Question about 1995 GMC Sonoma

1 Answer

I have replace a head gaskets and timing chain on my 1995 gmc sonoma 4.3 litter engine ,but now it does not start dont even turn the switch on what is it going tobe?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Check timing and earth strapes

Posted on Nov 03, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1118 Answers

SOURCE: 2000 GMC Sonoma 4.3l V6 timing chain replacement

Sounds to me someone wants to make a couple of bucks. Does the truck still run? The timming chain is going to have play in it, even with only a few miles on it THATS JUST THE NATURE OF THE BEAST, the chanses of the timming chain going out is remote, I've owned a few 4.3's with well over 100.000 mi. and never had to chg. a timming chain, not to say it can't happend just saying its very remote.

Posted on May 15, 2009

  • 99 Answers

SOURCE: 1995 gmc sonoma

check your connections in the fuse box, they may not be making a good clean and tight fit, they could have pushed out the rear of the fuse box

Posted on Nov 30, 2008

  • 217 Answers

SOURCE: 94 GMC sonoma needs head gasket

no real pit falls just drain coolant remove head have head checked at machine shop. Clean engine surface good and rise good with brake clean, make sure head gasket is on correct before head goes on bolt down with proper torque and sequence then finish up then drain oil.

Posted on Jan 17, 2009

  • 14036 Answers

SOURCE: TEMP GAUGE NOT WORKING ON 95 SONOMA 2.2

check the wiring insrument cluster to the temp sensor. check the ground wire.

Posted on Apr 07, 2009

seanpwright
  • 2030 Answers

SOURCE: How to replace timing chain

Here ya go....

b3e8f22.jpg

Posted on Aug 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove oil pan on a 2001 gmc Sonoma pick up truck to replace gasket


1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN ...

? 2:31
https://www.youtube.com/watch?v=1KsRTlnW7Cg
Sep 27, 2011 - Uploaded by JohnSmiths8379858
trying to reomove the oil pan to this truck has been sitting for about 6 ... 1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN REMOVAL "HELP!

Oil Pan Gasket: How to Change Oil Pan Gasket for 2001 ...

www.2carpros.com/questions/2001-gmc-sonoma-oil-pan-gasket
Mar 18, 2011 - How to change oil pan gasket for 2001 sonoma, can i get away with just raising the engine two inches to ... 2001 GMC Sonoma • 4 cylinder 2WD Automatic • 150,000 miles ... You need to remove the engine to get the sump off.

Nov 28, 2015 | GMC Cars & Trucks

1 Answer

'94 Gmc Sonoma 4.3L Starts loosing Power and making weird Rattle Noise when reaching operating temperature. Also water tank looks like there is a bit oil in it. Could it be the cylinder head gasket?


Oil in the coolant is usually an intake manifold gasket problem on these engines. If a head gasket failure the engine will normally overheat and give erratic temp guage readings. Make sure the oil level is full. Is the rattle noise coming from the engine? Some times the exhaust (converter) will fail and the catylist will seperate causing a rattle noise from the exhaust and plug it up giving a no power situation

May 23, 2015 | 1994 GMC Sonoma

1 Answer

What would it cost a mechanic to install motor mounts on a 1995 gmc sonoma 4.3 litre 4*4


Im sure your 95 is no different then my 01 sonoma 4x4 u shouldn't need a cherry picker to do the engine mounts a small block of wood and a floor jack to support the engine from underneath and take a little bit of the load off the mount should work you dont have to lift the engine out to do them its not easy this way but is possible and cost less money working for a gm parts department and a former tech you would be spending and average of 75 to 100 an hour labor wise depending on what shop u take it to and what shop labor rates at like near you I would estimate an easy 2 hours labor but it all goes by book time thats or determined at the shops

Mar 27, 2014 | 1995 GMC Sonoma

1 Answer

Truck won't start


Sounds like you have several problems.
If the engine will not crank, do you have power on the purple wire on the small starter terminal when the key switch is in the start position ?

Apr 14, 2013 | 1995 GMC Sonoma

1 Answer

I have a 1995 GMC Sonoma that will not start when turn ignition switch lights will come on etc but engine will not turn over battery is good etc but nothing happens


Make sure all the ends on your battery cables are clean and tight. I got a tow in because my car would not try to start even tried boosting to no avail. All my lights and radio was working but they said the cable was corroded and would not let the full power work. We replaced the battery cables and worked like new now.

May 16, 2017 | 1995 GMC Sonoma

1 Answer

1995 GMC Sonoma, Wont Start, On Electrical Power after Replacing Head Gaskets


Look at the main power supply battery junction block . Fusible link's . Firewall driver side . These power up the whole vehicle . Do you have a voltmeter ,do you know how to use one to test B+ voltage ? Here is a web site for free wiring diagrams . http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make ,model and engine size . Under system click on electrical distribution ,under subsystem click on power distribution . Click the search button ,then the blue link's . Look at the diagrams ,get out the voltmeter an test for B+ voltage where it's suppose to be.

Sep 05, 2017 | 1995 GMC Sonoma

1 Answer

I have a 1995 GMC sonoma 5 speed 4 cyl.It was running fine until it blew a radiator hose last week,I changed the hose now its over reving when it warms up after driving for a while when I barely touch the...


The v6 engines had a problem with the throttle body gasket leaking air. Could be the same problem on your engine. It wouldn;t happen until the vehicle had been driven for a while, then the gasket would become fuel soaked and would be sucked in at the back corner of the gasket. Replace the throttle body gasket and see if the problem goes away.

Dec 19, 2010 | 1995 GMC Sonoma

5 Answers

2001 GMC Sonoma Engine stopped while driving


sounds like it could be plugged injectors or a timing problem.

Oct 27, 2008 | 2001 GMC Sonoma Extended Cab

1 Answer

1996 gmc sonoma


Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} Long start time and misfires can be caused by retarded engine time. Purchase a timing light and check your engine time against the front pulley and the timing scale located around your timing chain cover. If you have recently had your timing belt or chain replaced you could be a tooth off.
With regard to your ABS light the easiest thing to check or replace is the speed sensor on the wheel. Because this is a magnetic pick-up sensor and due to the location (on the wheel behind the rotor) can be susceptible to corrosion. That is also the most common cause of an illuminated ABS light. Do you have 4 or 2 wheel anti lock? The 4 wheel abs doesn't change what could be wrong, it just means you have more speed sensors to check.

Aug 04, 2008 | 1997 GMC Sonoma

Not finding what you are looking for?
1995 GMC Sonoma Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...