Question about 2006 Honda Element
Our car was broken into and ever since then, whenever we lock the car it doesn't beep the correct way. Also when we unlock the car, it unlocks it, but it doesn't beep. Is this a problem from the break-in, and does anyone know what can be don to reset the alarm?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Car Alarm
sounds like the drivers side key switch has failed remove the interior door panel and there will be a switch attached to the back of the key lock cylinder or around there it should be two or three wires also check the door jamb wire harness where the door closes for any broken or damaged wires, use a vot meter and see if you get power or ground to the opposite side of the switch when you use the key to lock and unlock the door if nothing changes and there is power or ground! at this switch i would replace it, i don't think there is one but if the car has a passenger side key hole try to unlock the car from that side and see if you get the same problem -jeff
Posted on Aug 31, 2008
For the system to arm, the ignition switch must be off and the key removed. Then, the multiplex control unit must receive signals that the doors, hood, and trunk lid are closed and locked. When everything is closed and locked, none of the control unit inputs are grounded.
The door switches, hood switch, trunk lid switch, door lock knob switches, and door lock cylinder switches are all open. Ten seconds after the doors are locked with the key or the lock knob, or immediately after locking the doors with the remote transmitter, the system arms.
If anything is opened or improperly unlocked after the system is armed, the control unit gets a ground signal from that switch, and the system is set off.
If one of the switches is misadjusted or there is a short in the system, the system will not arm. As long as the control unit continues to get a ground signal, it thinks the vehicle is not closed and locked and will not arm.
An alarm that sounds for no apparent reason may have been set off by a switch that is on the threshold of misadjustment. In this case, it may only take a significant change in outside temperature, the vibration of a passing truck, or someone bumping into the vehicle to make the alarm sound.
Posted on Nov 19, 2008
SOURCE: Honda CRV 2002 Power Door lock
try testing or replaceing the drivers door lock actuator, reprogram ur key fobs and try unlocking and locking ur doors. as far as the lights and reminder,....it sounds like a seperate problem. but try the door actuator first (drivers side always act up and cause every other actuator to act up... like a bad kid that gets the rukkus started and ruins things for everyone..
Posted on Apr 05, 2009
the key fob remotes need to be reprogramed or have the battery checked... make sure to have all key fob remotes present when reprogramming...
Posted on Apr 06, 2009
I have an '06 Honda Civic. The most common places where the code is found is on the left side of the glove box, in the trunk somewhere along the gasket or underneath where the speakers are, under the fuse box panel, under the ashtray and sometimes under center console lid. I happen to find my in the left side of the glove compartment. The first five digits are the code and under that, you should see and 11 digit code which is your radio serial. So once you have the code if you haven't already, turn on the radio. It will ask you for the code and you punch it in using the number on the buttons you use to change your radio stations. As you punch in numbers "CODE" will start to fill in. Just like the asterisks used in passwords. If you punch it incorrectly, it will say "error 1" or something to that effect. Do not push anything else, just start over by punch in the first number of the code and then the rest. Be careful, if you attempt too many times, the radio will lock itself and you will need to leave the radio on for an hour for it to reset itself. When successful done, the radio will turn back on to the last station you were last on. Hope that helps.
Posted on Dec 08, 2009
Tips for a great answer:
Jan 14, 2016 | 2006 Honda Element
Oct 10, 2012 | 2008 Honda Accord
Sep 26, 2012 | 2010 Honda Civic
Feb 05, 2012 | 2006 Honda Accord 2.4
Nov 27, 2011 | 2006 Mercedes-Benz C-Class
Aug 25, 2010 | Audi Cabriolet Cars & Trucks
Mar 29, 2010 | 2004 Honda Element
Aug 24, 2009 | 2003 Honda Element
Apr 26, 2009 | 2003 Honda Element
166 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: