Question about 2001 Chevrolet Suburban

Open Question

How to remove power steering pump 2001 suburban

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: Power Steering Pump removal

you havr the whole bracket with pump .next you will need PS pulley removal tool take out 3 bolts same tool needed to replace pulley

Posted on Oct 20, 2008

Ad
  • 1 Answer

SOURCE: 2001 chevy 1500 V6 4.3L power steering

If you have replace the pump with a known good pump, then I would double check you hoses both high and low pressure. I know that sometimes the areas around the clamps can become cracked and cause a leak. Also, might double check that you have a good seal around the threaded fitting to back of the pump.

Posted on Feb 05, 2009

davesmith_37
  • 94 Answers

SOURCE: removing power steering pump

To replace the power steering pump, proceed as follows:

  1. Disconnect the power steering return hose from the remote reservoir or pump. Allow the fluid to drain from this hose into a drain pan. Discard the used fluid.
  2. Loosen the bracket or belt tension adjusting bolt, and the pump mounting bolt.
  3. Loosen the belt tension until the belt can be removed. On some cars, it is necessary to lift the vehicle on a hoist and gain access to the power steering pump from underneath the vehicle.
  4. Remove the hoses from the pump, and cap the pump fittings and hoses.
  5. Remove the belt tension adjusting bolt and the mounting bolt, and remove the pump.
  6. Check the pump mounting bolts and bolt holes for wear. Worn bolts must be replaced. If the bolt mounting holes in the pump are worn, pump replacement is necessary.
  7. Reverse steps 1 through 5 to install the power steering pump. Tighten the belt as described previously, and tighten the pump mounting and bracket bolts to the manufacturer's specifications. If o-rings are used on the pressure hose, replace the o-rings. Be sure the hoses are not contacting the exhaust manifold, catalytic converter, or exhaust pipe during or after pump replacement.
  8. Fill the pump reservoir with the manufacturer's recommended power steering fluid, and bleed air from the power steering system as described earlier.

Posted on Feb 27, 2009

  • 32 Answers

SOURCE: Water Pump removal on 2001 Impala

yes

Posted on Mar 22, 2009

daltonp
  • 361 Answers

SOURCE: Recently removed windshield washer tank from 2001

thats a new one make sure the fluid is up to the mark. Some times turning with out power leaks fluid

Posted on Apr 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the power steering pump from a 2001 Chev Blazer with the 4.3 engine?


4.2L Engine
  1. Remove the air cleaner assembly.
  2. Remove the drive belt.
  3. Install a drain pan under the vehicle.
  4. Disconnect the power steering pressure hose from the power steering pump.
  5. Disconnect the power steering cooler hose from the power steering pump.
  6. Disconnect the wiring harness from the wiring loom on the power steering pump.
  7. Remove the power steering pump mounting bolts.
  8. Remove the power steering pump.
  9. Remove the power steering pump pulley.
  10. Remove the power steering pump pulley using Power Steering Pump Pulley Remover tool no. J 25034-C, or equivalent.

Oct 30, 2010 | 1993 Plymouth Acclaim

2 Answers

Where do you pour the power steering fluid for the 1995 gmc suburban


into the Power Steering pump, the reservoir is at the rear

Aug 31, 2010 | 1995 GMC Suburban

1 Answer

HOW DO I CHANGE THE POWER STEERING HOSE. IT IS WET ALL OVER AND LOOKS TO BE LEAKING BY THE RUBBER HOSE AND SILVER CONNECTION 1999 CHEVY SUBURBAN 5.7


You'll need to disconnect that line from the pump, (some metric wrenches will be needed) and disconnect the line at the steering gear box. It may help removing the A/C compressor and the power steering pump and bracket from the motor to get to the line where it attaches to the pump.

Feb 21, 2010 | 1999 Chevrolet Suburban

2 Answers

Remove a power steering pump out of a 97 chevy suburban


give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your baby SUV wish you the best of luck Michigan Man.

Jan 25, 2010 | 1999 Kia Sportage

1 Answer

Steering gets hard when turning to the left


check if the power steering fluid is within limits and if its the correct fluid. if the fluid is fine, then its the power steering pump at fault. (you give it a little presure and it gives out)

Aug 14, 2009 | 2001 Chevrolet Suburban

1 Answer

Steering gets hard when steering to the left


Hi,i take it has power steering if so theres a fault either with the pump or the steering rack seals,if your car is a none steering rack model then i would go for the power steering pump.
hope this helps you.
George.

Jul 15, 2009 | 2001 Chevrolet Suburban

1 Answer

Cant remove power steering pump.


Check for any hidden mounting bolts. There may be a rear mounting bolt. Make sure you have removed all mounting bolts. Recommend buying a Chilton's manual from Autozone.

May 24, 2009 | 1999 GMC Suburban

1 Answer

I was mudding in my 2001 chevy suburban this week and suddenly lost my power steering. dads pissed and won't help me. need to know where i can find the pump itself


the pump is on front of motor. there is the belt wrapped around it. it is where you pour the power steering fluid into.

Apr 20, 2009 | 2001 Chevrolet Suburban

Not finding what you are looking for?
2001 Chevrolet Suburban Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...