 1998 Jeep Cherokee

2 Answers

Turn the key on and the starter will not engage.


check fuel pressure.if not above recomended spec. replace fuel pump. for starting have solenoid 0n starter checked.

Jan 26, 2009 | 1994 Cadillac Fleetwood

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...