Question about 1993 Cadillac DeVille

Open Question

Location of dlc connector 93 deville - 1993 Cadillac DeVille

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
airjer995
  • 5332 Answers

SOURCE: Deville 2000 DLC does not work

Typically the data link connector gets its power from the cigar fuse. On your vehicle there is a fuse in the underhood fuse block labeled ALDL (assembly line data link).

Posted on Aug 24, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the DLC located on my 93 cutless ciera I'm trying to program keyless entry?


Under the dash in front of the steering wheel. See typical connector diagram below.
obd2 diagnostic port-qr34xv3iiuqnp04wurr1szx3-2-0.jpg

May 01, 2017 | Cars & Trucks

1 Answer

Can't get a code from dlc fuse's are good


Do you have 12 volts at the pin marked 16 on the DLC connector. If not hook up a battery source to it and bypass the system power.

Aug 28, 2012 | 2000 Cadillac DeVille

1 Answer

Deville 2000 DLC does not work


Typically the data link connector gets its power from the cigar fuse. On your vehicle there is a fuse in the underhood fuse block labeled ALDL (assembly line data link).

Aug 23, 2012 | Cadillac DeVille Cars & Trucks

1 Answer

Handle you close the door (drives door)one end came undone


Maybe these instructions will help you take the door apart: REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Mark the location of the door hinges on the door.
  3. Remove the door trim panel and water deflector.
  4. Label and detach the electrical connections.
  5. Remove the rubber conduit and the wiring harness from the door.
  6. Support the door with a suitable jack, being careful not to damage the paint or trim.
  7. Remove the bolts from the door side of the hinges and remove the door with the aid of an assistant. To install:
  8. Position the door to the hinges with the aid of an assistant. Install the bolts.
  9. Adjust the door for proper door-to-body alignment and lock-to-striker engagement, then tighten the bolts to 38 ft. lbs. (48 Nm).
  10. Attach the wiring harness and rubber conduit to the door.
  11. Attach the electrical connectors.
  12. Install the water deflector and door trim panel.
  13. Connect the negative battery cable. Fig. 1: Front door hinge1990—93 Deville and Fleetwood; others similar 84200001.gif
    Fig. 2: Rear door hinge1990—93 Deville and Fleetwood; others similar 84200002.gif
prev.gif next.gif

Jul 03, 2010 | 1993 Cadillac DeVille

3 Answers

93 cadillac fuse panel location?


There are three fuse blocks in most late model Cadillacs. The engine compartment fuse block, the MaxiFuse relay center and the rear compartment fuse block.

1991-93 Deville, are equipped with a fuse block located in the rear of the engine compartment. There is also a fuse/relay block, located in the glove box behind an access panel, or on the passenger side, under the dash.

Dec 08, 2009 | 1993 Cadillac DeVille

2 Answers

Where do i find the dlc plug


PLEASE DON'T FORGET TO RATE!!!! Data Link Connector OBD II Systems use a standardized test connector called the Data Link Connector (DLC). It is located beneath the instrument panel somewhere between the left end of the instrument panel and 12 inches (300 mm) past the vehicle centerline.
The DLC is located out of the sight of vehicle passengers, but should be easily viewable by a technician from a kneeling position outside the vehicle. The DLC is rectangular in design, capable of accommodating up to 16 terminals and has keying features to allow for easy connection. The DCL and Scan Tool connector have latching features that ensure the Scan Tool connector will remain mated when properly connected. Some common uses of the Scan Tool are:
  • To identify and clear any stored diagnostic trouble codes
  • To read the serial data stream information (e.g., PID data)
  • To perform Enhanced Diagnostic Tests (bi-directional Scan Tool)
96d7723.gif
Data Link Connector Graphic

Nov 01, 2009 | 2002 Oldsmobile Alero

2 Answers

I have a 1988 jeep cherokee, if your are standing in front of the vehicle, on the left fhand side, there is a relay center. well right beside that realy center is two little white plastic boxes with yellow...


Diagnostic Connector To read Diagnostic Trouble Codes (DTC's), the test connector for the electronic engine control system must be used. The test connector is more commonly referred to as the Data Link Connector (DLC). On all Jeep models through 1990, the DLC is a 6-pin and a 15-pin connector located under the hood on the right side of the engine compartment. On 1991–93 models, the DLC is located under the hood on the left side of the engine compartment near the powertrain control module. On 1994–98 vehicles, the DLC is located in the passenger compartment, under the driver side dashboard.

Data Link Connector (DLC) location — Jeep models through 1990

5b4e680.gif
Please don't forget to rate and let me know if this helped you.

Greg

Jul 11, 2009 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Scaner won't power up when pluged into dlc


Fuse #5 10A Data Link Connector (DLC)
located in.

Passenger compartment fuse panel
The fuse panel is located on the left
hand side of the instrument panel
facing the driver’s side door. Pull the
panel cover outward to access the
fuses

Jun 02, 2009 | 1999 Mazda Pickup

1 Answer

I need to know where diagnostic connection is on a 1994 ford lincoln


With the advent of OBD-II, the Federal Government has mandated the location of the DLC (Data Link Connector) .The Data Link Connector is located in the passenger compartment. It is attached to the instrument panel and accessible from the driver's seat. The DLC is rectangular in design and capable of allowing access to 16 terminals. The connector has keying features that allow easy connection. The test equipment and the DLC have a latching feature to ensure a good mated connection. The Scan tool uses the DLC as a pathway to communicate with the on board computer system. If the DLC is not located under the dash, the vehicle is using OBD-I. This is a slightly different management system in its operation and diagnosis. Look for DLC under the hood near the left front headlight on the Town Car and Mark VII, near the right side firewall on the Continental.

May 07, 2009 | Ford Lincoln Continental Cars & Trucks

1 Answer

Need to replace turn signal switch 93 cadillac deville


First do you have a sterring wheel puller. Can't remove the steering wheel without one. Quite an involved job including snaking the electrical connector end through the steering column. I wouldn't recommend it to the novice

Mar 28, 2009 | 1993 Cadillac DeVille

Not finding what you are looking for?
1993 Cadillac DeVille Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...