Question about Cars & Trucks

1 Answer

2004 chrysler pacifica, a/c and heater will not turn off while vehicle is running

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Check the heater resistor.

Posted on Jul 23, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 718 Answers

SOURCE: Where is starter located on 2004 chrysler

90e9c96.jpg
Look around the "back" of the engine beside the transmission. The Starter connects to the flywheel to start the engine.
If you are replacing the starter you may want to consider doing this first;
) Have the charging system checked. Many auto parts stores and Sears will do this for free.
) Clean the battery terminal/connectors.
) Check the wiring from the battery to make sure it's good.

If you replace the starter yourself;
) Does your car have an anti-thief alarm ? If so find how to reset it if the battery is disconnected. Some alarms will shut down the car if the battery is disconnected !!
) DISCONNECT THE BATTERY.
) Disconnct the wiring to the starter.
) Remove the bolts holding the starter. Remove the harder one to reach first.
) Pull out the old starter.
) Put it the new starter.
) Bolt the new starter in. Put the easier bolt to reach first.
) Connect the wiring to the new starter.
) Re-connect the battery.
) If necessary reset the thief alarm.
) Take the old starter back for a core charge refund.

Posted on May 15, 2009

  • 323 Answers

SOURCE: 2004 chrysler pacifica

It is for an oil change mainly and any other service your maintenance manual suggests at the mileage interval. It needs to be reset after each oil change to be accurate.

Posted on Jun 05, 2009

shadtremonky
  • 353 Answers

SOURCE: How do you replace the EGR valve on a 2004

check with you dealer, that part may have a manditory extended warranty by law

Posted on Jun 24, 2009

  • 1986 Answers

SOURCE: How do I adjust the headlights to see further down

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

  • 1024 Answers

SOURCE: serpentine belt routing for 2004 chrysler pacifica

here it is

98c85ed.gif

Posted on Apr 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temperature control manual not lighting up when I turn the AC on it only works on cold I can't change it.


the vacuum pipe to the heater core in the engine compartment is either cracked ,holed or even just come off the fitting

Oct 20, 2014 | 2004 Chrysler Pacifica

1 Answer

Why my 2004 chrysler pacifica stop running at stoplight?


code - po442=evap leak medium detected

code-po456=evap leak small detected
look at fuel cap or leaks in rubber hoses

Aug 20, 2014 | Cars & Trucks

1 Answer

Take out heater core


See if this will help,click here to see your heater core removal guide.

Jun 04, 2013 | 2004 Chrysler Pacifica

1 Answer

2004 chrysler pacifica heater controls won't change


Under the dash drivers side there are mode motors that control where the air comes from replace bad one or both the bottom one is recirculate. You could take a volt meter and see which one has power when you push button

Dec 23, 2011 | 2004 Chrysler Pacifica

1 Answer

04 chrysler pacifica dashboard lights stay on & drains my battery


my dash lights stay on after i turn off my van, the fan stays on also the alarm does not work or the keyless entry does not work.

Dec 28, 2009 | 2004 Chrysler Pacifica

1 Answer

2004 Chrysler Pacifica Fluctuating Fuel Gauge Indicator


Hello, the answer to solve this problem is to take it to your nearest chrysler dealer and have them re-flash the updates to the ecu....since 2004, chrysler has had about 4-5 new updates since the date they were manufactured....you need to have the update that followed from your date of man. on your vehicle....They attempted to flash mine to the latest update and didnt work, turns out that they need the re-flash from back when...in order to get the gauage to stop fluctuating.....Hope this helps!!

Sep 06, 2009 | 2004 Chrysler Pacifica

1 Answer

2004 chrysler pacifica water in floor board


the ventilation system of this vehicle has a drain. This may have been plugged from debris that lays in the cowl. I would suggest on your next oil change to have the mechanic clean the drain hose underneath the car.

Sep 03, 2009 | 2004 Chrysler Pacifica

3 Answers

Crankshaft position sensor location on 2004 chrystler pacifica


can u please tell me where on my 2004 chrysler pacifica is the crankshaft sensor located?

May 02, 2009 | Chrysler Pacifica Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...