Question about Cars & Trucks
Yoi need a code scanner to erase code after replacing faulty sensor.if already done could have faulty pcm or damaged or short in sensor wires.
Posted on Nov 03, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This code is set the camshaft position sensor, it is part of the ignition system, this can cause your loss of power.
Posted on Jul 28, 2008
YOU will need the car on a hoist, doing it on the ground is almost impossiable, disconnect the filler neck at top, remove the straps, lower tank slow and disconnect wiring and fuel hoses, you need a special tool to remove the gas line retainer clips.
Posted on Jul 28, 2008
no need to replace the throttle body , and i think that you make a test before to buy any piece . disconnect the negative battery terminal few minutes, then connnect and start engine again, drive few minutes by observing the engine, if light comes again, replace only map sensor ,good luckl
Posted on Apr 24, 2009
Tips for a great answer:
Feb 23, 2016 | 1994 Ford Ranger Supercab
Dec 03, 2014 | 2006 Ford Freestyle
Nov 14, 2014 | Cars & Trucks
Jun 26, 2014 | 2000 Mazda Protege
Aug 13, 2013 | Mazda Cars & Trucks
Trouble Code: P0122
Are you sure on p1121 or was it po121 because there is no p1121?
Throttle Position Sensor 'A' Circuit Low Input
TP sensor signal circuit is shorted to ground TP sensor VREF circuit is open or shorted to ground
Trouble Code: P0700
TCU Request For MIL -ON-
poor connection TCM
Trouble Code: P0121
Throttle Position Sensor Performance
MAF sensor or TP sensor ground circuit has high resistance MAF sensor has drifted out of calibration TP sensor has drifted out of calibration TP sensor is damaged or has failed PCM/ECMTP sensor is damaged or has failed PCM has failed
Jun 08, 2012 | 2003 Kia Sorento
Sep 27, 2010 | Chevrolet Chevy Cars & Trucks
Dec 04, 2008 | Jeep Wrangler Cars & Trucks
164 people viewed this question
Usually answered in minutes!