Question about 2000 Chevrolet Blazer

1 Answer

Loud clicking noise from front end of 2000 chevy blazer 4x4

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Master
  • 1,007 Answers

Is the clicking noise most prevalent when turning close to full lock?
If so, then check your front drive shafts. It could be that their joints are heavily worn.

If not, then please describe when the clicking noise is most prevalent.

Posted on Nov 04, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 350 Answers

SOURCE: engine removal out of a 2000 chevy blazer 4x4

hi everything is easy if you know what you are doing and have the right equipment so have you got lifting gear have you got a good selection of tools and will need a little help getting the engine in and out otherwise you will struggle and you need to be inside with plenty of space good luck, yates210456

Posted on Oct 26, 2008

LAYNRAIL
  • 18 Answers

SOURCE: The heat on my 2000 Chevy blazer LT 4x4 isn't coming out hot but

Did you check the level of the coolant? do it while it is running............but make sure it is cooled off.

Posted on Jan 16, 2009

  • 114 Answers

SOURCE: loud hum from front end-99 blazer 4x4

Sounds like the front hub bearing assembly.

Posted on Jan 22, 2009

SOURCE: purge solenoid location

which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol

the locations are described as if you are looking at the engine from the front of the car with hood open.

on the blazer:

it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.

on the silverado:

it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.

hope this helps!

Posted on Feb 17, 2009

  • 1 Answer

SOURCE: torque specs

2005 Chevy 1500 4x4 front hub bearing assembly, what is the torque spec

Posted on Jun 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2000 ford expedition 4x4 the front right side makes a clicking noise while driving. Any ideas


Clicking Noise From Left Front Tire Area - F150online Forums

www.f150online.com/.../47713-clicking-noise-left-front-tire-area.html
Aug 11, 2001 - I have a clicking type noise comming from the left front tire. It does not ... I can really hear it when I'm driving beside a sound wall or the side of a building. ... the sound. (Yeah right!) ... Almost forgot: 1999 Ford F150 XLT Supercab 5.4 4X4. ... My 2000 4X4 had a ting ting noise coming from the left front wheel. Intermitent Grinding Noise on 2004 F150 4x4 - Page 5
Jan 15, 2010
Popping noise in front end.
Oct 26, 2009
Clicking noise at low speeds.
Aug 7, 2009
Annoying clicking sound in rear of truck?!?!
Jun 8, 2009
More results from www.f150online.com

Jan 05, 2016 | Ford Cars & Trucks

1 Answer

I have a 99 blazer 4x4 it is humming in he rear end we had the rear bearings n seals changed new diff cover new fluid and it is still humming what is it??? PLEASE HELP!!!


99 Blazer driving hum,noise - Blazer Forum - Chevy Blazer Forums

blazerforum.com > ... > Steering, Suspension & Drivetrain
Dec 31, 2007 - 99 Blazer 4x4 has constant noise-humming that occurs non-stop and increases and ... Sounds like it is coming from rearend but not 100% sure. 99 LT 4x4 Rear End Whine
Nov 5, 2013
7-5/8 or 8.5" ring gear?
Jan 16, 2012
99 Jimmy 4x4 humming noise
Dec 24, 2009
More results from blazerforum.com

Sep 30, 2015 | Cars & Trucks

1 Answer

I hav a 2000 chevy 4x4 four door when i accelerate the rear end makes a loud banging noise took it to a mecanic they said it was the pumpkin...wnatever that is....please help wat is it and an estimate on...


Pumpkin refers to the rear end and the gears it contains, depending on the damage and what all is involved inside of it damage wise, its hard to give you a cost for the repair

Jun 22, 2011 | 2000 Chevrolet Blazer

1 Answer

2000 Chevy Blazer 4x4...started making a horrible loud noise after my cruise control went out. I have recently replaced my hub and the brake pads and the CV axle. The noise comes and goes and only happens...


does it get louder above 45-60mph? and much quieter at low speeds. It could be wheel bearings, a rear differential or front differential. If its a grinding humming noise its wheel bearings, listenin to see if theyre coming from the front or rear, left or right, or both when your driving to know what wheel bearing are bad. If its a whinning noise, its probably a differential. check and listen to hear if its coming from the front or rear. Also, check for loose plastic around the wheels. Lastly check your tires for uneven or choppy wear. move your hands front to back on the top of the tire. does it feel really choppy and rough, maybe you just need new tires

May 04, 2011 | 2000 Chevrolet Blazer

1 Answer

Vibration NOISE in front end of 2000 Chevy Blazer. Any suggestions??


Check the front wheel bearings .... very common . While driving turn the wheel gently from side to side and see if the noise changes .. this will load and unload the bearings.

Feb 12, 2011 | 2000 Chevrolet Blazer

1 Answer

2000 chevy blazer ls 4x4 poping noise in the frount end rotors are shot the axel is some what shot


ok -- not quite sure what the problem is, yet a viable solution would be to replace it. Try area salvadge yards for your parts to keep the costs down.

Jan 15, 2011 | 2000 Chevrolet Blazer

1 Answer

2000 4 wd blazer loud whinning noise


Sounds like you have a bad bearing hub (likely in front but you need to determine which side) You really can't tell by shaking it, unless its falling apart. Remove front brakes and rotors and turn the bearing by hand, any slight roughness is a problem (you can't exert as much force as the vehicle weight of the vehicle)

Jun 08, 2009 | 2000 Chevrolet Blazer

1 Answer

Loud hum from front end-99 blazer 4x4


Sounds like the front hub bearing assembly.

Jan 22, 2009 | 1999 Chevrolet Blazer

1 Answer

Clicking noise in front end when 4x4 is ingaged.


Have the front hubs and CV joints checked, that is where this kind of noise most commonly comes from.

Dec 16, 2008 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...